Effect of Fe2+ and Fe0 Applied Photo‐Fenton Processes on Sludge Disintegration

The disintegration of waste active sludge was investigated by photo‐Fenton processes. A batch study was conducted to evaluate parameters, such as Fe²⁺ and Fe⁰ ions and H₂O₂, governing the activated sludge integration by the photo‐Fenton process. Under optimum conditions, the concentration of soluble chemical oxygen demand (SCOD) with the classical Fenton process (CFP) increased very rapidly in the first five minutes due to the sufficient presence of reaction components in the medium, and then the rate of increase declined. In the modified Fenton process (FTP), the SCOD concentration increased more slowly as metallic iron powder must first be dissolved. The photo‐Fenton process proved to be a feasible and efficient process for the disintegration of waste sludge.     

Nymphoides peltatum as a novel feedstock for biomethane production via anaerobic co-digestion with waste sludge

Nymphoides peltatum (NP) is exploited as a novel feedstock for biomethane production via anaerobic co-digestion with waste sludge (WS). Batch experiments are conducted under mesophilic condition at NP/WS of 1/3, 2/2, 3/1, 0/4 and 4/0 based on volatile solids (VS). Prior to anaerobic digestion (AD), NP undergoes only natural drying and grinding. The maximum net cumulative methane yield (265.16 mL CH₄·g VS_added^?1) and the highest gross VS removal rate (56.12%) are obtained at NP/WS of 1/3. The kinetic analysis by the modified Gompertz model fit hinted that 28 days is adequate for methane recovery and co-digestion significantly accelerates the digestion rate. Synergetic effect is corroborated to exist in co-digestion due to amiable conditions in term of total ammonia nitrogen, free ammonia, pH, volatile fatty acids and total alkalinity. High-throughput 16S rRNA pyrosequencing reveals that Bacteroidetes, Firmicutes, Methanosarcina and Methanosaeta are conducive to AD of NP.     

基于钴改性的钙基吸附剂污泥富氢气化

基于钙基吸附剂的污泥蒸汽气化制取富氢合成气是一种高效环保的污泥处理方式。本文采用溶胶-凝胶法制备了Co改性、Al₂O₃为载体的钙基吸附剂。借助热重分析仪测定不同钙基吸附剂在多个碳酸化和煅烧循环中的CO₂吸附能力和循环稳定性，并在固定床上进行污泥蒸汽气化实验。结果显示：煅烧过程中，以Al₂O₃为载体的钙基吸附剂中的Al₂O₃与CaO生成七铝酸十二钙(Ca₁₂Al₁₄O₃₃)，并表现出优异的孔隙结构的和CO₂吸附能力，其中，Co质量分数为10%的吸附剂在30次循环（700℃碳酸化35min，850℃煅烧5min）中碳酸化率稳定在70%左右；提高气化温度及Co的添加量可促进焦油裂解和甲烷重整反应，显著提高了合成气中H₂的浓度和产量及污泥气化的冷煤气效率，有利于富氢气体的制取；在650℃下，相比于纯CaO，添加Co质量分数为15%的吸附剂时，H₂产量提高了102%，H₂体积分数提高到85%。     

Comparison of horizontal and vertical electric field in the treatment of river sediment by electro-dewatering

The aim of this study was to evaluate and compare the effectiveness of horizontal (H-EDW) and vertical (V-EDW) electro-dewatering fields, in terms of dewatering and energy consumption, for the treatment of river sediment. The influence of the sludge thickness (3, 4, 5, 6, 7?cm) and the applied voltage (10?30?V) were examined. V-EDW was found to significantly improve dewatering and reduce process time, while H-EDW has the potential to save energy but results in sludge containing greater moisture. As the applied voltage was increased from 10?V to 30?V, the final dry solids content and energy consumption increased for both modes. Increased sludge thickness from 3?cm to 7?cm was found to have a negative influence on the final dry solid content of the sludge for V-EDW, but is not a significant influence with H-EDW. The results demonstrate that H-EDW is an effective dewatering method and has potential for continuous operation and energy efficiency for industrial-scale applications.     

原位固氮剂在污泥堆肥过程中保氮机制

高温好氧堆肥技术虽然可有效处理有机固体废物，但常常会释放大量的氨气和造成氮素损失。本文以硫酸镁、磷酸二氢钾、硫酸镁+磷酸二氢钾（分别记为MgSO₄、KP和KPM处理组）为原位固氮剂，污泥和木屑为原料，进行高温好氧堆肥试验，研究以上原位固氮剂对污泥堆肥过程中的氨气挥发和氮素损失的影响。结果表明，硫酸镁（MgSO₄）对物料pH有显著的降低效应，添加硫酸镁使堆体高温期pH降低至8.17，低于硫酸镁+磷酸二氢钾（KPM）组（8.55）和对照（CK）组（8.90）。与CK相比，MgSO₄和KPM的NH₃累积释放量分别降低了34%和28%，反而KP组增加了35%。对比不同条件下XRD图谱可知，MgSO₄的固氮效应并不是由于MgNH₄PO₄·6H₂O的生成，而是由于其对pH的降低效应造成的。堆肥结束后，除了KP组，各处理条件下的种子发芽率值（germination index，GI）均不会对后续使用带来不利影响。     

城市污水厂剩余污泥对水中F-的吸附性能研究

利用城市污水处理厂的剩余污泥对水中F-进行吸附处理,通过污泥投加量、F-初始质量浓度、时间、pH等反应条件的研究,探讨除氟效果和影响因素。结果表明,室温下,污泥对F-的吸附在60 min后达到平衡;20 g/L的污泥投加量对10 mg/L含氟水的F-去除率可达83.1%;污泥可在3~10的较大pH范围内保持稳定的除氟效果。准二级动力学模型很好地拟合了污泥对F-的吸附行为,Langmuir和Freundlich模型均符合污泥对F-的吸附特性,热力学参数的计算表明该吸附过程是自发的放热反应。     

短程反硝化耦合厌氧氨氧化工艺及其应用前景研究进展

短程反硝化以其碳源消耗量、废污泥产量、温室气体排量极低及无需曝气等优势，被认为是最具研究潜势的厌氧氨氧化底物供给技术，成为近年来研究热点。本文首先介绍了短程反硝化工艺原理；其次从污泥源、反应时间、碳源类型、碳源量及pH等5个方面总结了影响短程反硝化工艺启动因素；随后综述了短程反硝化耦合厌氧氨氧化工艺的重要研究进展，同时指出了耦合工艺实验研究与工程应用的不足，并提出了解决实验与工程应用缺陷的方案；最后展望了耦合工艺处理城市污水和工业硝酸盐废水的可行性及应用前景，认为全面分析工业硝酸盐废水化学组分与基于分子生物学水平的宏基因组学测序、元转录组学技术是未来耦合工艺同步处理城市污水和工业硝酸盐废水的研究重点。     

Study on migration characteristics of heavy metals during oil sludge incineration

Experimental and simulation studies on the migration characteristics of heavy metals during the incineration of OS were conducted with a tube furnace reactor and thermodynamic equilibrium calculation software FactSage, respectively. The results showed that when the incineration temperature increased from 800°C to 1100°C, the release rates of heavy metals such as Cr, Pb, Cu, Zn and Ni increased gradually and reached the maximum at 1000°C. When the excess air ratio increased from 1.0 to 1.4, the release rates of heavy metals such as Cr, Pb, Cu, Zn and Ni first decreased and then became steady. The content of gaseous hydroxide of Cr and gaseous chlorides of Pb and Cu increased while the chemical forms of Zn and Ni did not change obviously with the increase of combustion temperature or excess air ratio.