吸湿凉爽机织物的结构设计与性能

为研究织物组织结构与复合纱线线密度对织物凉爽性能的影响,将线密度为7.4和9.8 tex涤纶分别与线密度为7.8 tex锦纶反向加捻、并线后作为纬纱,以8.3 tex涤纶/竹浆纤维50/50混纺纱作经纱,设计平纹、二上一下斜纹和透孔组织织物.测试织物的瞬间接触凉感、热湿舒适性能及织物干、湿态升温曲线,并采用凉爽温度指数对织物的综合凉爽性能进行评价.研究结果表明:6种设计织物的瞬间接触凉感均高于标准,且平纹织物最好,纬纱粗细对瞬间接触凉感影响不显著;透孔织物透气性最好,且在人体出汗的状态下具有较好的导湿散热性能.平纹织物凉爽温度指数最高,最大凉爽温度为2.8℃,综合凉爽性能最好.     

跨界借鉴在建筑立面创新设计中的运用

解释了跨界借鉴的含义,并阐述了其在建筑立面创新设计中运用的可能性和积极意义。通过案例分析,提出建筑立面跨界借鉴的内容和方式。     

Modeling Impact of ROADM Intra-Node Add/Drop Contention on a Single Node Lightpath Blocking Performance

We propose an analytical model to evaluate the lightpath blocking performance for a single ROADM node with intra-node add/drop contention,in which the number of lightpaths that can be added/dropped with the same wavelength is limited by the add/drop contention factor.Different models of traffic load per nodal degree are considered to validate the effectiveness of the analytical model.The simulation results show that the proposed analytical model is effective in predicting the performance for different values of add/drop contention factor C and for variable offered loads at the node.The add/drop contention factor shows an important impact on the lightpath blocking performance and properly raising the contention factor can significantly improve the lightpath blocking performance.When the add/drop contention factor C exceeds a certain level,the performance of a ROADM with intra-node contention is close to that of a contentionless ROADM.     

Analysis of the ionospheric variability based on wavelet decomposition

In this work,the ionospheric variability is analyzed by applying the wavelet decomposition technique to the noontime fo F2,F10.7,interplanetary magnetic field(IMF)Bz,Ap,and lower thermospheric temperature at pressure of 10?4 h Pa in 2002.Results show that the variance of periodic oscillations in the ionosphere is largest in the 2–4-day period and declines with the increase of the period.The maximum variance of the periodic oscillations in solar irradiation is in the 16–32-day period.For geomagnetic activities,most of the variance is about equally distributed on intervals of periods shorter than 32 days.Variance distributions of IMF Bz and lower thermospheric temperature are similar to those of the ionosphere.They show the maximum in the 2–4-day period and decline with the increase of the period.By analyzing the distributions of the variances,the potential connections between the ionosphere and the external sources are discussed.     

Structural dependence of microwave dielectric properties of spinel structured Mg2(Ti1-xSnx)O4 solid solutions: Crystal structure refinement,Raman spectra study and complex chemical bond theory

Mg₂(Ti_1-xSn_x)O₄ (x?=?0–1) ceramics were prepared through conventional solid-state method. This paper focused on the dependence of microwave dielectric properties on crystal structural characteristics via crystal structure refinement, Raman spectra study and complex chemical bond theory. XRD spectrums delineated the phase information of a spinel structure, and structural characteristic of these compositions were achieved with the help of Rietveld refinements. Raman spectrums were used to depict the correlations between vibrational phonon modes and dielectric properties. The variation of permittivity is ascribed to the Mg₂(Ti_1-xSn_x)O₄ average bond covalency. The relationship among the B-site octahedral bond energy, tetrahedral bond energy and temperature coefficient are discussed by defining on the change rate of bond energy and the contribution rate of octahedral bond energy. The quality factor is affected by systematic total lattice energy, and the research of XPS patterns illustrated that oxygen vacancies can be effectively restrained in rich oxygen sintering process. Obviously, the microwave dielectric properties of Mg₂(Ti_1-xSn_x)O₄ compounds were obtained (${\epsilon }_r$= 12.18, $Q\times f$?=?170,130?GHz, ${\tau }_f$?=??53.1?ppm/°C, x?=?0.2).     

SIMPLIS环境中开关电源集成电路控制器模型的开发及应用

介绍现代开关电源行业仿真工作的意义和现状,以及专用仿真软件包SIM etrix/SIMPLIS的优点和不足。通过实例给出SIMPLIS环境中集成电路控制芯片的建模过程,并就其中的关键技术予以简单讨论。     

砾岩储层精细描述中标准测井资料的应用

克拉玛依油田七区的标准测井资料是指使用标准电极系视电阻率测井、自然电位测井和井径测井,以相同的1:500深度比例尺及相同的横向比例进行测井作业所取得的资料.这种资料本来并不具备定量解释储层孔隙度和含油饱和度的能力,但这种资料占该区测井资料总量的比率高达34%.利用标准电极系视电阻率资料和岩心分析资料建立了视电阻率-岩性图版,利用自然电位减小系数α和岩心孔隙度分析资料φ建立了α-φ图版,根据综合测井资料求出标准测井视电阻率校正系数,进而确定了饱和度计算方程的参数.与相应的综合测井资料计算结果相对比,用该方法得到的孔隙度平均绝对误差及相对误差分别为1.85%和11.88%;含油饱和度平均绝对误差及相对误差分别为9.08%和24.75%.将该方法有选择地应用到该区砾岩储层精细描述研究中,弥补了缺乏综合测井资料无法进行测井储层评价及参数研究的缺陷.