Formation of toxic aldehydes in cod liver oil after ultraviolet irradiation

Formaldehyde, acrolein, malonaldehyde (MA), acetaldehyde and propanal produced from cod liver oil upon ultraviolet irradiation (λ_max=300 nm) were derivatized into nitrogenor sulfur-containing compounds and then analyzed by capillary gas chromatography with a nitrogen-phosphorus detector or a flame photometric detector. Acrolein and MA were formed at levels of 10.9±3.06 and 190.2±38.4 nmol/mg of fish oil, respectively. Maximum levels of formaldehyde, acetaldehyde and propanal formed were 7.0±0.90, 49.1±4.5 and 35.8±4.0 nmol/mg of oil, respectively. Formation of propanal in large quantities corresponded to the high content of ɛ-3 fatty acids in cod liver oil.     

甲醛与甲酸甲酯的偶联反应 Ⅰ.杂多酸的催化作用

研究了４种杂多酸（磷钨酸、硅钨酸、磷钼酸和硅钼酸）对甲醛和甲酸甲酯偶联反应的催化作用；对反应条件进行了考察。结果表明，磷钨酸和硅钨酸对该反应具有较高的催化活性；而氧化性强的钼系杂多酸的活性较低。水对甲醛和甲酸甲酯的偶联反应具有不利影响。将杂多酸在３００℃进行热处理后，其活性显著增强。     

树脂热解炭制备碳化硅晶须

用自制的配合醛树脂热解和炭源，用ＳＩＯ２超细汾作原，根据碳热还原原理，利用常规加热和微波加热两种方式，分别制备了直径在纳米级的ＳｉＣ晶须，Ｘ射线衍射、透射电检测结果表明：制备工艺和条件对ＳｉＣ晶须的性质有较大的影响。     

银川市室内环境空气污染现状及治理措施的初探

本文通过对银川市室内环境空气污染现状的调查与检测,阐述了室内环境空气污染的来源及危害,提出了污染治理措施。     

甲醇氧化制甲醛铁钼催化剂的研究

采用共沉淀法制备甲醇氧化制甲醛无载体铁钼催化剂,并考察了催化剂制备老化条件、焙烧温度、外型尺寸以及活性测试反应温度、空速对催化剂性能的影响。该催化剂在280~300℃、气空速7000 h-1~8000 h-1、进料φ(甲醇)为5.5%的下,可获≥98%的甲醇转化率,≥92%的甲醛选择性和≥90%的甲醛产率。催化剂活性高,强度好,性能稳定。     

木材用交联型醋丙胶粘剂的研制

研制一种由醋酸乙烯、丙烯酸丁酯、特种单体共聚而成的水性交联型环保胶粘剂以替代目前广泛使用的氨基树脂,适应绿色环保要求。     

Copolymerization in UF/pMDI adhesives networks

Kinetic evidence in thermomechanical analysis experiments and carbon‐13 nuclear magnetic resonance spectroscopy (¹³C NMR) evidence indicates that the strength of a joint bonded with UF (urea–formaldehyde)/polymeric 4,4'‐diphenylmethane diisocyanate (pMDI) glue mixes is improved by coreaction of the methylol groups of UF resins with pMDI to form a certain number of methylene cross‐links. The formation of these methylene cross‐links is predominant, rather than formation of urethane bridges which still appear to form but which are in great minority. This reaction occurs in presence of water and under the predominantly acid hardening conditions, which is characteristic of aminoplastic resins (thus, in presence of a hardener). Coreaction occurs to a much lesser extent under alkaline conditions (hence, without UF resins hardeners). The predominant reaction is then different in UF/pMDI adhesive systems than that observed in phenol‐formaldehyde (PF)/pMDI adhesive systems. The same reaction observed for UF/pMDI system at higher temperatures has also been observed in PF/pMDI systems, but only at lower temperatures. The water introduced in the UF/pMDI mix by addition of the UF resin solution has been shown not to react with pMDI to an extent such as to contribute much, if at all, to the increase in strength of the hardened adhesive. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 3681–3688, 2002     

Fenton试剂处理苯酚和甲醛废水的研究

用H2O2同Fe^2 结合的Fenton试剂处理有机废水是一种经典的催化氧化法，这种方法适合于处理废水中高浓度、难降解的有机物质。主要研究了Fenton试剂处理含苯酚和甲醛有机废水样的反应机理和影响因素，试验结果表明：废水中苯酚和甲醛的去除率均可达到95％以上，COD去除率达到85％以上，表明用Fenton法处理含苯酚和甲醛的有机废水是一种非常有效的方法。     

光催化降解甲醛的波长效应研究

分别以紫外杀菌灯和黑光灯为光源，研究了TiO2薄膜催化剂上甲醛的光催化氧化反应．实验结果表明，紫外杀菌灯照射下，甲醛的光催化降解率明显低于以黑光灯为光源时甲醛的光催化降解率．采用傅立叶红外光谱(FT-IR)和热分析(TG-DTA)对反应后的TiO2光催化剂进行分析和表征，对两种不同光源照射下甲醛光催化降解率的差异进行了初步探讨．     

催化合成高聚合度萘磺酸盐缩合物

用工业萘、硫酸、甲醛为原料,合成出聚合度为16～21的β 萘磺酸盐甲醛缩合物。确立了n(甲醛)/n(萘)=0 88～0 90,反应温度(110±5)℃,反应时间3h,催化剂MA用量为萘质量的1%的最佳工艺条件。产品性能测试表明,加入质量分数为0 8%的产品,混凝土减水率可达21%以上,抗压强度可提高60%以上。