排序方式: 共有13条查询结果,搜索用时 15 毫秒
1.
不同取代度壳聚糖季铵盐的制备及其热稳定性研究 总被引:3,自引:0,他引:3
制备了不同取代度的壳聚糖季铵盐(羟丙基三甲基氯化铵壳聚糖),利用单因素实验分析了制备条件,采用热重分析探讨了壳聚糖季铵盐的热降解温度。结果表明,壳聚糖季铵盐的最佳制备条件为环氧丙基三甲基氯化铵(ETA)与壳聚糖的比为3,水与异丙醇的比为3,反应温度为80℃,反应体系的pH值为6.0。壳聚糖季铵盐与壳聚糖相比,热稳定性下降,随着壳聚糖季铵盐取代度的增加,初始降解温度(T0)、最大降解速率温度(Tp)和终止降解温度(Tf)均逐渐降低。同时,从初始降解温度到最大降解速率温度的时间也随着取代度的增加而减少。 相似文献
2.
Zinc oxide (ZnO) thin films were grown on n-GaN/sapphire substrates by radio-frequency (RF) magnetron sputtering. The films were grown at substrate temperatures ranging from 400 to 700 ℃ for 1 h at a RF power of 80 W in pure Ar gas ambient. The effect of the substrate temperature on the structural and optical properties of these films was investigated by X-ray diffraction (XRD), atomic force microscopy (AFM) and photoluminescence (PL) spectra. XRD results indicated that ZnO films exhibited wurtzite symmetry and c-axis orientation when grown epitaxially on n-GaN/sapphire. The best crystalline quality of the ZnO film is obtained at a growth temperature of 600 ℃. AFM results indicate that the growth mode and degree of epitaxy strongly depend on the substrate temperature. In PL measurement, the intensity of ultraviolet emission increased initially with the rise of the substrate temperature, and then decreased with the temperature. The highest UV intensity is obtained for the film grown at 600 ℃ with best crystallization. oindent 相似文献
3.
枸橼酸西地那非原料药合成过程中出现的新的未知杂质进行了提纯、结构表征及合成。将氯气通入5-(2-乙氧苯基)-1-甲基-3-丙基-1,6-二氢-7H-吡唑[4,3-d]嘧啶--酮的氯仿溶液中合成杂质-(-氯--乙氧苯基)-1-甲基-3-丙基-1,6-二氢-7H-吡唑[4,3-d]嘧啶-7-酮,并经过LS-MS、NMR、IR确证结构。此杂质未见报道,文献调研及实验研究发现该杂质是造成枸橼酸西地那非原料药纯度降低的主要因素之一,为确保药物安全有效,合成过程中严格控制该杂质的含量。本研究论文侧重于对该杂质形成机理及结构进行表征分析。 相似文献
4.
5.
6.
7.
8.
9.
本文对Co3+的电氧化合成以及用作氧化对甲砜基甲苯合成对甲砜基苯甲酸进行了系统研究。研究表明,选用阳极二氧化铅、阴极铅为电极板,陶瓷膜作为阳离子交换膜,电解液浓度为C(Co2+)=0.5mol/L、C(硫酸)=4.0mol/L、C(硫酸铵)=0.15mol/L,电极间距d=2cm、电流密度J=350A/m2、电解温度t=10℃,电解液Co2+转化率可达80%,电解氧化电流效率67.5%。在进行对甲砜基甲苯的氧化时,控制电解液浓度为C(Co3+)=0.4mol/L、C(硫酸)=4.0mol/L、C(硫酸铵)=0.15mol/L,Co3+与对甲砜基甲苯的摩尔比n(Co3+):n(对甲砜基甲苯)=6:1,反应温度30℃,反应时间30min,对甲砜基苯甲酸的收率可达97.8%,精制后纯度在98.5%以上。 相似文献
10.