Synthesis,thermal properties,conductivity and lifetime of proton conductors based on nanocrystalline cellulose surface-functionalized with triazole and imidazole

A new proton conductor based on 1H-1,2,3-triazole doped nanocrystalline cellulose (2.66 CNC-Tri) has been synthesized for possible use as an electrolyte in proton exchange membrane (PEM) cells. The physicochemical properties of 2.66 CNC-Tri were determined and compared with those of imidazole-doped nanocrystalline (1.17 CNC-Im) and pure nanocrystalline cellulose (CNC). The composites were obtained in the form of a film and their synthesis proceeded under vacuum. The maximum conductivity of 2.66 CNC-Tri was measured to be 0.1 × 10⁻⁴ S/m at 175 °C and that of 1.17 CNC-Im to be 1.6 × 10⁻² S/m at 155 °C, in the anhydrous state. The composite 2.66 CNC-Tri, compared to 1.17 CNC-Im, has much better thermal properties manifested as stability of the matrix and durability of the heterocyclic molecule. The lifetimes of 2.66 CNC-Tri fulfills the requirements of the U.S. Department of Energy for the minimum lifetimes of a PEM based fuel cell for cars.     

Sequential Functionalization of the O?H and C(sp2)?O Bonds of Tropolones by Alkynes and N‐Sulfonyl Azides

Sequential copper‐catalyzed [3+2] cycloaddition, rhodium‐catalyzed O H insertion, intramolecular 1,8‐addition, and rearrangement starting from 1‐alkynes, N‐sulfonyl azides, and tropolones is demonstrated for the synthesis of the 2‐functionalized aminotropones in one pot. These results indicate that sequential functionalization of O H and C(sp²) O bonds smoothly occurs in the C(sp²) O H bonds of tropolone

     

2-烷氨基-3-对氟苯基-5-甲基-6-(1H-1,2,4-三唑-1-基)-噻吩并[2,3-d]嘧啶-4(3H)-酮衍生物的合成及其杀菌活性

已见含氟类有机物具有杀菌能力的报道,将氟元素引入到噻吩并嘧啶酮的衍生物之中,考查其杀菌活性。通过Gewald反应生成噻吩,产物同PPh3、C2Cl6、Et3N作用得到膦亚胺,再用对氟苯基异氰酸酯与之作用得到碳二亚胺,之后与伯胺反应得到10种新的标题化合物,其结构经1HNMR、MS和元素分析表征。生物活性测试表明,此类衍生物对常见农作物部分菌体均表现出较大的抑制作用,其中以2-正庚氨基-3-对氟苯基-5-甲基-6-(1H-1,2,4-三唑-1-基)-噻吩并[2,3-d]嘧啶-4(3H)-酮活性最好,它对棉花枯萎菌的抑制率达90%。该系列物质相对不含氟元素的同种取代基的噻吩并嘧啶酮衍生物的杀菌活性有一定程度的提高。     

1,4-二取代-1,2,3-三氮唑的合成研究

以苄基氯(1a)、4-氯苄基氯(1b)、特戊酸氯甲酯(1c)为原料,通过叠氮取代和1,3-偶极环加成反应合成了三种含羟基的三氮唑衍生物1-苄基-4-羟甲基-1H-1,2,3-三氮唑(3a)、1-(4-氯-苄基)-4-羟甲基-1 H-1,2,3-三氮唑(3 b)、1-(特戊酸甲酯基)-4-羟甲基-1 H-1,2,3-三氮唑(3 c),实验应用FT-IR、1HNMR、13CNMR对产物的结构进行了表征,结果证实了合成路线的可行性,目标产物的收率分别为85.32%、90.26%、72.62%。     

Styrenated urethane oil synthesis via CuAAC “click” chemistry approach

In this study, a novel route for the modification of sunflower oil-based partial triglycerides with styrene (St) was described. For this purpose, in the first step, copolymers of St and 4-chloromethyl styrene (P(St-co-CMS)) were synthesized by free radical polymerization (FRP) and controlled/living radical polymerization (nitroxide mediated radical polymerization (NMRP)) methods. In the second step, chloro groups of these samples were transformed into azido groups by using NaN₃/DMF and then azido groups were coupled with propargyl alcohol to achieve hydroxyl functional polystyrene chain (PSt-OH) via Cu(I)-catalyzed 1,3-dipolar azide-alkyne cycloaddition (CuAAC) “click” chemistry approach. Finally, alcohol groups of PSt-OH and the partial glyceride (PG) were combined by the reaction with toluene 2,4-diisocyanate (TDI). As a result, styrenated urethane oil (PG-TDI-PSt) was obtained as an oil-based binder. The structures were determined by FT-IR, ¹H NMR and GPC analyses, and film properties of the products were examined according to the related standards. (PG-TDI-PSt) gave good film properties, and therefore could be considered as an applicable oil-based binder.     

Positional‐Species Composition of Triacylglycerols from the Arils of Mature Euonymus Fruits

Positional‐species composition (PSC) of 1,2,3‐triacyl‐sn‐glycerols (TAG) from the arils of mature fruits of 13 species of Euonymus L. genus was established. The residues of six major fatty acids (FA), palmitic, stearic, hexadecenoic (H), octadecenoic (O), linoleic (L), and linolenic, were present in the TAG. PSC of TAG was determined by their partial lipase hydrolysis. By using hierarchical cluster and principal component analyses, it was definitely demonstrated that separate taxonomic units forming this genus were significantly distinguished as regards PSC of TAG. In particular, the Euonymus subgenus greatly exceeded the Kalonymus subgenus in both total content of L in TAG and in the rate of its incorporation into their mid‐position, while TAG of Kalonymus were marked by a prevalence of O‐TAG and sn‐2‐O isomers. Thus, these subgenera were significantly distinct in the rate of incorporation of O and L residues in the sn‐2 position of TAG molecules. Meanwhile, the TAG from the Euonymus section species were marked by an enhanced concentration of H and the incorporation of H in UUU TAG was much more active than in other TAG types. As for positional‐type composition of TAG, saturated FA were always virtually absent in the sn‐2 position of Euonymus aril TAG.     

5,5′-氧化偶氮双(4-硝基-1,2,3-三唑-1-)氧化呋咱的理论研究与性能预估

设计了一种新型富氮类高能量密度化合物5,5′-氧化偶氮双(4-硝基-1,2,3-三唑-1-)氧化呋咱,采用密度泛函理论的B3LYP方法,在6-31G**基组水平上得到该化合物全优化构型;在振动分析的基础上求得体系的振动频率I、R谱;通过键级分析得到热解引发键的键离解能(BDE);预估了该化合物密度、生成焓、爆速、爆压和爆热,并预测了撞击感度。结果表明,该化合物存在11个强吸收峰,校正后热解引发键的BDE为144.77 kJ/mol,热分解活化能为204.93 kJ/mol,稳定性较优;密度1.975 g/cm3、生成焓963.837 kJ/mol、爆速9 015 m/s(K-J)、9 337 m/s(VLW),爆压38.64 GPa(K-J)、50.60 GPa(VLW);撞击感度H50为16.89 cm,稍低于RDX(24 cm)和HMX(26 cm)。     

The influence of impurities on the acid-catalyzed reaction of glycerol with acetone

The acid-catalyzed reaction of glycerol with acetone was studied in the presence of impurities that might be present in the crude glycerin of biodiesel production. These are mainly methanol, water and sodium chloride, in different amounts. The results indicated that methanol has minor effect on the glycerol conversion, whereas the concomitant addition of water and sodium chloride produces a drastic decrease of the conversion. The nature of the acid catalyst also affects the conversion in the presence of impurities. Amberlyst-15™ acid resin is more sensible to the water content than zeolite Beta. The results of the glycerol adulteration with different contaminants were compared with the reaction using a crude glycerin from a Brazilian biodiesel industrial plant.     

Preparation of π-conjugated polymers consisting of 1-aminopyrrole and 4-amino-1,2,4-triazole units

π-Conjugated polymers based on 1-aminopyrrole and 4-amino-1,2,4-triazole were prepared. Pd-catalyzed organometallic polycondensation gave poly(arylene-ethynylene) (PAE)-type π-conjugated polymers consisting of BOC-protected 4-amino-1,2,4-triazole (Taz(BOC)) units (BOC = t-butoxycarbonyl). The number average molecular weights (M_n) were determined to be 5200–19,200 using GPC. An alternating copolymer of Taz(BOC) and bithiophene (Th–Th) units, P(Taz(BOC)-Th-Th)_n-Pd, with an M_n of 10,800 was also prepared by Pd-catalyzed organometallic polycondensation. (Taz(BOC)-Th-Th)_n-Pd showed a UV–Vis absorption peak at λ_max = 425 nm, which is reasonable for a π-conjugated five-membered ring polymer with a coplanar structure. The deprotection of the BOC group of the polymers proceeded at 200 °C; this BOC-deprotection was investigated using a model compound. The optical and electrochemical properties of the π-conjugated polymers are reported.     

Chemical modification of chloromethylated polysulfones via click reactions

A new approach to the modification of azidomethyl polyethersulfones using click reactions with acetylenic derivatives in the presence of CuBr as catalyst is presented. An azidomethyl polyethersulfone was prepared by the reaction of chloromethylated polysulfone with sodium azide in dimethylformamide. By the Cu(I)‐catalysed Huisgen 1,3‐dipolar cycloaddition reaction of the azidomethyl polyethersulfone to acetylenic derivatives, new polyethersulfones containing 1,2,3‐triazole rings were obtained. The structures of the polymers were confirmed using attenuated total reflectance Fourier transform infrared and NMR spectroscopy. The polymers were characterized using dynamic mechanical analysis, thermogravimetric analysis, stress‐strain and water contact angle measurements and solubility tests. The polymers bearing 1,2,3‐triazole rings having OH or COOH as substituents exhibited static contact angles smaller than that of the parent polyethersulfone. Copyright © 2010 Society of Chemical Industry