A CEC-funded project has been performed to tackle the problem of producing an advanced Life Monitoring System (LMS) which would calculate the creep and fatigue damage experienced by high temperature pipework components. Four areas were identified where existing Life Monitoring System technology could be improved:
1. 1. the inclusion of creep relaxation
2. 2. the inclusion of external loads on components
3. 3. a more accurate method of calculating thermal stresses due to temperature transients
4. 4. the inclusion of high cycle fatigue terms.
The creep relaxation problem was solved using stress reduction factors in an analytical in-elastic stress calculation. The stress reduction factors were produced for a number of common geometries and materials by means of non-linear finite element analysis. External loads were catered for by producing influence coefficients from in-elastic analysis of the particular piping system and using them to calculate bending moments at critical positions on the pipework from load and displacement measurements made at the convenient points at the pipework. The thermal stress problem was solved by producing a completely new solution based on Green's Function and Fast Fourier transforms. This allowed the thermal stress in a complex component to be calculated from simple non-intrusive thermocouple measurements made on the outside of the component. The high-cycle fatigue problem was dealt with precalculating the fatigue damage associated with standard transients and adding this damage to cumulative total when a transient occurred.
The site testing provided good practical experience and showed up problems which would not otherwise have been detected. 相似文献
In this study the shelf‐life of sardine marinades was investigated. After the marination process, sardine fillets were packed into glass jars with 2% citric acid, 4% sodium chloride and spices. The effect of pasteurization at 70 °C for 20 min on the shelf‐life of the sardine marinades was determined. At the end of 6 months storage the differences between thiobarbituric acid, free formaldehyde (FA(ex)), free and bound formaldehyde (FA(dest)) and peroxide value of pasteurized and non‐pasteurizated marinades were not significantly (P > 0.05) different, while the difference between total volatile basic nitrogen, trimethylamine, pH, total plate count and lactic acid bacteria count of pasteurized and non‐pasteurized marinades were. The shelf‐life of both pasteurized and non‐pasteurized sardine marinades was found to be 5 months at 4 °C. 相似文献
Deciding between the different policy approaches available for reducing human exposures to indoor pollutants is an exceptionally complex task. These options can range from waiting until more definitive information is available to enacting regulatory standards, with many variations in between. This paper presents some of the factors policy-makers must consider in establishing indoor air quality policies, and the role researchers should play in ensuring that indoor air policies are based on the best available scientific information. 相似文献
Packaging engineers need to be able to accurately determine the forces present in the shipping environment in order to protect packaged goods. The purpose of this study was to determine the vertical vibration levels measured in three separate truck-trailer suspension systems; conventional leaf-spring, conventional air-ride and damaged air-ride. The main conclusion reached in this study is that the air-ride suspension when maintained gives lower power density (PD) levels on all road surfaces studied. A damaged air-ride suspension and leaf-spring suspension are very similar in response frequencies, although the damaged air-ride produces higher vibration levels at lower frequencies. 相似文献
The aim of this study was to design a modified atmosphere package for a mixed vegetable salad consisting of 75 g of cut carrot, 55 g of cut cucumber, 20 g of sliced garlic and 50 g of whole green pepper. Respiration data of all the components were combined with film permeability data to predict package atmospheres and design optimal packages for experimental testing for improved shelf-life of the produce. The optimal package avoided minimum O2 and maximum CO2 tolerance limits, and chilling injury temperatures for any component. A pouch form package made of 27 mm low density polyethylene developed a modified atmosphere of 2.0–2.1% O2 and 5.5–5.7% CO2, which was beneficial for all components and provided better quality retention than other test packages. 相似文献
Vibro-fluidized beds are widely used in drying sticky powders and agglomerated materials as milk powder. Using a vibro-fluidized laboratory scale dryer, this work is aiming at analyzing preliminarily the effect of its operational variables on the drying kinetics and characteristics of whole milk powder. The full-factorial design technique with three replications at the central point has been employed to generate data and correlations to quantify the effect of inlet air temperature, air flow rate, and vibration bed amplitude on the drying curves and the milk powder properties related to its faster reconstitution in water (as tapped density, Hausner cohesion ratio, agglomerate size distribution, and internal pore concentration). Results obtained are analyzed and discussed to identify the adequate operation condition for final drying whole milk powder in vibro-fluidized beds, assuring a high product quality. 相似文献
Total phosphorus (TP) inputs to Lake Simcoe have led to hypolimnetic dissolved oxygen (DO) depletion and loss of cold water fish habitat. Since 1990, efforts have been made to reduce the total TP input to the lake below a defined target of 75 t/year, which was predicted to lead to reductions in spring TP concentration and improvements in end-of-summer hypolimnetic DO concentrations. The total TP load to the lake during the most recent period of record (1998/99-2003/04) ranged from 53 to 76 t/yr and averaged 67 t/yr, compared to an average of 114 t/yr estimated between 1990/91 and 1997/98 (range 85-157 t/yr). Reductions in TP loads from the catchment via tributary discharge (∼26 t) accounted for the majority of the decrease in total load between the two time periods. Total P concentrations decreased significantly in four out of six long-term monitored tributaries; however, concentrations in all six tributaries remain above the level recommended to avoid nuisance plant growth (30 μg/L). Although TP loads to the lake are currently below the target 75 t/yr, excessive growths of filamentous algae and macrophytes continue to be a problem in the nearshore zone. End-of-summer minimum hypolimnetic DO concentrations (average 4.3 mg/L, 1998/99-2003/04) remain substantially below the level (7 mg/L) that is considered protective of lake trout. Efforts to reduce TP loads to the lake therefore need to continue. 相似文献
This paper deals with an advanced static Var compensator (ASVC) using quad-series voltage-source PAM inverters. The ASVC consists of four three-phase voltage-source inverters with a common dc capacitor and four three-phase transformers, each primary winding of which is connected in series with each other. Each inverter outputs a square-wave voltage, while the synthesized output voltage of the ASVC has a 24-step wave shape. This results not only in a great reduction of harmonic currents and dc voltage ripples but also in fewer switching and snubbing losses. In this paper, transient analysis is performed with the focus on the response of reactive power and the resonance between the dc capacitor and ac reactors. Experimental results obtained from a small-rated laboratory model of 10 kVA are also shown to verify analytical results based on the p-q transformation. The analytical results help in the design of system parameters such as the capacity of the dc capacitor and feedback gains. 相似文献
The behavior of inducted gas from liquid surface and the; power requirements in an agitated tank using a mechanical agitator are studied in order to increase the amount of gas self-induction and the gas retention time for gas absorption. A 45° six-blade downward impeller turbine was utilized in this study. Air and water, air and 40 wt% 60 wt%, and 80 wt% of glycerin water, and air and 106 cP silicon oil were employed as gas and liquid phases. Variables which were studied included geometrical factors (immersed depth of impeller, baffle with and diameter of impeller) and the physical properties of the liquid (viscosity, density, and surface tension). The correlations for the onset speed of impeller and power consumption after gas induction in the agitated tank are established from our experimental results. The amount of gas self-induction from the liquid surface in the agitated tank increases with increasing impeller diameter and speed and decreases with increasing baffle width, depth of impeller and viscosity of liquid. 相似文献