Effect of phosphogypsum on saline-alkalinity and aggregate stability of bauxite residue

A column experiment was conducted to investigate the effect of phosphogypsum (PG) on the saline- alkalinity, and aggregate stability of bauxite residue. Results showed that: with increasing leaching time, the concentrations of saline-alkali ions decreased while the concentration increased in bauxite residue leachate; compared with CK (control group) treatment, pH, electric conductivity (EC), exchangeable sodium percentage (ESP), sodium absorption ratio (SAR), and exchangeable Na⁺ content of bauxite residue were reduced following PG treatment; average particle sizes in aggregates following CK and PG treatments were determined to be 155 and 193 nm, respectively. SR-μCT test results also confirmed that bauxite residue following PG treatment acquired larger aggregates and larger pore diameter. These results indicate that the PG treatment could significantly modulate the saline-alkalinity, and simultaneously enhance aggregate stability of bauxite residue, which provides a facile approach to reclaim bauxite residue disposal areas.     

碳酸性侵蚀与AAR作用下纳米混凝土的耐久性

地铁混凝土处于地下空间,容易受到地下水的碳酸性侵蚀；碱集料反应 (AAR)是一种严重的混凝土耐久性问题,既难以发现又难以修补,由两者共同作用引起的混凝土耐久性降低严重影响地铁隧道的正常使用.为研究纳米材料对地铁混凝土在碳酸性侵蚀和AAR共同作用下耐久性的影响,在普通混凝土中掺入适量纳米SiO₂和纳米Fe₂O₃,利用自行研制的碳酸性侵蚀试验箱进行试验,采用碳酸性侵蚀深度、膨胀率和声速作为测试指标来评价纳米混凝土在碳酸性侵蚀和AAR共同作用下的耐久性.试验结果表明:掺入纳米颗粒后,混凝土的膨胀率和侵蚀深度有了明显降低,而声速有了明显提升,说明纳米混凝土的耐久性优于普通混凝土；在182 d龄期时,掺量为2%的纳米SiO₂混凝土耐久性改善最明显,侵蚀深度和膨胀率最小,声速最大且声速下降幅度最小；其次是掺量为1%的纳米Fe₂O₃混凝土.由于纳米颗粒特殊的物理化学性质,改善了混凝土内部的微观结构和孔溶液的化学组成,使碳酸性侵蚀和碱集料反应共同作用下混凝土的耐久性得到了提高.     

基于RSM-BBD的废石-风砂胶结体配合比与强度试验研究

充填料浆配合比的选择直接决定了充填体的强度及运行成本。根据两种骨料混合堆积密实度试验,得到废石风砂最优配比。利用Design-Expert软件中的Box-Behnken中心组合试验设计及响应面法(RSM)研究了料浆质量分数、水泥用量和骨料配比对充填体不同龄期内无侧限抗压强度的影响规律,建立了以粗骨料胶结体3,7,28 d强度为响应值的三元二次回归模型,并对该模型的适用性进行了验证。试验结果表明,充填体强度不仅受单一因素影响,而且两因素之间的交互作用对强度影响显著。由模型的响应曲面可知,质量分数与骨料配比的交互作用对充填体早期强度影响显著,水泥用量与骨料配比的交互作用对充填体中期强度影响显著,质量分数与水泥用量的交互作用对充填体后期强度显著。通过回归模型及建立的充填材料成本函数,优选出一组料浆配合比,经现场试验满足生产要求。     

钢渣复合取代矿粉、砂和石用作混凝土掺合料与骨料及其性能分析

用风淬渣粉取代矿粉、电炉渣砂取代混合砂、电炉渣石取代碎石制备混凝土，分析了混凝土的内照射指数、外照射指数、f-CaO含量、沸煮膨胀值、比表面积、密度、含水率、容重、含泥量、泥块含量、坍落度、抗压强度及其化学组成、矿物组成与微观形貌，研究了钢渣的安全性与稳定性及风淬渣粉取代矿粉、电炉渣砂取代混合砂、电炉渣石取代碎石与钢渣复合取代矿粉、砂和石对混凝土性能的影响。结果表明，风淬渣粉、电炉渣砂和电炉渣石的安全性与稳定性满足国标要求，可用于混凝土。当风淬渣粉取代20wt%矿粉、电炉渣砂取代10wt%混合砂和电炉渣石取代20wt%碎石时，混凝土的性能最优。钢渣复合取代矿粉、砂和石的比例合适，可改善混凝土的界面结构密实度，尤其能提高混凝土养护后期的强度。     

某选矿厂处理粗粒磁铁矿精矿经济分析

肃北县酒钢某磁铁矿选矿厂长期处于停产状态,为充分利用其现有资产,对途经该厂的酒钢外购粗粒磁铁精矿进行再磨再选,并进行了技术经济分析。通过分析表明,利用该选厂对粗精矿进行精选加工,精选后精矿中SiO₂含量降低约5个百分点,粒度更有利于后续的烧结作业,技术上可行,经济上有利。     

Investigating the wicking behavior of micro/nanofibrous core-sheath PET–PAN yarn modified by dimethyl 5-sodium sulfoisophthalate

The present research aims at imparting an improved wicking ability to the recycled multifilament yarns by wrapping composite nanofibers to attain an efficient material for filtration purposes. Therefore, polyacrylonitrile nanofibers containing dimethyl 5-sodium sulfoisophthalate nanoparticles were wrapped around the recycled poly(ethylene terephthalate) yarn by means of a novel electrospinning technique. Several tests were performed to investigate the parameters affecting wicking rise and moisture regain of the samples. Taguchi method was used in two separate designs (with or without nanoparticles). Some factors such as polymer solution concentration, mass ratio of nanoparticles, take-up rate, and number of filaments were considered as the variable factors while yarn wicking rate and moisture regain were the response factors. It was found that the hydrophilic nature of nanoparticles together with the ultrafine structure of nanofibers provide yarns with enhanced wicking properties. Although solution concentration is the predominant factor in wicking rate of the yarns containing nanoparticles, the most effective factor in wicking rise and moisture regain for other cases is the number of filaments. The mechanism of nanoparticle effect on fluidic jet during electrospinning process is explained by theory of nanofluids stability which has never been validated experimentally in previous research studies. © 2019 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019 , 136, 48185.     

The effect of atmospheric plasma treatment of recycled carbon fiber at different plasma powers on recycled carbon fiber and its polypropylene composites

To increase the mechanical properties of recycled carbon fiber-reinforced polypropylene (PP) composites, recycled carbon fibers (RCF) were subjected to atmospheric plasma treatment at different plasma powers (100, 200, and 300 W). The changes on surface topography and roughness of RCF were examined by atomic force microscopy. Plasma treatment of RCF increased the roughness value of RCF. The variation of surface elemental compositions and tensile strength of RCF were determined by using X-ray photoelectron spectroscopy and tensile test, respectively. Plasma-treated RCF-reinforced PP composites were fabricated using high speed thermo-kinetic mixer. Plasma treatment of RCF at 100 W increased the tensile and flexural strength values of RCF-reinforced PP composites considerably by 17 and 11%, respectively. However, plasma treatment of RCF at higher plasma powers (200 W and 300 W) decreased tensile and flexural strength values of composites because of the etching of RCF. © 2018 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2019 , 136, 47131.     

Mechanical and microstructural analysis of geopolymer composites based on metakaolin and recycled silica

This paper evaluated mechanical and thermal stability of alkali-activated materials obtained from metakaolin and alternative silica sources, such as rice husk ash (RHA) and silica fume (SF), and were reinforced with recycled ceramic particles (RP) obtained by grinding bricks. Specimens were produced, and after 7 days of curing, they were exposed to temperatures between 300 and 1200°C to determine the influence that different percentages of RP had on the mechanical behavior and microstructure of the produced composites. The results showed a reduction in the linear contraction by 10.22% with 20 wt% RP and that the reinforcing materials improved the mechanical performance of the geopolymers after exposure to high temperatures; the compressive strengths reached 137.7 (±11.4)  MPa after being exposed to 1200°C for the matrix based on RHA and 180.6 (±19.15) MPa after being reinforced with 20 wt% RP. The improvement was mainly due to densification and the formation of crystalline products such as leucite, kalsilite, and mullite.     

混菌矿化增强再生粗骨料的物理力学性能

为克服单一微生物培养成本高且矿化鲁棒性不足的缺陷，提出了一种混菌矿化增强再生粗骨料物理力学性能的方法.通过筛选矿化效率较高的好氧嗜碱混菌，考察了混菌矿化对再生粗骨料物理力学性能和混凝土抗压强度的影响.结果表明：相同增强时间下，混菌比纯菌呈现出更优异的矿化增强效果；随着混菌矿化增强时间的延长，再生粗骨料吸水率和压碎指标呈现出先减小后增大的趋势，最优增强时间为15 d；采用矿化增强再生粗骨料制备的再生混凝土抗压强度提高幅度达到22.1%.     

Extraction of protein from food waste: An overview of current status and opportunities

The chief intent of this review is to explain the different extraction techniques and efficiencies for the recovery of protein from food waste (FW) sources. Although FW is not a new concept, increasing concerns about chronic hunger, nutritional deficiency, food security, and sustainability have intensified attention on alternative and sustainable sources of protein for food and feed. Initiatives to extract and utilize protein from FW on a commercial scale have been undertaken, mainly in the developed countries, but they remain largely underutilized and generally suited for low-quality products. The current analysis reveals the extraction of protein from FW is a many-sided (complex) issue, and that identifies for a stronger and extensive integration of diverse extraction perspectives, focusing on nutritional quality, yield, and functionality of the isolated protein as a valued recycled ingredient.