350MW机组锅炉SCR脱硝系统优化

准东煤田是我国目前最大的整装煤田,但准东煤在锅炉燃烧过程中易发生结焦问题,一般掺烧高岭土缓解结焦。某燃用准东煤350 MW机组,锅炉燃煤掺烧高岭土后烟气携带灰尘颗粒及灰尘量增大,出现SCR脱硝系统烟道积灰严重和喷氨量明显偏大问题,同时在空气预热器形成硫酸氢氨堵塞,使机组不能长周期稳定运行。通过与国内同类型多台机组锅炉对比后发现,脱硝系统均存在易产生积灰的脱硝转向室、催化剂上方及空气预热器入口斜坡积灰状况等情况。针对存在的问题,通过建立改造前、后的模型计算分析,进行了导流板布置的优化设计、CFD流场分布、优化SCR系统导流板设计、声波与蒸汽吹灰器结合吹灰和氨注射栅格优化升级等工作,应用德图480风速仪实测风速试验,发现脱硝烟道原导流板设计不合理及施工安装偏差;原导流板水平段跨距大,支撑不足,造成导流板压塌变形,影响烟气流场分布;锅炉所烧煤质为高钠煤,为防止锅炉结焦掺烧高岭土后,增加了烟气飞灰颗粒及灰尘量,飞灰具有很大黏性,易沉积在烟道导流板及烟道壁面上。因此,提出对脱硝内部各处导流板进行优化改造,对脱硝系统烟道易产生积灰的部位增加声波吹灰器,对喷氨格栅喷嘴数量及氨空混合器升级,同时开展锅炉SCR脱硝喷氨热态优化调整试验工作。通过开展相关工作,SCR烟气系统的烟气流场相对标准偏差优化5%,相同负荷下液氨消耗量降低45%,彻底解决脱硝系统积灰和空气预热器堵塞问题,实现机组满负荷达标稳定运行。锅炉长期运行半年后停炉检查,发现前期脱硝系统烟道高达1 m的积灰部位彻底解决,催化剂表面干净无杂物,解决了脱硝系统积灰问题,同时配合提高空气预热器冷端综合温度的措施,彻底解决锅炉空气预热器堵塞问题。同时,经济效益显著,每年可以分别节约液氨费用70万元,节约风机电耗费用100万元,节约检修清理积灰及检修费用80万元,节约空气预热器冲洗治理费用20万元,综合节约费用270万元/a,达到预期效果实现机组长周期安全经济稳定运行。     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

Insight into the chemical reaction of CH2OH with NO: Formation of N-hydroxy formamide as an isocyanic acid precursor

This study has explored the potential energy surface on the chemical reaction of CH₂OH with NO by using ab initio calculation. We have found the new reaction pathway producing N-hydroxy formamide, which can further decompose to generate isocyanic acid as a reducing agent of hydrocarbons selective catalytic reduction.     

SCR deactivation in a full-scale cofired utility boiler

The Energy and Environmental Research Center installed a portable slipstream selective catalytic reduction (SCR) reactor in the convective pass of a utility boiler cofiring wood waste and Powder River Basin (PRB) coal. Catalyst sections were removed after 43, 128, and 171 days of operation. SCR catalytic activity was determined for each section, and a sample of one section was examined under a scanning electron microscope to look for signs of catalyst blinding and/or poisoning. The catalyst deactivated at an apparently inverse rate with an initial deactivation rate of 18% every 1000 h. The major mode of deactivation appeared to be pore blocking by combined alkali and calcium sulfate deposition and growth.     

电动钻机的工作理论基础(一)--系列专题之七

近年来，电驱动已成为石油钻机的主要驱动形式，是钻机自动化、智能化的坚实平台。文章就电动钻机的部分工作理论作初步剖析，包括钻机工作机组对电驱动的要求，可控硅直流电驱动和交流变频电驱动的工作原理，直流电动机和交流变频电动机等的特性分析，电动机的四象限运行和能耗制动原理等。     

Single and combined deactivating effect of alkali metals and HCl on commercial SCR catalysts

Two commercial SCR catalysts, with a nominal W content of about 9 wt.% and a V nominal content of 0.55 and 1.8 wt.%, respectively, were contacted with different amounts of Na and K and with HCl vapours in order to simulate poisoning by species more specifically contained in exhaust gases from MSW combustion. Catalysts were characterised using XRD analysis, SEM/EDX analysis, BET and pore size distribution measurements, NH₃ TPD, TG analysis. Poisoning agents do not cause loss of surface area nor pore occlusion. A significant loss of surface acidity was observed upon alkali metals poisoning whereas a decreasing of vanadium content was observed for the more concentrated catalysts upon HCl poisoning. Catalysts deactivation is proportional to the number of acid sites neutralised by alkali metals adsorbing ammonia in the temperature range typical of SCR process. HCl promotes the formation of new acid sites showing a lower activity compared to the original one.     

一种小电流下的引弧及稳弧方法

介绍一种小电流直流TIG焊中的引弧及稳弧方法，并对实现此功能的控制电路进行了详细的分析。简单介绍了此种小型焊机的特点及用途。     

晶闸管CO2焊机的新型同步及触发电路

所论述的同步及触发电路，基于主电路结构特点设计，克服了传统同步及触发电路的不足，引用新的器件设计电路。该电路结构简单、稳定、精度高，通过具体的试验对电路设计进行的验证。说明该电路在工程实际应用中是非常实用的。     

燃煤电厂SCR脱硝氨逃逸迁移规律试验研究

研究了某燃煤电厂350 MW机组SCR系统氨逃逸在下游设备的迁移规律。现场试验发现,SCR系统下游设备中空气预热器、低低温省煤器、电除尘器氨逃逸捕获率分别为总氨逃逸量的23%~26%、9%~17%和56%~62%,进入脱硫系统的氨逃逸不足总氨逃逸的3%;提高低低温省煤器出口烟温会导致氨捕获率降低,但下游电除尘器飞灰氨含量增多,表明其对氨的捕获性能提高,最终总的捕获比例基本保持不变。通过现场试验及数据分析,建立了电除尘器所捕捉飞灰中氨含量与SCR出口氨逃逸的对应关系,当机组燃煤煤质大幅变化或对设备进行大幅改造等情况时,需要根据实际情况重新修正对应关系。     

NO reduction by CH4 over Pd/Co-sulfated zirconia catalysts

A series of sulfated zirconia supported Pd/Co catalysts was synthesized by the sol–gel method and examined for NO_x reduction by methane. The NO conversion increased up to a Co/S ratio of 0.43, and then decreased at a higher Co loading (Co/S = 0.95). Sulfate content was also essential for obtaining high selectivity to molecular nitrogen. A catalyst loaded with 0.06 wt.% Pd, 2.1 wt.% Co and 2.1 wt.% S (Pd/Co-SZ-2) exhibited remarkable performance under lean conditions and displayed stability in a long-term durability test using a synthetic reaction mixture containing 10% water vapor. This catalyst exhibited the highest sulfur retention most probably as cobalt sulfide. Besides, the catalytic oxidation of NO to NO_y groups was confirmed by FT-IR, in agreement with the general mechanism for the SCR of NO by hydrocarbons. In the absence of oxygen in the feed stream, the catalyst was highly active for NO reduction with methane. IR stretching bands assigned to N₂O and adsorbed nitro groups were identified upon adsorbing NO on Pd/Co-SZ-2. This indicates that under rich conditions disproportionation of NO to N₂O and NO₂ occurs and confirms that the formation of NO₂ species is an essential step for NO reduction by CH₄.