红土镍矿冶金技术研究进展

如今世界经济迅猛发展,金属镍的需求量也在加速增长。人们主要从硫化镍矿和红土镍矿中提炼金属镍。然而硫化镍矿资源因大规模开发而不断减少,红土镍矿未来将成为镍的主要来源。因此研究红土镍矿的高效开发利用,是当今围绕镍资源研究的热点,对实际生产具有重要的现实意义。本文简要介绍了镍的应用、开发红土镍矿的意义、红土镍矿的矿物学特性、红土镍矿世界范围内的储量和分布,并且列举并分析了红土镍矿的各种冶炼工艺及其优点与不足,同时综述了有关红土镍矿研究的新方法,为红土镍矿高附加值综合利用研究提出思路。     

Microstructural and Tribological Behavior of Pulse Electroplated Nickel Barrier on Copper Conductors

The microstructural, mechanical, and tribological behaviors of electroplated Ni on Cu conducting substrates have been investigated in this study. The microstructural studies were performed by X-ray diffraction (XRD) analysis and scanning electron microscopy (SEM). The results showed that initially (111) with (220), (200) Ni texture components were predominant in the coating, and increasing the current density from 0.1 to 0.5 A/cm² led to the development of a strong (111) texture. The presence of ultrafine grains coupled with a (111) Ni texture improved the coating microhardness and wear properties significantly. It was shown that with an increase in current density, wear resistance of the coatings improved significantly and the electrical resistivity increased due to the highly populated grain boundaries.     

汽车锁零部件碱性锌镍合金电镀工艺

介绍了汽车锁零部件碱性挂镀锌镍合金电镀生产线的开发过程,包括前期市场调研、中期小槽试验、后期成本核算、电镀工艺流程确定、废水处理工艺制定以及阳极膜应用可行性分析。     

新型镍基镁渣催化重整松木热解挥发分焦油析出特性研究

采用过量浸渍法制备了镍基镁渣催化剂，并在小型气流床气化炉上开展了松木热解挥发分的催化重整研究。评估了煅烧/催化温度、镍含量和水碳比对焦油组分的影响，同时在不同煅烧/催化温度下与Ni/γ-Al₂O₃催化剂进行了裂解焦油性能的对比。采用比表面积测试（BET）、X射线衍射（XRD）、扫描电镜（SEM）和透射电镜（TEM）对催化剂进行了表征。结果表明，当镍含量为3%，煅烧/催化温度为800℃，水碳比为0.5时，镍基镁渣催化剂表现出最优异的催化裂解焦油能力：大幅度降低了重质多环芳烃的相对含量，并且焦油转化率达到95.69%，同时焦油露点温度降至40.2℃。XRD结果表明，Ni、Fe、Ca、Mg相互作用可以形成多种活性中心，进而协同提高催化剂活性。     

镍基高温合金液相扩散焊接头组织及性能

镍基高温合金GH4413在高温下具有较为优异的高温持久强度和抗蠕变性能，在航空发动机和各种工业燃气轮机中得到广泛应用。以BNi 2作为填充合金材料使用液相扩散焊对GH4413合金进行了连接，研究了在焊接温度分别为1 030和1 080 ℃、保温时间分别为30和60 min等不同焊接参数下GH4413镍基高温合金的接头微观组织、成分分布和显微硬度。扫描电镜(SEM)以及能谱分析结果表明，当焊接温度为1 080 ℃、保温时间为60 min 时，钎缝组织中形成了性能良好的固溶体，且随着焊接温度的升高和保温时间的延长，钎缝的宽度增加，钎料元素向母材中的扩散深度逐渐增加，在母材近缝区形成了金属间化合物。     

分光光度法和光度滴定法联合测定湿法炼锌流程中钴渣浸出液中锌钴镍

湿法炼锌流程中钴渣浸出液中含有高浓度的Fe²⁺和Mn²⁺,用分光光度法测定Co²⁺和Ni²⁺时,Fe²⁺-EDTA会严重干扰Co²⁺和Ni²⁺的测定;在用光度滴定法测定Zn²⁺和Co²⁺合量时,Ni²⁺对二甲酚橙指示剂具有封闭作用,Mn²⁺亦与EDTA螯合,导致滴定结果偏高。为消除Fe²⁺和Mn²⁺对Zn²⁺、Co²⁺和Ni²⁺测定的干扰,实验进行氧化分离Fe²⁺和Mn²⁺预处理,在NaAc/Hac缓冲体系下,以EDTA作显色剂用分光光度法测定Co²⁺、Ni²⁺。在波长466nm处,Co²⁺的线性范围为50~500mg/L时与吸光度呈线性,相关系数R²为0.9992;在384nm处,Ni²⁺的线性范围为50~500mg/L时与吸光度呈线性,相关系数R²为0.9998。根据分光光度法测出Ni²⁺物质的量,加入1.1倍的丁二酮肟以除去Ni²⁺,用二甲酚橙为指示剂,EDTA鳌合-光度滴定法测定Zn²⁺、Co²⁺合量,扣减Co²⁺含量得出Zn²⁺含量。选取4个锌湿法炼锌流程中钴渣浸出液实际样品,按照实验方法中的分光光度法测定Co²⁺和Ni²⁺,光度滴定法测定Zn²⁺、Co²⁺合量,Zn²⁺、Co²⁺和Ni²⁺测定结果的相对标准偏差(RSD,n=6)均不大于0.70%,加标回收率分别为99.59%~100.41%、99.69%~100.64%、99.92%~100.08%。     

Controlled galvanic decoration boosting catalysis: Enhanced glycerol electro-oxidation at Cu/Ni modified macroporous films

We report on glycerol electro-oxidation in alkaline medium at macroporous Ni electrodes decorated with Cu particles. Macroporous Ni film is electrodeposited, using hydrogen bubbles as dynamic templates, atop of a Cu substrate. This film shows good electrocatalytic activity towards glycerol oxidation reaction (GOR). The Ni film is further decorated with Cu via spontaneous deposition from CuSO₄ solution. This is done to enhance the catalytic activity of the film towards GOR. The morphology of the Cu-decorated Ni film is controlled using various additives such as KCl and (NH₄)₂SO₄ which are added to the Cu deposition bath. The as-prepared Cu-decorated Ni films are characterized by electrochemical measurements, scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), X-ray diffraction (XRD), and X-ray photoelectron spectroscopy (XPS). It is found that these additives have tremendous effects on the morphology and the electrocatalytic activity of the decorating Cu particles.The decorated Ni foam showed superior electrocatalytic activity towards the GOR, as confirmed by the negative shift in the onset oxidation potential (ca. 100 mV) together with an increase in oxidation current that is up to 1.5-fold during the cyclic voltammetry (CV) measurements, compared to the undecorated Ni foam.     

加压酸浸法从烟化炉冰铜中浸出铜和镍的试验研究

烟化炉冰铜主要是采用烟化炉处理低品位铜、锡、镍、锌等物料时产生的中间产物，主要含铜、镍、铁、硫等元素，从中浸出铜和镍具有重要价值。采用加压酸浸法从烟化炉冰铜中浸出铜和镍，试验研究了时间、温度、氧分压、液固比、粒度等因素对铜、镍、铁浸出率的影响。试验结果表明：烟化炉冰铜粒度球磨至小于75μm、温度433K、时间3h、氧分压为0.6MPa、液固比4/1mL/g、木质素磺酸钠用量为2‰的优化条件下，铜、镍、铁浸出率分别平均为98.18%、98.42%和26.46%。     

Self-supported Ni2P nanotubes coated with FeP nanoparticles electrocatalyst (FeP@Ni2P/NF) for oxygen evolution reaction

Bimetallic phosphides have been widely investigated as electrocatalysts for oxygen evolution reaction (OER) due to their efficient activity and environmental friendliness. While the reasonable design and controllable synthesis of bimetallic phosphide with typical nanostructure is still a great challenge. Hence, we put forward a novel and straightforward way for constructing FeP nanoparticles coated Ni₂P ultrathin nanotube arrays on the surface of Ni foil (FeP@Ni₂P/NF), which is synthesized through two steps of electrodeposition and subsequent in-situ phosphorization process. The obtained FeP@Ni₂P/NF shows excellent electrochemical activity for OER, and it only needs potential of 1.52 V vs. RHE to reach the current density of 50 mA cm⁻² in an alkaline media. The excellent electrocatalytic activity of FeP@Ni₂P/NF mainly benefits from: (i) the synergistic effect between FeP and Ni₂P promoting electron transfer; (ii) the formation of the unique 3D ultrathin nanotube arrays increasing the quantity of active sites and avoiding the agglomeration of catalysts during testing. In addition, the influence of reaction condition on the electrochemical activity for OER has also been investigated through altering the phosphorization temperature of precursor.