自重湿陷性黄土地基预钻孔浸水处理的可靠度设计方法

为解决传统预浸水法存在的浸水时间长、浸水处理范围难以确定等不足,基于土体中水分运移规律,依据可靠度理论、极限状态设计方法及复合 Poisson 过程原理,提出一种消除黄土湿陷性的处理浸水方法——预钻孔浸水法。给出了利用预钻孔浸水法对自重湿陷性黄土地基进行浸水时,水平向及竖直向浸水影响范围的确定模型;在此基础上结合达西定律给出了浸水孔设计参数如孔深、孔间距及浸水孔个数的确定方法。结合铜川某工程,设计进行了现场预钻孔浸水试验,对该方法的合理性进行了验证,并通过现场钻探、现场勘探、室内湿陷性试验等方法对该方法的处理效果进行了评价。该浸水方法具有浸水时间短、浸水影响范围可根据浸水孔布设进行控制等优点,且浸水处理效果良好,完全符合施工要求。     

Comparative analysis of inbreeding parameters and runs of homozygosity islands in 2 Italian autochthonous cattle breeds mainly raised in the Parmigiano-Reggiano cheese production region

Reggiana and Modenese are autochthonous cattle breeds, reared in the North of Italy, that can be mainly distinguished for their standard coat color (Reggiana is red, whereas Modenese is white with some pale gray shades). Almost all milk produced by these breeds is transformed into 2 mono-breed branded Parmigiano-Reggiano cheeses, from which farmers receive the economic incomes needed for the sustainable conservation of these animal genetic resources. After the setting up of their herd books in 1960s, these breeds experienced a strong reduction in the population size that was subsequently reverted starting in the 1990s (Reggiana) or more recently (Modenese) reaching at present a total of about 2,800 and 500 registered cows, respectively. Due to the small population size of these breeds, inbreeding is a very important cause of concern for their conservation programs. Inbreeding is traditionally estimated using pedigree data, which are summarized in an inbreeding coefficient calculated at the individual level (F_PED). However, incompleteness of pedigree information and registration errors can affect the effectiveness of conservation strategies. High-throughput SNP genotyping platforms allow investigation of inbreeding using genome information that can overcome the limits of pedigree data. Several approaches have been proposed to estimate genomic inbreeding, with the use of runs of homozygosity (ROH) considered to be the more appropriate. In this study, several pedigree and genomic inbreeding parameters, calculated using the whole herd book populations or considering genotyping information (GeneSeek GGP Bovine 150K) from 1,684 Reggiana cattle and 323 Modenese cattle, were compared. Average inbreeding values per year were used to calculate effective population size. Reggiana breed had generally lower genomic inbreeding values than Modenese breed. The low correlation between pedigree-based and genomic-based parameters (ranging from 0.187 to 0.195 and 0.319 to 0.323 in the Reggiana and Modenese breeds, respectively) reflected the common problems of local populations in which pedigree records are not complete. The high proportion of short ROH over the total number of ROH indicates no major recent inbreeding events in both breeds. ROH islands spread over the genome of the 2 breeds (15 in Reggiana and 14 in Modenese) identified several signatures of selection. Some of these included genes affecting milk production traits, stature, body conformation traits (with a main ROH island in both breeds on BTA6 containing the ABCG2, NCAPG, and LCORL genes) and coat color (on BTA13 in Modenese containing the ASIP gene). In conclusion, this work provides an extensive comparative analysis of pedigree and genomic inbreeding parameters and relevant genomic information that will be useful in the conservation strategies of these 2 iconic local cattle breeds.     

Association of TaD14-4D,a Gene Involved in Strigolactone Signaling,with Yield Contributing Traits in Wheat

Tillering is a crucial agronomic trait of wheat; it determines yield and plant architecture. Strigolactones (SLs) have been reported to inhibit plant branching. D14, a receptor of SLs, has been described to affect tillering in rice, yet it has seldomly been studied in wheat. In this study, three TaD14 homoeologous genes, TaD14-4A, TaD14-4B, and TaD14-4D, were identified. TaD14-4A, TaD14-4B, and TaD14-4D were constitutively expressed, and TaD14-4D had a higher expression level in most tissues. TaD14 proteins were localized in both cytoplasm and nucleus. An SNP and a 22 bp insertion/deletion (Indel) at the exon regions of TaD14-4D were detected, forming three haplotypes, namely 4D-HapI, 4D-HapII, and 4D-HapIII. Due to the frameshift mutation in the coding region of 4D-HapII, the interaction of 4D-HapII with TaMAX2 and TaD53 was blocked, which led to the blocking of SL signal transduction. Based on the two variation sites, two molecular markers, namely dCAPS-250 and Indel-747, were developed. Association analysis suggested that haplotypes of TaD14-4D were associated with effective tillering number (ETN) and thousand kernel weight (TKW) simultaneously in four environments. The favorable haplotype 4D-HapIII underwent positive selection in global wheat breeding. This study provides insights into understanding the function of natural variations of TaD14-4D and develops two useful molecular markers for wheat breeding.     

Verification of unified effective stress theory based on the effect of moisture on mechanical properties of fiber reinforced unsaturated soil

The unified effective stress theory based on suction stress (SSCC theory) enables the characterization of soils under both saturated and unsaturated conditions with one closed-form relationship. This study provides experimental verification of this theory through the unconfined compressive strength test (UCS) and indirect tensile test strength (ITS) on silty clay soil stabilized with fiber. A series of matric suction, ITS, and UCS tests were conducted to validate the SSCC theory through the representation of the results of ITS and UCS tests in terms of mean total stress (p) versus deviatoric stress (q) and mean effective stress (p`) versus deviatoric stress (q). The results of the validation procedures showed that the SSCC theory is applicable and valid at a range of 6%–16% of water content on the silty clay and the silty clay fiber-reinforced soils. There is a small fluctuation in the increase of ITS and UCS values with increasing fiber content due to randomly oriented distribution of the fiber. The addition of glass fiber does not significantly affect the capacity of water retention of the soil. It improves the condition of the mechanical soil properties at the end of construction more than of the effective stress condition.     

基于新型光纤的传输技术探讨

随着互联网的高速发展，引发了网络流量、电信骨干网流量急速增长，使得网络容量的提升迫在眉睫。目前，100G 系统已经商用，超100G系统能够更有效地解决流量和网络带宽持续增长带来的压力，本文主要介绍新型单模光纤的特性以及探讨基于新型单模光纤的传输技术。     

分级加载电压下考虑有效电势变化的软黏土电渗固结理论

分级加载电压技术能够有效延长电渗处理的时间,改善地基的处理效果并能有效降低能耗。在利用分级加载电压技术开展电渗试验时,随着土体的排水固结,土体各点的电势会发生明显的变化,这与现有的电渗固结理论假设土体各点电势保持不变有所差异。利用自主设计的电渗试验仪器开展了分级加载电压下的电渗室内试验,分析了电渗过程中土体有效电势变化的规律。基于该规律并结合Esrig固结理论建立了在阳极处不排水、阴极处排水条件下考虑土体有效电势变化的电渗固结理论,得到了分级加载电压条件下考虑土体有效电势变化的超静孔隙水压力和平均固结度的解析表达式。研究表明,在电压分级加载过程中,土体有效电势变化规律表现为随时间先基本保持不变,后呈抛物线状先增后减。通过试验案例验证了考虑土体有效电势变化所求得解析解的合理性,且该数值计算结果相较于Esrig数值计算结果,前者更加接近实测值,该固结方程的建立为后续分级加载电压技术的推广应用提供了理论依据,也为实际工程提供了参考。     

Assessing smoke toxicity of burning combustibles by four expressions for fractional effective dose

Toxicity of smoke generated in a fire is difficult to measure accurately. That is because gas sensors for measuring rapidly varying concentrations of toxic gases are not yet developed. Simple expressions are searched for quick measurement in assessing smoke toxicity practically. Four equations on calculating fractional effective dose (FED) related to toxic effluents were reported in the literature, each based on different assumptions. FED value was proposed to be calculated based on peak carbon monoxide concentration and peak carbon dioxide concentration, and transient carbon monoxide, carbon dioxide, and oxygen concentrations. The four values were compared in this article using literature data on toxic gases from different materials measured by (i) cone calorimeter; (ii) full-scale burning tests; and (iii) tunnel full-scale tests. Measured carbon monoxide, carbon dioxide, and oxygen concentrations by standard equipment of oxygen consumption calorimeters were used to calculate the four FED values. It is found that the values of FED based on peak carbon monoxide and carbon dioxide concentrations (denoted as FED₂) are similar to the average values of FED calculated from the updated equation in the literature using the oxygen consumption calorimeters. Putting the values of FED₂ in fire safety design guides is then recommended.     

劲骨胶囊功效成分鉴别及其盐酸氨基葡萄糖含量测定

目的对劲骨胶囊功效成分进行鉴别并对其主要的功效成分盐酸氨基葡萄糖的含量进行测定。方法采用化学反应法、薄层色谱法(thin-layer chromatography,TLC)及高效液相色谱法(high performance liquid chromatography,HPLC)鉴别功效成分及测定盐酸氨基葡萄糖含量。结果样品和盐酸氨基葡萄糖对照品与碱性酒石酸铜试液反应生成红色Cu_2O沉淀,与硝酸银试液反应生成白色絮状AgCl沉淀,与茚三酮试液反应生成蓝紫色溶液,在薄层色谱相应位置上生成深红色斑点。样品和芍药苷对照品在薄层色谱相应位置上生成蓝紫色斑点。样品和碳酸钙对照品与稀盐酸试液反应产生CO_2气体,与草酸铵试液反应生成白色CaC204沉淀。样品和维生素K_1对照品及样品和维生素D_3对照品高效液相色谱峰保留时间一致。所有阴性样品都无上述反应。通过高效液相色谱法测定样品中盐酸氨基葡萄糖含量,线性范围为96～1200μg/mL,相关系数为0.9999,方法检测限1.2μg/mL,精密度为0.72%,回收率为99.78%～100.40%。对连续3批样品盐酸氨基葡萄糖的含量进行测定,含量分别为64.94 g/100 g、64.25 g/100 g及65.12 g/100 g,相对标准偏差为0.48%。结论这种鉴别和含量测定方法专属性强、重现性好、灵敏度高,可管控产品质量,适合应用于劲骨胶囊功效成分鉴别及盐酸氨基葡萄糖含量测定工作中。     

Transformation of the reabsorption characteristics of lignite treated by low and high temperature drying process

Abstract

The reabsorption characteristics of the lignite treated by low and high temperature drying process were addressed in the paper. The information about the moisture form, functional groups, effective water-filled porosities and equilibrium moisture content of the lignite before and after the drying process was investigated using Differential scanning calorimetry (DSC), Fourier transform infrared (FTIR) spectroscopy, nuclear magnetic resonance (NMR) spectroscopy and a self-made reabsorption device, respectively. The results show that the low drying temperature (140, 190, 230?°C, 10?min, N₂) has little impact on the effective water-filled porosities of the resulted samples, whereas it has a great influence on the main oxygen-containing functional groups, which amount firstly decreases and then increases with the drying temperature increasing. In the case of the lignite samples dried under high-temperature (600, 700, 800?°C, 30?s, N₂), the amount of the effective water-filled porosity of the sample decreases and the amount of oxygen-containing functional groups increases as the temperature increasing. The reabsorption capability of the high temperature dried sample is much lower than that of the sample treated under low drying temperature. The reabsorption characteristics of the low-temperature dried samples are affected by the amount of the oxygen-containing functional groups, while the effective water-filled porosity is main factor for the lignite samples derived from high temperature drying process. Moreover, the work gives a good evidence that the high-temperature drying process is an effective choose for lignite upgrading.