Hygrothermal deformation of orthotropic nanoplates based on the state-space concept

This paper deals with the investigation of the effect of hygrothermal conditions on the bending of nanoplates using Levy type solution model employing the state-space concept. The nanoplates are assumed to be subjected to a hygrothermal environment. The two-unknown function plate theory is used to derive the governing differential equations on the basis of Eringen's nonlocal elasticity theory. The governing equations contain the small scale effect as well as hygrothermal and mechanical effects. These equations are converted into a set of first-order linear ordinary differential equations with constant coefficients. Analytical solution of bending response for nanoplates under combinations of simply supported, clamped and free boundary conditions is obtained. Comparison of the results with those being in the open literature is made. The influences played by small scale parameter, temperature rise, the degree of moisture concentration, boundary conditions, plate aspect ratio and side-to-thickness ratio are studied.     

Synthesis of amphiphilic magnetic microspheres by dispersion copolymerization of styrene and poly(ethylene oxide) macromonomer

Amphiphilic magnetic microspheres ranging in diameter from 5 to 100 µm were prepared by dispersion copolymerization of styrene and poly(ethylene oxide) vinylbenzyl (PEO‐VB) macromonomer (MPEO) in the presence of Fe₃O₄ magnetic fluid. The effects of various polymerization parameters on the average particle size were systematically investigated. The average particle size was found to increase with increasing styrene concentration and initiator concentration. It also increased with decreasing stabilizer concentration and molecular weight of MPEO. The content of the hydroxyl groups localized in the microspheres ranged from 0.01 to 0.2 mmol g^?1. © 2003 Society of Chemical Industry     

波动方程数值模拟的隐式差分法

在有限差分波动方程数值模拟中,通常采用高阶差分方法来提高空间导数的数值逼近精度,以实现降低数值频散,提高数值模拟精度的目的。首先对差分频散进行了理论分析;然后讨论了估计一阶空间导数的隐式差分格式,并与通常采用的高阶精度显式差分格式进行了对比分析,结果表明,隐式差分格式能够在更宽的波数范围使差分频散控制在可接受的水平,如8阶精度的显式差分格式所适应的波数带宽约为O．55kmax,而隐式差分格式所适应的波数带宽约为0．7kmax;最后通过模型试算,对隐式差分格式的有效性进行了验证。模拟结果表明,用隐式差分格式在一定程度上降低了差分频散,提高了模拟精度。     

非稳定井流模型的半解析解

为了提高非稳定渗流计算的计算精度 ,通过数学分析得到了水位传导系数随时间变化时 ,一类非稳定渗流井流模型的半解析解 ,并进行了计算比较     

求解二维结构-声耦合问题的一种直接方法

本文基于传递矩阵法(TMM)和虚拟边界元法(VBEM)，提出了一种求解在谐激励作用下二维结构-声耦合问题的直接法。文中对任意形状的二维弹性环建立了一阶非齐次运动微分方程组，便于用齐次扩容精细积分法求解，对于含有任意形状孔穴的无穷域流体介质的Helmholtz外问题，采用复数形式的Burton-Miller型组合层势法建立了虚拟边界元方程，保证了声压在全波数域内存在唯一解。根据叠加原理并结合最小二乘法，提出了一种耦合方程的直接解法，由于该方法不存在迭代过程，因而具有较高的计算精度和效率。文中给出了二个典型弹性环在集中谐激励力作用下声辐射算例，计算结果表明本文方法较通常采用的混合FE／BE法更为有效。     

Transport of a surface-applied corrosion inhibitor in cement paste and concrete

Surface-applied corrosion inhibitors are a kind of repair material and usually contain an aminoalcohol and a component forming a salt with the aminoalcohol. According to the manufacturers, this type of inhibitor penetrates very rapidly into concrete; however, the transport mechanisms have not been sufficiently investigated so far. The major part of the study therefore focused on the transport of the ingredients of an inhibitor in cement paste and concrete, which contained an aminoalcohol and a phosphorous compound. It has been shown that the latter forms an insoluble calcium salt in the environment of cement and precipitates quantitatively. It is thus unable to penetrate from the outside into the alkaline concrete zone and cannot develop its inhibiting effect there. The aminoalcohol, on the other hand, is not bound by cement, but remains largely dissolved in the pore liquid, thus providing optimal conditions for high mobility. The analysis of the transport mechanisms involved has revealed that diffusion in the dissolved state is by far the most efficient transport mechanism. While basically the transport of the aminoalcohol via the gaseous phase is possible, it does play an inferior role only. Surprisingly, the substance had hardly been absorbed by concrete by capillary suction, but at first remained close to the concrete surface.     

合成丁苯嵌段共聚物的影响因素

采用负离子溶液聚合方法制备了丁苯嵌段共聚物，研究了引发剂、活化剂、偶合剂、终止剂对聚合产物性能的影响。     

16×10.7 Gb/s 1 600 km普通单模光纤环路传输研究

利用双折射光纤环设计了可调功率均衡滤波器,实现了16路16×10.7 Gb/s NRZ码、超过1 600 km常规单模光纤(SMF)的系统传输及性能测试,信道误码率均小于3×10-5(FEC纠错前).数值仿真并实验研究了对单环长度240 km、损耗超过80 dB的环路16路10.7 Gb/s波分复用(WDM)系统传输的优化.传输7圈后,功率均衡器降低了信道功率不平坦度超过5 dBm.     

饼干炉湿度控制的改进方法

在大空间的温度控制系统中 ,采用简单的PID控制规律 ,对空间的温度、湿度进行解藕计算 ,将空间的相对湿度控制转化为送风含湿量的控制。该控制方式稳定、可靠 ,并且节约能源。本方法适用于所有的烘烤炉中     

Processing of Yttria-Alumina Coated Silicon Nitride Slips by Slip Casting

Si₃N₄powders coated with 6 wt% Y₂O₃and 4 wt% Al₂O₃were prepared by coprecipitation. The resulting powders were dispersed in water at different pH values and with addition of various amounts of ammonium polyacrylate (NH₄PA) to produce 32 vol% slips. The influence of the amount of NH₄PA solution added and pH on the rheological properties of 32 vol% coated Si₃N₄slips were studied. In addition, the sintered density of cast samples was determined and related to the degree of slip dispersion. The adsorption of the NH₄PA on the coated particle surface was rather high and the surface became saturated near 0.86 mg/m²at pH 9.2. High NH₄PA concentrations (1.7–3 wt%) were necessary to obtain well dispersed 32 vol% coated Si₃N₄slips at pH 9.2. The best stabilization was obtained with the addition of 2.3 wt% NH₄PA; in this condition, the viscosity reached a minimum value of 35 mPa.s at 100 s^–1. The slip viscosity increased with increasing pH from 9.2 to 10.2. Slips with low viscosities gave a more dense packing of cast samples and consequently higher sintered density values.