Coil‐Type Asymmetric Supercapacitor Electrical Cables

Cable‐shaped supercapacitors (SCs) have recently aroused significant attention due to their attractive properties such as small size, lightweight, and bendability. Current cable‐shaped SCs have symmetric device configuration. However, if an asymmetric design is used in cable‐shaped supercapacitors, they would become more attractive due to broader cell operation voltages, which results in higher energy densities. Here, a novel coil‐type asymmetric supercapacitor electrical cable (CASEC) is reported with enhanced cell operation voltage and extraordinary mechanical‐electrochemical stability. The CASECs show excellent charge–discharge profiles, extraordinary rate capability (95.4%), high energy density (0.85 mWh cm⁻³), remarkable flexibility and bendability, and superior bending cycle stability (≈93.0% after 4000 cycles at different bending states). In addition, the CASECs not only exhibit the capability to store energy but also to transmit electricity simultaneously and independently. The integrated electrical conduction and storage capability of CASECS offer many potential applications in solar energy storage and electronic gadgets.     

Quality and Emulsion Stability of Milk from Ettawah Crossed Bred Goat During Frozen Storage

Goat milk has specific chemical composition and physical properties. The purpose of this study was to investigate the change of milk quality and emulsion stability during 60 d frozen storage. Milk sample was taken from three Ettawah Crossedbred goats that were divided into three groups. Samples were frozen and stored for 0, 30 and 60 days. At the end of each storage periode, milk sample was thawed in the refrigerator and analyzed for total number of bacteria, chemical (acidity, pH, free fatty acids), physical (alcohol test, clot on boiling test) quality, and emulsion stability. The microbiological and chemical data were analyzed statistically using one way ANOVA, whereas physical quality and emulsion stabilty were expressed qualitatively. There were no change in the total bacteria, acidity, pH and free fatty acid (FFA) of milk during storage, whereas the assessment by 70% alcohol showed positive since 0 d. Emulsions stability changed after 30 d of storage. While, the clot on boiling (COB) test of milk was positive at 60 d of storage. Recommendation is frozen storage of goat milk should not longer than 30 d.     

Development of New Product: Rambutan Pulpy Juice

This study aimed to know the effect of adding pulp in rambutan fruit juice on the characteristics of rambutan juice during storage. Research using the CRD, the treatment were kind of pulp (mandarin and rambutan) and pulp concentration (5%, 7.5%, and 10%). The results showed that the addition of pulp significantly affect the characteristics of rambutan juice (pH, vitamin C, total acid) during storage. Pulpy juice with the most prefered was addition of rambutan pulp as much as 7.5% (w/v) and the addition of citrus pulp as much as 7.5% (w/v) with the score of 3-4 (moderate like - like).     

Effect of stoichiometry and Cu-substitution on the phase structure and hydrogen storage properties of Ml-Mg-Ni-based alloys

To improve the electrochemical properties of rare-earth–Mg–Ni-based hydrogen storage alloys, the effects of stoichiometry and Cu-substitution on the phase structure and thermodynamic properties of the ...     

Changes in the physical properties of honey powder during storage

Honey powders produced by spray drying with the addition of Arabic gum and sodium caseinate were characterised in terms of the influence of storage time on the following physical properties: particle size, moisture content, water activity, bulk density, flowability and hygroscopicity. The storage affected those properties; after 12 weeks of storage, particle size decreased (except Arabic gum powder treated as a control sample), moisture content and water activity increased, hygroscopicity decreased. Changes in bulk density, particle size and moisture content caused the rise of Hausner ratio value; however, the powders were still characterised by a very good flow properties and low cohesiveness. The colour of reconstituted powders was also affected by storage; in most of samples, the darkening, reduction in redness and yellowness were observed. Colour parameters were the most stable in powders obtained with the addition of 2% w/w of sodium caseinate.     

Iron mediated cathodic electrosynthesis of hausmannite nanoparticles

A novel synthetic route has been proposed to prepare hausmannite nanoparticles. The synthetic route comprises an iron mediated constant current cathodic electrodeposition of manganite and heat treatment of the latter to obtain hausmannite. The obtained nanostructures have been characterized using X-ray Diffraction (XRD), scanning electron microscopy (SEM), energy dispersive X-ray spectrometry (EDX) and Fourier transform Infrared Spectrometry (FTIR). The role of iron in the formation of manganite precursor has been studied by cyclic voltammetry (CV) and differential thermal analysis (DTA). A formation mechanism based on iron mediated formation of Mn³⁺ and subsequent cathodic reduction of the disproportionated products has been proposed accordingly. The prepared nanoparticles exhibited specific capacitance of 143 F g⁻¹ in 0.5 M Na₂SO₄ solution. The retained specific capacity was 87% after 2000 cycles.     

泌阳凹陷复杂断块群油气分布控制因素

泌阳凹陷北部斜坡复杂断块群油田以断鼻、断块及断层+岩性油气藏为主,垂向含油层系多,平面上叠合连片,油气主要富集在鼻状构造主体部位的断鼻断块内。通过对研究区油气控制因素的分析,指出继承性的鼻状构造控制了油气聚集方向和富集程度,油气藏含油范围和油气藏高度则主要受断层封闭性和封闭程度的控制,油气分布规律受伸展构造所伴生的各种断块群构造型式的控制。     

Effect of Stoichiometry on Properties of Rare-Earth-Based Hydrogen Storage Alloy for Nickel-Metal Hydride Secondary Battery

Effect of stoichiometry on microstructures, electrochemical properties and PCT characteristics of the alloys MI(Ni0.71Co0.15-Al0.06Mn0.08)x (MI=Lanthanum-rich Michmetal, x=4.6~5.2) have been investigated. The lattice constants a, c, and cellvolumes of non-stoichiometric alloys are bigger than those of the stoichiometric alloy. With the increasing stoichiometry x,the value of a decreases, and the value of c and cell volume increases except for those of the stoichiometric alloy; the plateaupressure of PCT curve, discharge capacity and cycling stability all increase. The alloy with x=5.2 shows the highest dischargecapacity and the best cycling stability among the studied alloys.