国产风机盘管空调系统常见问题分析

分析了国产风机盘管使用中常见的问题,指出机组因风量不足、冷量风量匹配不合理以及风机盘管某些设备故障,导致了风机盘管精度低、舒适性差、能耗高等一系列问题。指出应引起空调设计和运行维护人员的注意。     

屏蔽暂堵技术在青西地区的应用

对玉门油田青西地区裂缝性储层的保护方法 ,最有效的技术手段就是利用屏蔽暂堵技术。根据该地区储层岩性不同 ,分别选用聚磺、金属离子、阳离子钻井液体系 ,在原浆的基础上加入EP - 2、LF - 1和硅油消泡剂 ,配制成屏蔽暂堵钻井液体系。通过室内试验 :屏蔽暂堵钻井液体系API失水小于 5ml,HTHP失水小于 13ml,岩心渗透率恢复值大于 70 % ,起到了良好的屏蔽暂堵效果。经完井试油发现 ,储层污染明显减小 ,产量与邻井相比有大幅度提高     

Magnetic field dependence of shielding current density in Y-Ba-Cu-O rings at 77 K

A method for contactless measurement of the shielding critical current density and its dependence on the external magnetic field is described and analyzed. The obtained values are compared with those measured resistively on two different samples. It is shown that the shielding critical current densityJ _cs and the intergranular transport current densityJ _cr are identical if the measurement conditions are similar. A degradation ofJ _cs measured in the external field with AC ripple has been observed.     

Absolute Measurements of the Magnetic Field Generated by Different Coils in the Center of EGYPTOR Tokamak

The present work is devoted to measure the absolute magnetic field produced by different coils in the EGYPTOR tokamak using a calibrated pickup coil. Scaling these measurements in different equations connected with the discharge currents from each supply system are performed. The pickup coil used in the present study is well calibrated with Helmholz coils at the IPP in Prague, Czech Republic. A 0.2% deviation has been found between an evaluation done in the present study and the calibration using Helmholz coils. Experimental measurements of the toroidal magnetic field are in good agreement with calculations to within 2%. Very low values of stray magnetic field components arising from TF and OH coils are recorded which proves that the compensation coils for these components are sufficient.     

彩色多频同步显示器行激励级电路的倒推设计法（1）

行激励级电路的设计是完全为行输出级服务的,它实质上是行输出级电路设计的一个重要而不可分割的组成部分。因此行激励级电路的设计,自然采用了从显象管偏转线圈和行输出管到激励变压器和行激励级的倒推设计法。     

关于电磁屏蔽

本文从场的角度阐述了电磁屏蔽原理,计算方法及实际中考虑屏蔽应注意的问题。提出了组合屏蔽方式。     

镀铜／镍聚丙烯腈纤维填充复合材料电磁波屏蔽性能的研究

研究了镀铜／镍的聚丙烯腈纤维填充ＡＢＳ树脂制得的复合材料的导电性及电磁波屏蔽性能，复合材料的导电性主要与导电纤维的填加量有关，导电纤维与基体树脂间的相容状况、复合加工时某些工艺条件等对复合材料的导电性也有较大的影响，电磁波屏蔽性能随导电纤维填加量的增加而提高，加入适当的偶联剂有助于改善和复合材料的电磁波屏蔽性能。     

微型电磁继电器的制作和仿真分析

介绍了一种基于MEMS技术的微型电磁继电器的制作过程和仿真分析.这种微继电器的大小约是4mm×4mm×0.5mm,主要采用普通的微加工技术来完成全部制作工艺.与传统继电器相比,这种继电器采用平面线圈来代替螺线管线圈,有利于MEMS工艺,并且提出了一种双支撑的悬臂梁结构做为活动电极,具有较高的灵敏性和稳定性.另外,还进行了一些有关线圈通过激励电流后对活动电极产生电磁力的理论计算和仿真分析,利用这些结果可以对这种电磁继电器的结构和参数进一步优化.     

螺旋管簧的可靠性优化设计

讨论了螺旋管簧的可靠性优化设计问题。在基本随机变量的概率特性已知的情况下，采用二阶矩法和可靠性优化设计方法对螺旋管簧进行了可靠性优化设计。通过计算机程序可以直接实现螺旋管簧的可靠性优化设计，迅速准确地得到螺旋管簧的可靠性优化设计信息。