Temperature- and frequency-dependent hysteresis scaling behaviour and phase transitions in a [001]c 0.73Pb(Mg1/3Nb2/3)O3-0.27PbTiO3 single crystal

The dielectric properties and bipolar polarization-electric field (P-E) and strain-electric field (S-E) dynamic hysteresis of a relaxor [001]_c 0.73Pb(Mg_1/3Nb_2/3)O₃-0.27PbTiO₃ (PMN-0.27PT) single crystal were investigated to reveal more details of the temperature-induced phase transitions. Different linear scaling relations for ferroelectric hysteresis area <A>, coercive field E_c, saturation polarization P_s and remnant polarization P_r versus temperature τ were measured in different temperature regions. For each measurement frequency f, all hysteresis parameters were found to decrease linearly with temperature in the temperature range of the single rhombohedral (R) phase or tetragonal (T) phase, and the rate of decrease in the T phase was observed to be much larger than the corresponding rate in the R phase. In the temperature range near the R-T phase transition, the exponent α in the power law <A>∝f ^α for the R phase was found to be smaller than that for the T phase, and the magnitude of α depended strongly on temperature when the crystal was in the R-T coexisting phase state. Our experimental and theoretical results indicate that the difference in the activation energy and dipole moment in the R and T phases may lead to the observed discrepancy for the P-E and S-E hysteresis behaviour in different temperature regions.     

压电驱动器迟滞特性的Preisach模型研究

压电驱动器的迟滞特性是影响其位移输出精度的主要因素。该文采用改进的Preisach模型对压电驱动器的迟滞特性进行建模，并进行了相应的实验研究。实验结果表明该模型可以很好地预测压电驱动器在经过一定的控制电压序列以后的位移输出值．能够有效地降低迟滞特性对压电驱动器位移输出精度的影响。     

压电陶瓷微位移器件迟滞模型的研究

在通过统计物理学角度分析压电陶瓷迟滞规律的基础上，结合数学建模方法，提出了一种简单实用的压电陶瓷迟滞数学模型。并设计了压电陶瓷实验控制系统，对迟滞数学模型进行了验证，实验结果表明，此模型可以有效减小压电陶瓷的迟滞非线性误差，提高压电陶瓷微位移的控制精度，本研究有助于实现基于压电陶瓷的高精度开环微位移控制。     

Magnetic properties of nickel filament polymer-matrix composites

The magnetic properties of polyethersulfone-matrix composites with 3-19 vol.% polycrystalline nickel filaments (0.4 (im diam) were investigated. These filaments were found to exhibit hysteresis energy loss 10800 J/m³ of nickel and coercive force 16.9 kA/m, compared to corresponding values of 4930 J/m³ and 4.7 kA/m for 2 μ.m diam polycrystalline nickel fibers, 1020 J/m³ and 0.5 kA/m for 20 μm diam polycrystalline nickel fibers, and 1280 J/m³ and 2.3 kA/m for solid polycrystalline nickel.     

用ADT14设计的新型电子温控器

ADT14是一种可编程温度监控器电路，可广泛应用于各种控制系统中进行温度检测和控制。用ADT14设计的新型电子温控器具有结构简单，安装方便，温控准确等优点。     

高维滞环多值电路唯一稳态的研究

本文利用矩阵分解方法，在用常数界定元件成份关系斜率条件下，得到了确定高维具有滞环的非线性非自治电路唯一稳态的新条件。本文的结果表明，该类电路的唯一稳态，可以用分解矩阵的稳定性来决定，本文的结果中，电路元件可以是多值元件，这大大放松了目前已的经典结果中要求电路元件为单值的限制，扩展了已有的结果，同时，本文的结果，对于确定高维非线性非自治电路的唯一稳态，比已有结果，更加有力和简洁。     

Moisture sorption study on Nigerian foods: Kuka

Kuka is an important vegetable in the Nigerian food chain. The moisture sorption characteristics of the vegetable studied at 34, 37 and 45°C between a_w 0.10–0.96, revealed a BET type II behaviour. The Kuka exhibited hysteresis and an increase in EMC with increase in a_w and decrease in temperature. Four sorption models (Oswin, Halsey, Kuhn, and GAB) were studied and the Oswin model was the most suitable. The constants in the Oswin model and GAB monolayer moisture contents were obtained and found to be temperature-dependent. Heats of sorption were greater for desorption than adsorption and in either mode, they reduced with an increase in moisture content. An exponential equation was obtained to relate heat of sorption with moisture content.     

基于变轴力和定轴力试验对比的钢筋混凝土柱恢复力滞回特性研究

在讨论了框架柱在地震作用下轴力变化规律的基础上,通过由变轴力柱和定轴力柱的低周交变加载试验获得的恢复力滞回曲线对比,给出了用各个“轴力变化半周”的“等效滞回轴力”修正恢复力骨架曲线,和用“等效累积滞回轴力”随时间步长调整累积强度退化系数从而修正恢复力滞回曲线的再加载刚度的建议。该建议能更有效、更方便地反映轴力变化的整个历程对变轴力柱恢复特征的影响,有利于提高钢筋混凝土杆系结构非弹性地震反应分析的有效性。     

基于改进控制器的异步电动机直接转矩控制

通过分析转矩变化规律,研究不同电压矢量对转矩的变化所产生的影响,提出了改进的磁链和转矩的双层滞环方案。解决了传统直接转矩控制存在的低速转矩波动大的问题,方案简单、易于实现。仿真结果表明,采用该方案,能在不降低系统动态性能的情况下拓展系统的低速运行范围,降低转矩波动,提高电机的低速转矩。     

Factors Affecting the Squareness of Hysteresis Loops of Sintered NdFeB Magnets

Investigation into the magnets with different squareness of hysteresis loop (SHL) reveals that the microstructure of sintered NdFeB magnets has great effects on the SHL of the magnets. The abnormal grain growth deteriorates the SHL seriously. The shape of the grain and the grain boundary affect the intensity of demagnetization field, and consequently on the SHL. The added elements have effects on the phase structures and distributions in the magnets, which influences the uniform of demagnetization field.