PHOSPHORUS AND PHOSPHATE LEVELS IN THE ALEURONE CELLS OF CEREAL GRAINS

The aleurone cells of barley, wheat, rice, rye, oats and triticale contained, comparatively, higher percentages of phosphorus than the aleurone cells of sorghum, maize or millet. The aleurone tissues of barley, wheat and rice had more phosphate than corresponding tissues of sorghum and maize. Phosphate was not detected in the aleurone tissue of maize but was found in trace amounts in the aleurone tissue of sorghum.     

Mycological and physical parameters for selecting suitable packaging material for pre- and post-irradiation storage of cereal grains in Ghana

Owing to the rough warehouse handling of storage sacks in tropical areas in Africa, a suitable storage sack should not support de novo growth of fungal spores because this would reduce the tensile strength of the packaging material and act as a springboard for infecting grain contents. This paper reports the effect of activity of saprophytic fungi on the tensile strength of jute and woven polypropylene sacks. New woven polypropylene sacks carried lower levels of fungal spores (1.3×10¹ cfu/72 cm²) than jute sacks (3.0×10³ cfu/72 cm²). The natural mould penetration and growth was examined on sections (4×5 cm) of both jute and woven polypropylene after previous incubation at relative humidities of 55, 60, 65, 70, 75, 80, 90 and 95% for 10 weeks by placing them on Sabouraud's Agar. There was a significant difference (P = 0.05 level of significance) between the higher penetration of mould growth on jute sacks and that obtained on woven polypropylene sacks. Saprophytic fungi (Aspergillus candidus, A. flavus, A. fumigatus, A. niger, A. japonicus, A. parasiticus, A. ustus, Fusarium oxysporium, F. moniliforme, Penicillium verucosum var. cyclopium, Rhizopus oryzae and Trichoderma viride) isolated from jute sacks reduced tensile strength, measured by an Instron Model 1026, by 50–75% after 10 weeks at 90% R.H. Same fungal species on woven polypropylene sacks did not alter the tensile strength. Woven polypropylene sacks did not absorb moisture whilst the moisture content of jute sacks increased by 5.3–6.0% in 10 weeks at 90% R.H. with concomitant increase in mould and yeast counts by 1–2 log cycles. Evidence is presented to show that there was a positive correlation between the final mycoflora on jute sacks and loss in tensile strength. No correlation, however, was found between the total aerobic bacteria on jute sacks and the concomitant reduction in tensile strength. Fungi therefore play a major role in the reduction of tensile strength of jute sacks. Sterilization by gamma irradiation (8.0 kGy) of jute and woven polypropylene sacks did not affect their intrinsic tensile strength. Woven polypropylene sacks therefore have many microbiological and physical advantages over the traditional jute sacks to merit their use for grain storage in tropical areas like Ghana.     

Effect of Annealing on the Surface Microstructure of Y-Ba-Cu-O Superconducting Ceramics

Precusors to the YBa₂Cu₃O_7-δ material were prepared by both the oxalate precipitation method and conventional ceramic processing. Second-phase grains were observed to develop on the exposed fracture surface during annealing at 500° to 600°C in an ambient atmosphere. The second-phase grains were identified to be BaCO₃ using EDX and XRD. The liquid phase, which was formed because of local chemical inhomogeneity in the Y-Ba-Cu-O system, contributed to the formation of second-phase grains as a source of Ba.     

杂散电流对阴极保护效果影响的模拟实验

本文通过模拟地下管道阴极保护的现场，测定了地下的杂散电流及其对阴极保护效果的影响，并对相关问题进行了分析。     

六铝酸钙材料的合成及其显微结构研究

分别采用轻质碳酸钙和活性氧化铝 ,或纯铝酸钙水泥和活性氧化铝为初始原料 ,反应烧结合成了六铝酸钙 (CA6)材料 ,研究了原料和成型压力对合成材料的烧结性能和显微结构的影响 ,同时借助于XRD、TG -DSC、SEM和EDAX等测试手段对其反应过程、物相变化和显微结构进行了分析和观察。研究结果表明 :(1) 130 0℃时 ,合成材料的主晶相为刚玉相和CA2 ,并开始有CA6形成 ;温度升至14 0 0℃ ,CA6大量生成 ;15 0 0℃时反应完成 ,产物全部为CA6相。 130 0～ 15 0 0℃时 ,上述反应表现为体积膨胀过程 ,试样的体积密度和径向线收缩率随温度的变化不大 ;而高于 15 0 0℃时 ,试样明显趋向烧结 ,体积密度升高 ,线收缩率加大。采用纯铝酸钙水泥和活性氧化铝合成的试样的体积密度均高于采用轻质CaCO3 和活性氧化铝的 ,尤其在烧成温度高于 15 0 0℃时。坯体的成型压力对这两种合成试样的烧结性能均没有显著影响。 (2 )合成六铝酸钙材料的晶粒形貌与合成工艺有关 ,制备片状晶粒的六铝酸钙材料需满足两个条件 :一是晶核有足够的发育空间 ,二是从晶核生长形成片状结构需足够的物质扩散。采用纯铝酸钙水泥和活性氧化铝为原料的试样 ,其CA6晶核很容易发育成片状晶形 ,且随着坯体成型压力的增加 ,片状CA6有向等轴状发展的趋势 ;采用     

基于环状电极的电容式润滑油磨粒检测系统设计

摩擦副非正常磨损时将产生直径为几十微米的大金属磨粒。采用阻抗类方法检测磨粒时,要求传感器具有较高的灵敏度。为此,设计了差分结构的环状极板电容式传感器。应用电容/数字转换芯片AD7746将传感器的输出直接转换为数字信号,省去了前端复杂的信号调理电路,简化了设计,并且有效地降低了寄生电容和杂散电容的影响。实验表明:系统分辨率可以达到0.125 fF,极大提高了系统灵敏度。     

Migration of Intergranular Liquid Films and Formation of Core-Shell Grains in Sintered TiC–Ni Bonded to WC–Ni

When TiC–20 wt% Ni powder mixtures are sintered at 1400°C, relatively large TiC grains possibly containing some Ni form with near-equilibrium shapes. When these specimens are heat-treated again at 1400°C in contact with sintered WC–20 wt% Ni pieces, the liquid films between the TiC grains in the contact region migrate against their increasing curvatures, forming (Ti,W)C solid solution behind them. These migrating liquid films reverse their directions on further heat-treatment. As in other alloys, this liquid film migration must be driven by the coherency strain energy produced by W diffusion at the surface of the dissolving TiC grains. Shells of (Ti,W)C solid solution also form around the cores of TiC grains near the contact region, and this process is probably driven by both coherency strain energy and free energy of mixing. At some contact regions, (Ti,W)C precipitates nucleate and grow, probably driven mainly by the free energy of mixing. In powder mixtures, the formation of core-shell grains is expected to be driven by the coherency strain energy, the free energy of mixing, and the capillary effect.     

Study on the floatation mechanism and floatation performance for the floatation cyclone of natural inlet air

A novel structure floatation cyclone of natural inlet air has been designed, and its structural characteristics and floatation principle have been analyzed. The velocity and pressure distributions within the flow field of the floatation cyclone have been studied by Navier-Stokes equations. Based on the flow characteristics of the mixture of fine coal and water, reasonable boundary conditions are decided and the equations are modified, so that the final equations can describe the real flow state of the flow field of the floatation cyclone. The boundary surface position between float coal and tailings is determined and there is an air cylinder in the central region of the floatation cyclone. The research reveals the floatation mechanism of the floatation cyclone. The floatation results can be greatly improved by regulating the structural dimensions of cyclone. The experimental results show that the floatation cyclone is very effective for the floatation of fine coal grains.     

卡塞格林式星敏感器杂散光分析

卡塞格林系统是新型星敏感器的光学系统,具有口径大、体积小的优点,但外界杂散光对卡塞格林系统的影响很大。介绍了一种焦距为425mm,口径为102mm的卡塞格林系统,考虑轴外渐晕的影响,给出星敏感器主遮光罩以及主、次遮光罩的设计方法。这种设计方法相比于其他方法更加便捷和精准。并用Tracepro对系统进行杂散光分析。计算得到点源垂直照度透射比（Point Source Transmittance,PST）曲线。分析结果表明,当杂散光入射角大于临界角30°时,PST值小于10-8量级,满足系统使用要求。证明设计方法是可行的。     

Novel predictive model for metallic structure corrosion status in presence of stray current in DC mass transit systems简

The novel method to analyze metallic structure corrosion status was proposed in the presence of stray current in DC mass transit systems. Firstly, the characteristic parameter and the influence parameters for the corrosion status were determined. Secondly, an experimental system was established for simulating the corrosion process within the stray current interference. Then, a predictive model for the corrosion status was built, using a support vector machine （SVM） method and experimental data. The data were divided into two sets, including training set and testing set. The training set was used to generate the SVM model and the testing set was used to evaluate the predictive performance of the SVM model. The results show that the relationship between the characteristic parameter and the influence parameters is nonlinear and the SVM model is suitable for predicting the corrosion status.