嵌入式RISC核MPEG2/AC3解码器

介绍了在一个嵌入RISC核的AC3／MPEG2音／视频解码器中，通过增加特殊指令及其相应的硬件逻辑，对AC3的音频解码进行了一定的改进，不仅达到了AC3解码的实时性要求，而且降低了对存储器的要求。     

用软件实现曼彻斯特编译码方法的研究

介绍了在测井仪器中如何用单片机软件编程将井下仪测试数据实现曼彻斯特编码、发送传输 ,及地面解码等方法 ;阐述了井下仪实现双极性曼彻斯特码差分化的技术原理 ,地面译码时同步识别、数据采集、数据串 /并转换等技术方法 ,以及该方法在实践中应用情况。实际应用表明 ,该技术传 /收数据稳定可靠 ,智能化程度高 ,大大地简化了仪器硬件电路 ,提高了仪器性能价格比 ,在生产测井领域具有良好的推广应用前景。     

Sequential Decoding of Convolutional Codes for Rayleigh Fading Channels

The performance of sequential decoding of long constraint length convolutional codes is evaluated for Rayleigh fading channels. Sequential decoding is not practical below a certain theoretical signal-to-noise ratio, and these theoretical limits are calculated for a number of modulation methods and code rates. As an example, with BPSK modulation, soft decisions and code rate 1/2, the theoretical signal-to-noise ratio per information bit is 5.7 dB. Above this limit the bit error rate can be made arbitrarily small by increasing the constraint length at no significant complexity cost. Furthermore, it is shown that with carefully chosen quantization steps, 8 level uniform quantization gives a negligible loss also for sequential decoding on a Rayleigh fading channel. Simulation results using 8 level quantization correspond well with the theoretical performance bounds. Also, the performance on a correlated channel with finite interleaving has been obtained. With an interleaver depth of 50×50 and a normalized doppler frequency equal to 0.01 we are only 0.5 dB away from the performance with perfect interleaving. Finally, bit error rate results show this scheme to compete well with Turbo codes.     

MC-CDMA系统迭代检测中的一种信道估计算法

在DS—CDMA系统中，联合译码的迭代多用户检测是克服多址干扰增加系统容量的有效方法。本文将多用户检测和译码相结合的迭代检测技术应用于MC—CDMA系统，其中，多用户检测器由串行干扰消除和其后的MMSE滤波器组成。文中提出一种时域信道估计作为迭代初始值的频域信道估计算法，比单纯的频域信道估计方法节约导频符号数量，并且由于信道估计性能的改善，加快了迭代检测的收敛速度。     

一种改善Turbo乘积编码OFDM系统性能的新方法

本文提出一种利用对译码器软信息限幅来改善多径衰落信道中Turbo乘积编码OFDM(TPC-OFDM)系统性能的新方法。通过对不同多径衰落信道中QPSK映射和16QAM映射的TPC-OFDM系统性能的数值仿真，结果表明在10^-5误比特率下，这种新方法比传统的迭代译码大约有6～10dB的改进，对严重多径环境下TPC-OFDM系统的错误平底也有明显的改进。     

Turbo码概率-代数联合解码算法

Turbo码采用修正的BAHL et al.算法实现解码.这是一种基于软值的概率迭代解码算法.本文在保持Turbo码迭代软解码算法优点的基础上,充分利用Turbo码编码器结构这一确知条件,结合代数解码原理,提出了一种Turbo码概率-代数联合解码算法.该算法结合了概率解码和代数解码的优点,又有效避免了误差传播的发生,使Turbo码的纠错性能在原经典算法的基础上得到进一步的提高.该算法不仅为降低Turbo码的比特误码率和误差地板值提供了一种新的研究途径,而且因其更好的纠错性能而具有十分明显的实用价值.仿真实验结果显示,在比特误码率(BER)为10^-3~10^-4时,与经典Turbo码解码算法相比,采用该算法能获得0.1dB左右的编码增益.     

PERFORMANCE OF THREE STAGE TURBO－EQUALIZATION－DECODING

An increasing demand for high data rate transmission and protection over bandlimited channels with severe inter-symbol interference has resulted in a flurry of activity to improve channel equalization. In conjunction with equalization, channel coding-decoding can be employed to improve system performance. In this letter, the performance of the three stageturbo-equalization-decoding employing log maximum a posteriori probability is experimentally evaluated by a fading simulator. The BER is evaluated using various information sequence and interleaver sizes taking into account that the communication medium is a noisy inter symbol interference channel.     

线性分组码的神经网络译码

介绍了神经网络与线性分组码之间的关系，并在文献[1]的基础上证明了软判决译码与求解能量函数最大值之间的等价性，然后以(7，4，3)汉明码为例介绍了神经网络在循环码硬判决、软判决译码中的应用。     

DSP-based digital FM demodulation for GMSK signals

Demodulation of Gaussian Minimum Shift Keying (GMSK) using a limiter-discriminator is a low complexity alternative to coherent demodulation. This so-called digital FM demodulation is followed by clock recovery, sampling, and thresholding. Conventionally, clock recovery is done in hardware, and matched filtering is usually not possible when the Gaussian pulse is wider than a bit duration. We propose a clock recovery technique based on discrete-time processing of the demodulated baseband signal. This technique couples very nicely with a new maximum likelihood sequence estimator for the data that uses a whitening filter followed by a Viterbi decoder. The entire detection algorithm can be implemented in an efficient manner on a Digital Signal Processor (DSP). Computer simulation results are presented to show that the new algorithm performs better than the conventional slicer by as much as 5.5 dB.     

一种数字解码卫星电视接收机的原理分析

分析了一种数字解码卫星电视接收机，该机能接收利用ＭＰＥＧ－２进行数据压缩，采用ＳＣＰＣ或ＭＣＰＣ方式上星的卫星电视信号，具有选单显示，断电现场保护等功能。并对该机进行了原理分析，对主要集成电路的基本原理也作了简介，并给出了软件的部分主要流程及功能分析。