Effect of Strain Rate on Discontinuous Flow and Mechanical Characteristics of High-Nitrogenous Steel

Experimental study on the effect of strain rate on discontinuous flow and mechanical characteristics of the high-nitrogenous steel Kh23AG19F has been performed. Within the range of strain rates from 4.62 · 10^-5 to 1.85 · 10 ^-4 s^-1, discontinuous flow, reflected by serration on the tensile diagram, is chiefly determined by intergranular deformation mechanisms. Under strain rates over 1.85 · 10^-2 s^-1, combined deformation modes prevail, which cause a change in the character of discontinuous flow and transform a serrated tensile diagram into a wavy graph, with the yield stress of steel increased significantly.     

基于BOOSt结构下不连续导电模式的PFC电路

采用现代高频功率变换技术的有源功率因数校正（Power Factor Corrector,PFC)技术是解决高频开关变换器谐波污染的有效手段。与传统的PFC电路相比，有源PFC电路的输入电流接近正弦波且与输与电压同相位，能有效抑制电流波形畸变和谐波，因此避免了对同一电网设施的干扰。在PFC电路中，Boost变换器是研究和应用得最多的一种变换器。本文着重分析了Boost电路在不连续导电模式状态下，PFC电路的临界条件，对实际电路结构的设计有很好的指导意义。     

New two‐dimensional slope limiters for discontinuous Galerkin methods on arbitrary meshes

In this paper, we introduce an extension of Van Leer's slope limiter for two‐dimensional discontinuous Galerkin (DG) methods on arbitrary unstructured quadrangular or triangular grids. The aim is to construct a non‐oscillatory shock capturing DG method for the approximation of hyperbolic conservative laws without adding excessive numerical dispersion. Unlike some splitting techniques that are limited to linear approximations on rectangular grids, in this work, the solution is approximated by means of piecewise quadratic functions. The main idea of this new reconstructing and limiting technique follows a well‐known approach where local maximum principle regions are defined by enforcing some constraints on the reconstruction of the solution. Numerical comparisons with some existing slope limiters on structured as well as on unstructured meshes show a superior accuracy of our proposed slope limiters. Copyright © 2004 John Wiley & Sons, Ltd.     

CHARACTERISTICS OF INTERNAL FRICTION AND MODULUS ASSOCIATED WITH NON-EQUILIBRIUM DIFFUSION-TYPE PHASE TRANSFORMATION IN EUTECTOID Al-Zn ALLOY

The characteristics of the low frequency internal friction and the modulus effect associatedwith the non-equilibrium spinodal pretransformation and the following discontinuous trans-formation was investigated in an as-quenched eutectiod Al-Zn alloy.It was observed that theloss of the stability in the lattice,which corresponded to the large-amplitude long-wavelengthstatic concentration wave in the non-equilibrium spinodal pretransformation,did not induceany effect of localized soft modulus.Although there are two aging internal friction peaks inphase transformation which correspond to the appearance and disappearance of the coherencyin spinodal pretransformation and the maximum of the interface area in the discontinuoustransformation respectively,the effect of localized soft modulus did not take place yet.     

TiAl基合金在快速加热循环热处理过程中的结构失稳

观察了快速加热循环热处理过程中发生的4种结构失稳现象：形成二次层片组织、原始层片球化、晶界处非连续粗化、相界形核。通过比较连续加热与等温加热条件下的相转变开始线，探讨了连续加热与等温加热条件下结构失稳机制的异同。提出了快速加热循环热处理过程中避免结构失稳的途径：确保合金成分均匀，使各区域相变温度一致；使最高温度下的保温时间尽可能短。     

Z源直流变换器电感电流断续工作模式分析

Z源变换器具有新型的拓扑结构,在输入直流电源和输出变换器之间采用独特的Z源网络进行连接,以获得更好的升/降压效果.在电感电流断续条件下,对Z源直流变换器的工作状态进行了详细分析,利用稳态条件下电感平均电流为零的条件推导出Z源直流变换器的升压比,进一步分析出临界电感的计算公式,并通过仿真验证了理论分析的正确性.     

对称正则长波方程的局部间断Galerkin方法

利用局部间断Galerkin方法求解带有周期性边值条件的对称正则长波方程,通过将方程组化为一阶系统,并选取适合方程的数值通量,构造方程的半离散LDG格式,证明了格式的稳定性和收敛性。     

双排刚性桩屏障对平面SH波的隔离性状研究

基于Twersky的理论,引入圆柱体对声波和电磁波的多重散射解析解,对用排桩隔离环境振动的问题,提出了一种新的求解任意排列、任意直径刚性桩对平面SH波多重散射的理论方法,解决了传统的假设单重散射的计算方法中不考虑桩列作为整体屏障从而忽略桩间相互干涉关系的不足。随后,在数值计算分析中讨论了散射重数,排间距,桩间距等因素对双排刚性桩隔振效果的影响,对实际工程中利用排桩进行振动污染治理和屏障隔振的设计提出了有意义的结论。     

倾斜疲劳裂纹在混合型应力下张开及滑移特性

对于存在裂纹的机械零件或者构件,它很有可能会受到来自不同方向的作用力, 因此有必要研究裂纹在混合型应力条件下的传播特性. 该文使用具有不同倾斜角度的裂纹--这些裂纹是在应力比R=0的Ⅰ型循环应力下制作的,通过测量裂纹的开口方向和滑移方向的位移量,计算了裂纹端部Ⅰ型应力强度因子(KⅠ)mes和Ⅱ型应力强度因子(KⅡ)mes.裂纹的倾斜角度是指载荷方向与裂纹间的夹角.结果表明,对于存在压缩残余应力的疲劳裂纹,当倾斜角度较大,即β=60°时,应力强度因子的实验值(KⅠ)mes小于理论计算值(KⅠ),但此时实验值(KⅡ)mes与理论值(KⅡ)基本一致.另一方面,对于倾斜角度较小β=45°的疲劳裂纹,其(KⅠ)mes减少的同时,由于裂纹上下表面相互接触,从而导致(KⅡ)mes同时下降.     

灰度级信息的目标边界精确周长估算

目的 针对图像目标边界不连续或具有模糊性导致的目标周长无法精确估算这一问题,结合边界跟踪,提出一种基于灰度级信息的目标边界精确周长估算方法。方法 该方法利用目标边界的灰度级信息,同时结合边界跟踪得到的内外边界来估计目标图像的边界周长,从而提高边界周长估计的精确性和鲁棒性。为了获得目标物体真实周长,实验采用人工合成图像。结果 实验应用所提方法和3种传统周长估算方法分别计算合成目标对象的周长,并与真实周长比较。为了验证所提方法的有效性和鲁棒性,实验中对目标对象的边界进行不同程度的加厚模糊化;并在边界加入噪声,使边界不连续。当边界变得复杂时,本文所提方法的优势得到极大体现。结论 实验结果表明,在边界模糊和边界不连续的情况下,本文所提的算法具有更好的适应性和稳定性。