Fabrication and properties of the superhydrophobic ceria-based composite coating on magnesium alloy

A superhydrophobic ceria-based composite coating is developed to improve anticorrosion properties of AZ61 magnesium alloy, fabricating via chemical conversion method followed by hydrothermal treatment. The cerium conversion coating has a block structure with microcracks. After the hydrothermal treatment, a dense CeO₂ layer, porous CeO₂ nanorods, and stearic absorbing layers are grown stepwise on the conversion coating. And the composite coating is hydrophobic or even superhydrophobic and has almost no microcracks. As the hydrothermal reaction time increases, the water contact angle of the composite coating first increases and then decreases, and it reaches the maximum value of 152° after hydrothermal treatment for 4 h. Both the dense CeO₂ layer and the superhydrophobic stearic absorbing layer can effectively prevent the electrolyte from contacting the substrate; the corrosion current density of the superhydrophobic composite coating is lower than that of the hydrophilic composite coating and the cerium conversion coating, and has the best corrosion resistance.     

涪陵地区茅三段热液白云岩展布影响因素分析

针对热液白云岩展布非均质性强的问题,开展基底断裂与茅三段沉积演化关系研究,分析断裂样式与白云岩分布关系,建立沉积演化模式,预测白云岩的分布。研究结果表明:茅三段可划分为5个小层,1~3小层为白云岩发育主要时期,4~5小层为台地均一化时期,不发育白云岩;15-1、15-2和16号基底断裂控制了早期“台-洼”相间的沉积地貌,断裂附近的地貌高部位为生屑滩发育有利部位,为白云岩的发育提供物质基础;15-1、15-2号基底断裂样式为花状,周边生屑滩白云石化程度高,为白云岩发育最有利区;16号基底断裂为直立状,附近白云石化发育程度较低,为白云岩发育较有利区。研究成果可为热液白云岩领域的进一步勘探提供指导依据。     

紫金山东南矿段成矿期次、阶段浅析

通过对紫金山东南矿段铜钼(金)矿床地质矿化特征分析,指出铜钼矿化带主要赋存于花岗闪长斑岩的内外接触带,处于似斑状花岗闪长斑岩的上部,金矿化带赋存在表生氧化带的英安玢岩、隐爆角砾岩中。经过对矿石的组构特征、矿物生成顺序等特征分析,将矿床的成矿演化过程分为斑岩热液期、高硫化浅成低温热液期、表生氧化期三个主要矿化期次,进一步将斑岩热液期分为黑云母-钾长石化阶段、石英-绢云母化阶段、碳酸盐化阶段三个阶段;高硫化浅成低温热液期分为地开石化阶段、明矾石化阶段、硅化阶段三个阶段。研究结果为进一步研究矿床成因提供了依据。     

五彩湾煤半焦水热脱钠提质及其燃烧特性的演变

利用电感耦合等离子体原子发射光谱仪(ICP-AES)分析新疆五彩湾原煤及其热解提质半焦中钠的赋存形式，考察了水热脱钠前后半焦的钠含量，采用热重分析仪和Flynn-Wall-Ozawa(FWO)方法建立五彩湾煤焦燃烧反应动力学模型，获得半焦燃烧动力学参数并分析脱钠对半焦燃烧特性的影响。结果表明:五彩湾原煤及其半焦中钠的赋存形式以水溶性钠为主，半焦总脱钠率高于原煤，水溶性钠的存在不利于半焦燃烧。600 ℃热解半焦的水热脱钠率高达82.59%，在所有实验焦样中，经水热脱钠后的半焦燃烧特性指数最高，燃烧活性最好。     

Synthesis of ZSM‐5 by hydrothermal method with pre‐mixing in a stirred‐tank reactor

This work proposed a synthesis route of ZSM‐5 via the hydrothermal method with premixing in a stirred tank reactor (STR). Effects of various operating conditions, including pre‐mixing time, molar ratio of SiO₂/Al₂O₃, TPAOH (organic template agents) concentration, NaCl (alkali metal cations) concentration, crystallization temperature, and crystallization reaction time, on the average particle size (PS) and particle size distribution (PSD) were investigated. It was found that the pre‐mixing time in the STR significantly affect the formation of proto‐nuclei in premixing process and crystal growth in hydrothermal reaction process, and consequently influence the PS and PSD of the prepared ZSM‐5. ZSM‐5 with good thermal stability, a PS of 380 nm, PSD of 0.17–0.9 µm, pore diameter of 2.31 nm, pore volume of 0.19 cm³ · g^?1 and specific surface area of 337.25 m² · g^?1 were obtained under the optimal conditions of a crystallization reaction time of 24 h, a crystallization temperature of 130 °C, a molar ratio of SiO₂/Al₂O₃ of 200, a TPAOH concentration of 3.5 mol · L^?1, NaCl concentration of 0.3 mol · L^?1, and a pre‐mixing time of 5 h. This work indicated that the operating conditions including premixing time have a significant effect on its PS and PSD.     

LF精炼废渣水热浸出过程中主要矿相的溶解行为

通过水热浸出实验分别研究了精炼废渣及合成的废渣中2种主要单一矿相12CaO?7Al2O3和2CaO?SiO2的溶解行为，并将二者进行对比分析，探究了LF精炼废渣在水热浸出过程中的溶解行为。结果表明，废渣浸出过程中浸出液的pH?12，且随浸出时间增加，电导率和Ca浓度增加，Al浓度急剧下降，Si浓度低于0.1 mg/L且保持不变；12CaO?7Al2O3浸出过程中，随时间增加，浸出液pH值稳定在约11.3，浸出液中Al浓度增加，Ca浓度略微下降。2CaO?SiO2浸出液中主要为Ca2+，Si浓度低于0.6 mg/L；废渣与单一矿相浸出过程的pH值及Al, Si浓度较接近，可以通过单一矿相的溶解行为研究精炼废渣在水热浸出过程中的溶解行为，但废渣浸出液的Al和Si浓度均低于单一矿相，表明废渣中CaO等其它组分溶解抑制了12CaO?7Al2O3和2CaO?SiO2溶解。     

Conversion of aqueous extracts from thermochemical treatment of bagasse into functional emulsifiers

Synthetic emulsifiers in food industries are being replaced with a customer-friendly food ingredient that is derived from biomass using sustainable green technologies. After hydrothermal liquefaction treatment, raw bagasse (21%), pith (26%), and rind portions (25%) were obtained with reduced ash contents. As aqueous extracts, with oligosaccharides and lignin residues, it was used in the preparation of oil-in-water emulsions with 5% soybean oil. Results showed that the emulsions stabilised the oil droplets with particle size between 11 and 17 µm by steric repulsion with raw bagasse-stabilised emulsion showing a better stability at 25 °C (31 days). It was demonstrated that raw bagasse extracts, without alteration, maybe a potential unconventional source for food-grade emulsifiers by integrating a versatile thermochemical conversion of waste without the use of chemicals.     

Couple-based particle swarm optimization for short-term hydrothermal scheduling

A novel couple-based particle swarm optimization (CPSO) is presented in this paper, and applied to solve the short-term hydrothermal scheduling (STHS) problem. In CPSO, three improvements are proposed compared to the canonical particle swarm optimization, aimed at overcoming the premature convergence problem. Dynamic particle couples, a unique sub-group structure in maintaining population diversity, is adopted as the population topology, in which every two particles compose a particle couple randomly in each iteration. Based on this topology, an intersectional learning strategy using the partner learning information of last iteration is employed in every particle couple, which can automatically reveal useful history information and reduce the overly rapid evolution speed. Meanwhile, the coefficients of each particle in a particle couple are set as distinct so that the particle movement patterns can be described and controlled more precisely. In order to demonstrate the effectiveness of our proposed CPSO, the algorithm is firstly tested with four multimodal benchmark functions, and then applied to solve an engineering multimodal problem known as STHS, in which two typical test systems with four different cases are tested, and the results are compared with those of other evolutionary methods published in the literature.