全文获取类型
收费全文 | 4379篇 |
免费 | 579篇 |
国内免费 | 279篇 |
专业分类
电工技术 | 34篇 |
综合类 | 409篇 |
化学工业 | 1605篇 |
金属工艺 | 46篇 |
机械仪表 | 30篇 |
建筑科学 | 1338篇 |
矿业工程 | 311篇 |
能源动力 | 53篇 |
轻工业 | 112篇 |
水利工程 | 392篇 |
石油天然气 | 524篇 |
无线电 | 15篇 |
一般工业技术 | 231篇 |
冶金工业 | 111篇 |
原子能技术 | 11篇 |
自动化技术 | 15篇 |
出版年
2024年 | 3篇 |
2023年 | 47篇 |
2022年 | 91篇 |
2021年 | 184篇 |
2020年 | 151篇 |
2019年 | 130篇 |
2018年 | 141篇 |
2017年 | 159篇 |
2016年 | 143篇 |
2015年 | 180篇 |
2014年 | 256篇 |
2013年 | 290篇 |
2012年 | 299篇 |
2011年 | 336篇 |
2010年 | 248篇 |
2009年 | 279篇 |
2008年 | 257篇 |
2007年 | 304篇 |
2006年 | 280篇 |
2005年 | 272篇 |
2004年 | 251篇 |
2003年 | 194篇 |
2002年 | 158篇 |
2001年 | 91篇 |
2000年 | 89篇 |
1999年 | 85篇 |
1998年 | 65篇 |
1997年 | 58篇 |
1996年 | 38篇 |
1995年 | 37篇 |
1994年 | 27篇 |
1993年 | 18篇 |
1992年 | 14篇 |
1991年 | 18篇 |
1990年 | 12篇 |
1989年 | 5篇 |
1988年 | 4篇 |
1987年 | 1篇 |
1986年 | 2篇 |
1985年 | 3篇 |
1984年 | 2篇 |
1983年 | 4篇 |
1982年 | 2篇 |
1981年 | 1篇 |
1979年 | 8篇 |
排序方式: 共有5237条查询结果,搜索用时 15 毫秒
1.
黏土束缚水是储层测井评价的重要内容之一。采用扩散双电层理论推导出黏土束缚水孔隙度(ϕcw)与阳离子交换量之间的理论公式,通过岩心阳离子交换实验测定ϕcw。依据核磁共振—阳离子交换联测实验,对比分析了传统3ms黏土束缚水T2截止值测定ϕcw的误差,明确了黏土束缚水T2截止值与核磁共振不同截止值计算的ϕcw之间的变化规律,建立了变黏土束缚水T2截止值计算模型,从而实现核磁共振测井精细计算ϕcw的方法并给出具体计算步骤。应用效果表明,相比传统3ms核磁共振测井计算的ϕcw,所提新方法计算结果更合理,与岩心分析结论更匹配,是黏土束缚水评价的一种有效手段。 相似文献
2.
《Soils and Foundations》2022,62(1):101094
When a pile is installed into saturated clay ground, the “setup” effect may occur due to ground consolidation, which changes pile performance. Although this phenomenon has been observed both in the field and laboratory, its numerical simulation is still challenging. In this work, pile installation effects on the behaviors of jacked-in piles were investigated through three simulation techniques by a three-dimensional finite element analysis program, PLAXIS 3D. A constitutive model called the soft soil creep model was used to describe the soil behavior based on soil parameters obtained from laboratory tests. The behaviors of single piles were first investigated with or without the consolidation process after pile installation to evaluate the pile setup effect. Then, a pile group comprising 4 piles was analyzed using the consolidation process to verify the applicability of the three simulation techniques. The calculated results were compared with the corresponding experimental results. The calculated results using three techniques generally agreed well with the experimental results in terms of initial stiffness and pile shaft resistance. Both the measured and calculated results indicate that ground consolidation caused by pile installation significantly increases the pile bearing capacity and especially, the pile shaft resistance. Therefore, the pile setup effect can be reasonably simulated by the three proposed techniques. 相似文献
3.
在我国西南地区的工程建造中,红黏土地基工程难以避免。为确保工程质量,基于具体工程,对红黏土地基工程的勘察及地基处理进行了研究,总结了红黏土地基的勘察重点和地基处理要点,以期为红黏土地基工程的实施与研究提供参考。 相似文献
4.
5.
6.
为了探寻黏土强度时效性的微观机理,将时效强度与板状黏土颗粒搭接方式和相互作用势能联系起来,颗粒间的相互作用力使颗粒朝着势能较低的位置搭接,当颗粒间相互作用势能最低时,时效强度达到稳定值。提出了可考虑两板状颗粒间夹角θ和距离d影响的颗粒相互作用总势能公式,可用Zeta电位代替表面电位来计算势能,计算结果与实际情况相吻合。通过计算可知:①黏土时效强度与电解质浓度有很大关系,电解质浓度较低时(≤10-3mol/L),两颗粒相互垂直时的总势能最低;电解质浓度较高时(≥10-1mol/L),两颗粒相互平行时的总势能最低,时效强度几乎不变,甚至会减小;中间电解质浓度是过渡状态;②两黏土颗粒的稳定搭接方式主要是垂直和平行,两颗粒之间总会趋于向稳定搭接方式转化,这也是时效强度经历一定时间而达到稳定值的过程;③解释了黏土触变强度恢复的原因,即颗粒会一直趋于搭接强度最高的垂直稳定搭接。 相似文献
7.
生活垃圾焚烧底渣作为常见的固体废弃物之一,可与纤维混合提高其强度和稳定性。对生活垃圾焚烧底渣–黏土–聚丙烯纤维按一定比例混合,进行循环前大型直剪、循环剪切和循环后直剪试验,研究不同竖向应力、不同剪切位移幅值、不同压实度对纤维加筋底渣混合黏土循环剪切特性及循环后单调直剪特性。试验结果表明:循环前直剪试验中,剪切位移与剪应力曲线呈现弱硬化现象;施加循环荷载后的单调直剪试验,剪切位移与剪应力曲线则呈现明显软化现象。循环剪切试验过程中土样在不同竖向应力、不同剪切位移幅值下均出现循环剪切硬化和剪缩现象。随循环次数增加,硬化程度和剪缩量逐渐减小。随压实度增加,试样由明显的硬化型向软化型发展,压实度越大,沉降量越少,剪缩量越小。对比循环剪切后试样的单调直剪试验与未循环剪切单调直剪试验结果发现,循环剪切后的土样抗剪强度明显增大,黏聚力和摩擦角都相应增加。聚丙烯纤维的加入可以与底渣混合土形成空间网络骨架,从而增加试样抵抗变形能力,减小竖向沉降,增强稳定性。 相似文献
8.
以3种不同性能煅烧土取代20%二氧化钛用于装饰原纸的加填,并分析了对装饰原纸性能的影响;以6%纳米纤维素对二氧化钛进行高速预分散,并分析了纳米纤维素-二氧化钛预分散体加填对装饰原纸性能的影响。结果表明,高吸油煅烧土因为具有较高的比表面积和吸油值,可以改善浆料的滤水性能和纸张的遮盖性能,缺点是会降低纸张抗张强度。利用6%纳米纤维素对二氧化钛进行高速预分散并用于纸张加填,填料留着率从未预分散时的65%左右提高至73%左右,装饰原纸的遮盖性能也有所提高,特别是湿遮盖性能,装饰原纸的湿不透明度从未预分散时的84.1%~84.5%提高至86.5%~88.0%。纳米纤维素的存在促进了纸浆纤维结合,使纸张的透气性能明显降低。 相似文献
9.
碳纤维增强复合材料(CFRP)与黏土砖界面的粘结性能是外贴CFRP加固技术的关键,为了解CFRP-黏土砖界面粘结性能在硫酸盐侵蚀下的退化规律,对硫酸盐干湿循环不同周期下的加固试件进行了单面剪切试验,结果表明:硫酸盐侵蚀对CFRP片材与浸渍胶性能影响并不明显,但对CFRP-黏土砖界面粘结性能影响较大,CFRP-黏土砖界面剪应力、承载力均随循环次数呈先小幅上升后明显下降的趋势;在试验基础上,根据已有的理论,提出硫酸盐干湿循环作用下CFRP-黏土砖界面粘结-滑移模型,通过与试验值对比分析发现,模型能够很好地反映CFRP-黏土砖界面的粘结性能退化规律。基于ABAQUS软件,利用内聚力本构关系模型对界面力学行为进行数值模拟,结果表明,内聚力模型可以很好地模拟界面的非线性力学行为,数值模拟值与试验值吻合较好。 相似文献
10.
Tuning the nano/micro‐structure and properties of melt‐processed ternary composites of polypropylene/ethylene vinyl acetate blend and nanoclay: The influence of kinetic and thermodynamic parameters 下载免费PDF全文
The present study reports the dependence of the nano/micro‐structure and properties of polypropylene (PP)/ethylene vinyl acetate (EVA)/nanoclay ternary composites on the kinetics and thermodynamics of the melt‐mixing process. The size of dispersed EVA particles in the blends increased in the presence of the nanoclay particles, whereas in the ternary blend composites the size of the EVA dispersions decreased with increasing processing time. Intercalation and exfoliation were achieved more efficiently in ternary composites prepared with a longer EVA processing time. Moreover, the incorporation of the nanoclay particles within the EVA phase and interphase, as well as a long processing time stabilized the morphology. The degree of crystallinity, melting behavior, and crystallization temperature of PP in the ternary composites were not influenced by the presence of the nanoclay particles or by the duration of the melt‐mixing process. The thermal stability of the ternary composites improved with increasing melt‐mixing time. The rheological and thermomechanical properties were found to be dependent on the processing time and on the resulting structure. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018 , 135, 45585. 相似文献