Dynamic simulation of hydrogen-based off-grid zero energy buildings with hydrogen storage considering Fanger model thermal comfort

In this study, some locations with different climates, off-grid zero energy buildings with hydrogen energy storage systems are designed, and transient analysis is conducted. These considered buildings supply their electricity consumption without using the electrical grid and PV panels or wind turbines. Also, they supply thermal comfort to occupants by using a vapor compression chiller and humidifier. Domestic hot water of occupants is supplied using solar collectors. For analyzing building's performance and objectives achievement, TRNSYS software is used. Also, for evaluating occupant thermal comfort, the Fanger model is used. The considered building is a one-story building with a 150 m² area. Four occupants are considered. Both of them are seated at rest, and another is seated with light working such as typing. Using the Fanger model equation and MATLAB software, the thermal comfort of occupants is determined. For domestic hot water consumption, verified profiles that vary during 24 h of the day are considered. Achieved results show that for humid and cold cities, PV panels with an area of 73 and 76 m² can be supplied the required electricity of considered building with four occupants and battery state of charge is higher than 50% and 10%, respectively. Moreover, with a suitable air conditioner system, the predicted percentage of dissatisfied (PPD) can be lower than 12% and 8% for humid and cold cities. Therefore, the building can be converted to a zero-energy building using its rooftop area.     

Influence of mesoporous phosphotungstic acid on the physicochemical properties and performance of sulfonated poly ether ether ketone in proton exchange membrane fuel cell

This study demonstrates the successful development of hybrid mesoporous siliceous phosphotungstic acid (mPTA-Si) and sulfonated poly ether ether ketone (SPEEK) as a proton exchange membrane with a high performance in hydrogen proton exchange membrane fuel cells (PEMFC). SPEEK acts as a polymeric membrane matrix and mPTA-Si acts as the mechanical reinforcer and proton conducting enhancer. Interestingly, incorporating mPTA-Si did not affect the morphological aspect of SPEEK as dense membrane upon loading the amount of mPTA-Si up to 2.5 wt%. The water uptake reduced to 14% from 21.5% when mPTA-Si content increases from 0.5 to 2.5 wt% respectively. Meanwhile, the proton conductivity increased to 0.01 Scm^?1 with 1.0 wt% mPTA-Si and maximum power density of 180.87 mWcm^?2 which is 200% improvement as compared to pristine SPEEK membrane. The systematic study of hybrid SP-mPTA-Si membrane proved a substantial enhancement in the performance together with further improvement on physicochemical properties of parent SPEEK membrane desirable for the PEMFC application.     

低功耗高性能的全MOS电压基准源设计

设计了一种基于亚阈值技术的全MOS电压基准源,采用共源共栅结构来增大PSRR,使用MOS管代替电阻,优化温度特性,使电路中大部分MOS管工作于亚阈值区。基于0.18μm CMOS工艺进行设计、版图绘制、和前、后仿真,在后仿真中得出相关参数值。对各参数做出详细分析,包括:一定温度范围内的温度系数;常温下基准输出电压;不同电源电压条件下的线性调整率、基准源静态电流及功耗,并对不同频率下的电源电压抑制比进行了对比。实验结果表明达到了低功耗高性能的设计目标。     

生产工艺多方案并行与快速转换方法研究

生产系统复杂多变,在生产管理过程中存在多变性和不均衡性。对此,实际生产中需要实现生产工艺多方案并行与快速转换。分析了生产过程变化因素,介绍了主工艺+子工艺这一生产工艺多方案并行与快速转换方法,并通过实例验证了这一方法的有效性。     

Common Mode Voltage Reduction Using 3D-SVPWM for 3-level CI-NPC Inverter with Hybrid Energy System

This paper elucidates Common Mode Voltage (CMV) reduction in transformerless 3-phase 3-level Coupled Inductor Neutral Point (CI-NPC) Clamped Inverter with Hybrid Energy System. The three dimensional Space Vector Pulse Width Modulation (3D-SVPWM) with Nearest State Vector (NSV) is implemented to reduce the CMV by proper selection of medium, large and small vectors in 3D cubic space region. This NSV scheme in addition to CMV reduction, reduces the capacitor voltage balancing issues and minimizes switching losses. The proposed control provides full utilization of dc link voltage with reduced harmonics. This 3-level CI-NPC inverter is energized by hybrid energy source which includes photovoltaic system and wind energy system. The results obtained for the proposed scheme through simulation and experimental setup is compared with the conventional 2D-SVPWM and 3D-SVPWM scheme. From the compared results it is evident that the proposed scheme reduces CMV to a larger extent than 2D and 3D-SVPWM control. The simulation and experimental results are verified using matlab-simulink and FPGA-Spartan-6 controller respectively.     

In-situ methane enrichment of biogas from anaerobic digestion of palm oil mill effluent by addition of zero valent iron (ZVI)

Palm oil mill effluent (POME) is a wastewater effluent that is generated from palm oil milling. Treatment of POME, especially using biological treatment methods, is a challenge as it contains high amounts of organic and sulfur compounds, and it is highly acidic. In this research, the effects of zero-valent iron (ZVI) on the enhancement of methane production from POME via anaerobic digestion were investigated. Furthermore, to identify the reactor operation modes that were suitable for the addition of ZVI, anaerobic digestion of POME was tested in three reaction configurations: batch reactor, fed-batch reactor, and continuous stirred-tank reactor (CSTR). In the batch mode, where acidic POME was fed with 16 g/L of ZVI dose just once, methane production increased by 74%. However, as the oxidation of ZVI under anaerobic conditions led to the production of hydroxyl ions, the pH of the medium continuously increased from approximately 7 to 9, which is not suitable for methanogenesis. In the fed-batch mode that involved intermittent feeding of acidic POME, the pH of the culture media was maintained at 6.8. This is because the extra hydroxyl ions generated from the oxidation reaction of ZVI tended to neutralize the acids in the feeding substrate. In addition, ZVI promoted the production of methane from POME and increased the average methane content in biogas from 62% to 76%. In the CSTR mode, which involved continuous feeding of acidic POME, ZVI increased methane production by 86% (from 1.79 to 3.32 L/day), methane content in biogas from 60 to 75%, and total chemical oxygen demand (tCOD) removal efficiency from 78 to 89 to 88–95%. Thus, the addition of ZVI can be a potential strategy for in-situ methane enrichment of biogas by anaerobic digestion of POME. This is because ZVI acts as a buffer for acid generation and provides extra electrons, ferrous ions, and ferric ions, which promote key microbial activities in the anaerobic digestion process.     

A new sustainable hydrogen clean energy paradigm

We analyze the feasibility of a novel, hydrogen fuel cell electric generator to provide power with zero noise and emissions for myriad ground based applications. The hydrogen fuel cell electric generator utilizes a novel, scalable apparatus that safely generates hydrogen (H₂) on demand according to a novel method, using a controlled chemical reaction between water (H₂O) and sodium (Na) metal that yields hydrogen gas of sufficient purity for direct use in fuel cells without risk of contaminating sensitive catalysts. The sodium hydroxide (NaOH) byproduct of the hydrogen producing reaction, is collected within the apparatus for later reprocessing by electrolysis, to recover the Na reactant. The detailed analysis shows that the novel, hydrogen fuel cell electric generator will be capable of meeting the clean power requirements for residential and commercial buildings including single family homes and light commercial establishments under a wide range of geographic and climatic conditions.     

Direct model-based predictive control scheme without cost function for voltage source inverters with reduced common-mode voltage

This paper presents a direct model-based predictive control scheme for voltage source inverters (VSIs) with reduced common-mode voltages (CMVs). The developed method directly finds optimal vectors without using repetitive calculation of a cost function. To adjust output currents with the CMVs in the range of –V_dc/6 to +V_dc/6, the developed method uses voltage vectors, as finite control resources, excluding zero voltage vectors which produce the CMVs in the VSI within ±V_dc/2. In a model-based predictive control (MPC), not using zero voltage vectors increases the output current ripples and the current errors. To alleviate these problems, the developed method uses two non-zero voltage vectors in one sampling step. In addition, the voltage vectors scheduled to be used are directly selected at every sampling step once the developed method calculates the future reference voltage vector, saving the efforts of repeatedly calculating the cost function. And the two non-zero voltage vectors are optimally allocated to make the output current approach the reference current as close as possible. Thus, low CMV, rapid current-following capability and sufficient output current ripple performance are attained by the developed method. The results of a simulation and an experiment verify the effectiveness of the developed method.     

Improved synergetic excitation control for transient stability enhancement and voltage regulation of power systems

This paper proposes decentralized improved synergetic excitation controllers (ISEC) for synchronous generators to enhance transient stability and obtain satisfactory voltage regulation performance of power systems. Each generator is considered as a subsystem, for which an ISEC is designed. According to the control objectives, a manifold, which is a linear combination of the deviation of generator terminal voltage, rotor speed and active power, is chosen for the design of ISEC. Compared with the conventional synergetic excitation controller (CSEC), a parameter adaptation scheme is proposed for updating the controller parameter online in order to improve the transient stability and voltage regulation performance simultaneously under various operating conditions. Case studies are undertaken on a single-machine infinite-bus power system and a two-area four-machine power system, respectively. Simulation results show the ISEC can provide better damping and voltage regulation performance, compared with the CSEC without parameter adaptation scheme and the conventional power system stabilizer.