Starch: a potential substrate for biohydrogen production

Hydrogen is a clean energy carrier with great potential to be an alternative fuel. Anaerobic hydrogen fermentation seems to be more favorable, since hydrogen is yielded at high rates and various organic waste and wastewater enriched with carbohydrates as substrate result in low cost for hydrogen production. Abundant biomass from various industries could be a source for biohydrogen production where combination of waste treatment and energy production would be an advantage. Carbohydrate‐rich nitrogen‐deficient solid wastes such as starch residues can be used for hydrogen production by using suitable bioprocess technologies. Alternatively, converting biomass into gaseous fuels, such as biohydrogen, is possibly the most efficient way to use these agroindustrial residues. This review summarizes the potential of starch agroindustrial residues as a substrate for biohydrogen production. Types of potential starch agroindustrial residues, recent developments and bio‐processing conditions for biohydrogen production will be discussed. Copyright © 2014 John Wiley & Sons, Ltd.     

热镀锌板(卷)工程设计中的环境保护问题

对热镀锌板(卷)的生产工艺、主要生产设备进行了简要介绍，并就其污染源(工序)、生产过程中产生的污染物及其控制措施进行了评述，同时就设计和生产中宜注意的几个环保问题进行了分析。     

The First Template‐Free Growth of Crystalline Silicon Microtubes

A simple template‐free high‐temperature evaporation method was developed for the growth of crystalline Si microtubes for the first time. As‐grown Si microtubes were characterized using X‐ray diffraction, scanning electron microscopy, transmission electron microscopy, and room‐temperature photoluminescence. The lengths of the Si tubes can reach several hundreds of micrometers; some of them have lengths on the order of millimeters. Each tube has a uniform outer diameter along its entire length, and the typical outer diameter is ≈ 2–3 μm. Most of the tubes have a wall thickness of ≈ 400–500 nm, though a considerable number of them exhibit a very thin wall thickness of ≈ 50 nm. Room‐temperature photoluminescence measurement shows the as‐synthesized Si microtubes have two strong emission peaks centered at ≈ 589 nm and ≈ 617 nm and a weak emission peak centered at ≈ 455 nm. A possible mechanism for the formation of these Si tubes is proposed. We believe that the present discovery of the crystalline Si microtubes will promote further experimental studies on their physical properties and smart applications.     

A novel way to treat refractory waste: Sonication followed by wet oxidation (SONIWO)

The effectiveness of the hybrid system sonication followed by wet oxidation (SONIWO) to treat otherwise refractory waste has been demonstrated. In such a hybrid system homogeneous CuSO₄ catalyst was found to be very efficient.     

Continuous precipitation of calcium sulfate dihydrate from waste sulfuric acid and lime

Precipitation of calcium sulfate dihydrate, gypsum, from (i) a pure sulfuric acid/lime suspension and (ii) a waste sulfuric acid/lime suspension in a continuous pilot plant in the temperature range from 40 °C to 80 °C was studied. It was observed that in the case of waste sulfuric acid with a high content of Mg²⁺ and Fe²⁺ ions, several hours after the beginning of the precipitation, partial dissolution of the product and modification of the crystals from needle‐ and plate‐like to agglomerated structures occurred. It is suggested that the secondary changes occur due to the increased concentration of Mg²⁺ and Fe²⁺ ions in the reactor. Below 60 °C, and above 70 °C plate‐like and needle‐like single crystals respectively were formed. The mean size (d₅₀) of the crystals was found to increase with increasing temperature and decrease with the initial concentration of lime. Gypsum produced between 70 °C and 80 °C is suitable for further processing for construction plaster. In a precipitation process with pure sulfuric acid only single perfect needle‐like crystals occurred. Copyright © 2005 Society of Chemical Industry     

Synthesis of LiFePO4 with fine particle by co-precipitation method

LiFePO₄ is a potential candidate for the cathode material of the lithium secondary batteries. A co-precipitation method was adopted to prepare LiFePO₄ because it is simple and cheap. Nitrogen gas was needed to prevent oxidation of Fe²⁺ in the aqueous solution. The co-precipitated precursor shows the high reactivity with the reductive gas, and the single phase of LiFePO₄ is successfully synthesized with the aid of carbon under less reductive conditions. LiFePO₄ fine powder prepared by co-precipitation method shows high rate capability, impressive specific capacity and cycle property.     

Controlled Synthesis of Ag2S,Ag2Se,and Ag Nanofibers by Using a General Sacrificial Template and Their Application in Electronic Device Fabrication

Nanofiber bundles of Ag₂S, Ag₂Se, and Ag have been successfully synthesized by making use of Ag₂C₂O₄ template nanofiber bundles, utilizing both anion‐exchange and redox reactions. The obtained bundles were polycrystalline nanofibers composed of nanoparticles in which the precursor morphology was well‐preserved, indicating that Ag₂C₂O₄ nanofiber bundles acted as a general sacrificial template for the synthesis of silver‐based semiconductor and metal nanofibers. Dispersing media and transforming reactants were found to be key factors influencing the chemical transformation in the system. In particular, separate single‐crystalline Ag nanofibers were obtained via a nontemplate route when ascorbic acid was used as a relatively weak reductant. An electrical transfer and switching device was built with the obtained Ag₂S and Ag nanofiber bundles, utilizing the unique ion‐conductor nature of Ag₂S and revealing their potential applications in electronics.     

JETS,PLUMES AND BUOYANT JETS IN STATIC ENVIRONMENT

Turbulence represents an essential aspect in atmospheric and oceanic circulations.In particu-lar,it is a preponderant factor in the dispersion of pollutants of artificial or natural origin.Thevertical turbulent jets,plumes and buoyant jets discharging into static environment is one of themost important and basic flow patterns related with the environment pollution.These flows havenumerous important applications,for example,thrust augmentors,waste disposal plumes fromstacks and combustion systems,and significant problems of turbulent diffusion.     

有机-无机复合肥生产工艺

随着社会经济快速发展和城乡环境的污染已日趋严重。根据有机肥、无机肥各自的优缺点提出有机-无机肥生产的新工艺。