VO2/GaAs异质结的制备及其光电特性研究

采用直流磁控溅射和后退火氧化工艺在p型GaAs单晶衬底上成功制备了n-VO_2/pGaAs异质结,研究了不同退火温度和退火时间对VO_2/GaAs异质结性能的影响,并分析其结晶取向、化学组分、膜层质量以及光电特性。结果表明,在退火时间2 h和退火温度693 K下能得到相变性能最佳的VO_2薄膜,相变前后电阻变化约2个数量级。VO_2/GaAs异质结在308 K、318 K和328 K温度下具有较好的整流特性,对应温度下的阈值跳变电压分别为6.9 V、6.6 V和6.2 V,该结果为基于VO_2相变特性的异质结光电器件的设计与应用提供了可行性。     

DR环形吹风冷却装置及智能控制系统设计研究

介绍了河北达瑞化纤机械有限公司开发的DR环形吹风冷却装置,该装置能实现自动、精准、快速更换整流筒,打破了原有环吹风装置整流筒从风室顶部安装这一传统模式,利用风室底部安装和风室密封结构改变,采用气缸动力下的自动调节技术,实现了快速更换整流筒。该装置在维修和更换整流筒组件时,无须搬动上压盖,无须拆装若干螺栓,能自动化操作,降低了操作工人劳动强度,缩短了操作时间。开发的DCS智能控制系统,实现了实时智能监测冷却吹风装置的运行状况。     

Investigation on SCR-based ESD protection device for biomedical integrated circuits in a 0.18-μm CMOS process

In these decades, integrated circuits for biomedical electronics applications have been designed and implemented in CMOS technologies. In order to be safely used by human, all microelectronic products must meet the reliability specifications. Therefore, electrostatic discharge (ESD) must be taken into consideration. To protect the biomedical integrated circuits in CMOS technologies from ESD damage, a dual-directional silicon-controlled rectifier (DDSCR) device was presented in this work. Experimental results show that the DDSCR has the advantages of high ESD robustness, low leakage, large swing tolerance, and good latchup immunity. The DDSCR was suitable for ESD protection in biomedical integrated circuits.     

Robust Adaptive Control of Pulse-width Modulated Rectifiers Based on Adaptive Super-twisting Sliding-mode and State Feedback Controllers

Abstract—This article proposes a new robust adaptive hybrid controller for three-phase pulse-width modulated rectifiers to improve control performance. This hybridization is implemented by combining the second-order sliding mode with the adaptive gain super-twisting control law in the DC bus voltage control loop and state feedback adaptive control in the d-q-axis current control loops. The control objectives are fourfold: (1) driving the DC bus voltage to a reference signal without using a priori knowledge of the plant parameters, (2) forcing the d-q-axis current errors to zero, (3) assuring a satisfactory power factor correction in relation to the AC source, and (4) eliminating the chattering effect. In the closed-loop control system, three-phase source currents and the DC bus voltage are supposed to be available for feedback. As a result, no a priori knowledge of the plant parameters is necessary in the design of the proposed controller. In addition, the proposed controller does not have the disadvantages of singularity, over-parameterization, and chattering phenomenon. Results of experimental studies prove that the proposed control system guarantees the tracking of reference signals with high performance despite all the parameter and external disturbance uncertainties.     

Fundamental Evaluation of Power Supply and Rectifiers for Wireless Power Transfer Using Magnetic Resonant Coupling

This paper provides a fundamental analysis of a power supply and rectifiers for wireless power transfer using magnetic resonant coupling (MRC). MRC enables efficient wireless power transfer over middle‐range transfer distances. MRC for wireless power transfer should operate at a high frequency in the industry science medical band, such as 13.56 MHz, because the size of the transfer device decreases at higher transfer frequencies. Therefore, the output frequency of the power supply on the transmitting side should be 13.56 MHz. In addition, the rectifier on the receiving side is operated at a high frequency. This paper focuses on the reflected power in the power supply and rectifiers. Thus, the parametric design method is clarified for the power supply, including a low‐pass filter to match the output, the impedance of the power supply with the characteristic impedance of the transmission line. In addition, the effects on the rectifiers of silicon carbide and gallium nitride diodes are confirmed by performing an experiment and a loss analysis.     

双PWM变频调速系统在矿井提升机中的应用

针对目前大部分矿井提升机仍采用转子串电阻调速方法造成能量浪费的现状,提出了一种双PWM变频调速方案:三相电压型PWM整流器采用电压、电流双闭环控制,其中电流环引入前馈解耦控制,并结合空间矢量脉宽调制(SVPWM)算法来提高直流电压利用率。仿真实验的结果表明,该双PWM变频调速系统控制精度高、动态响应快、抗扰能力强,能有效地实现矿井提升机的节能降耗。     

电流型阻抗源升压整流器

自Z源网络提出以来,阻抗源变流器得到了广泛的研究和应用,但大多是针对电压型及逆变器的。选择电流型准Z源整流器作为研究对象,在传统控制策略中加入了阻抗源电感电流的前馈控制和有源阻尼控制,得到了更高的输出范围和更好的输出波形,并通过仿真验证了控制策略的正确性。设计了1台1 kW量级的样机并进行实验验证。     

一种用于油气井持气率测量的高可靠性光纤探针

针对油气井下油气水三相流的持气率测量,设计开发了一种高可靠性的光纤探针。探针敏感探头采用锥形蓝宝石结构,蓝宝石敏感探头与过渡管,以及过渡管与保护套管间均采用金基焊料焊接密封。对研制的光纤探针进行了可靠性实验和油气水三相流持气率测试,结果表明,该光纤探针可以承受高温(150℃)、高压(100MPa)环境,具有较高可靠性。管柱内的油气水三相流呈段塞流型,持气率为46%。该研究验证了光纤探针应用于油气井持气率测量的可行性,为后续的工程应用推广提供了理论依据和实际指导。