P(DBF-VA)型柴油低温流动性改进剂的研制

针对新疆地产柴油蜡含量较高的特点,以游离基聚合法合成了富马酸双链混合酯和醋酸乙烯酯共聚物型[P(DBF-VA)]柴油低温流动改进剂,利用正交实验研究了单体配比,引发剂用量,溶剂用量,聚合温度对聚合物降冷滤效果的影响。共聚物用IR进行表征,利用XRD初步探讨了该降凝剂的降凝机理。结果表明:该剂能使吐哈—10~#、0~#柴油冷滤点降低10℃和7℃;使独山子0~#柴油冷滤点下降12℃;使石化0~#柴油冷滤点下降8℃;使克拉玛依0~#柴油的冷滤点下降8℃。     

Valorisation of waste fractions from autohydrolysis of selected lignocellulosic materials

Non‐isothermal processing of lignocellulosic materials in aqueous media (autohydrolysis reaction) under mild conditions leads to solutions containing valuable chemicals (oligosaccharides, sugars and acetic acid) and other, undesired, compounds (belonging to the extractive and acid‐soluble lignin fractions) which have to be removed in further purification treatments. Liquors obtained by non‐isothermal autohydrolysis of Eucalyptus globulus wood and corncobs under a variety of operational conditions were extracted with ethyl acetate in order to remove non‐saccharide components, and the suitability of the fraction dissolved in the organic phase was assayed for possible utilisation as an antioxidant. The yield and antioxidant activity of ethyl acetate extracts (measured by the α,α‐diphenyl‐β‐picrylhydrazyl (DPPH) radical scavenging capacity) showed a strong dependence on the autohydrolysis conditions. The antioxidant activity of extracts obtained under selected operational conditions compared well with synthetic antioxidants. © 2003 Society of Chemical Industry     

由乙腈一步法制备乙酸丁酯的研究

以丁醇和制备丙烯腈的副产物乙腈为原料 ,采用一步法合成了乙酸丁酯。通过正交实验得到了影响反应的 4种因素。确定了最佳的工艺条件为 :催化剂的量为样品质量的 40 % ;n(CH3CN)∶ n(C4 H9OH) =1∶ 1 .0 5 ;反应温度为 1 0 5℃ ;反应时间为 8h。在此反应条件下 ,乙酸丁酯的收率为 88.8% ,纯度可达 99.5 %。并用气相色谱及红外光谱对产品的纯度进行了表征     

An attempt to compare the performance of bioscrubbers and biotrickling filters for degradation of ethyl acetate in gas streams

This study presents a comparison of the efficiency of a bioscrubber and a biotrickling filter (BTF) for the removal of ethyl acetate (EA) vapour from a waste gas stream, under the same operating conditions. The maximum EA elimination capacity achieved in the bioscrubber was 550 g m^?3 h^?1 with removal efficiency higher than 96%. For higher EA loadings the bioscrubber was oxygen limited, which caused incomplete EA biodegradation. When pure oxygen was fed to the bioscrubber at a rate of 0.02 L min^?1, the bioscrubber recovered and could treat higher EA loadings without any oxygen limitation. The BTF achieved EA elimination capacity of 600 g m^?3 h^?1 with removal efficiency higher than 97% and the dissolved oxygen concentration remained substantially higher than in the bioscrubber. However, severe channelling and blockage of the spray nozzle occurred due to the excessive biomass growth. Overall, the bioscrubber system was easier to operate and control than the BTF, while an enhancement of the oxygen mass transfer in the bioscrubber could potentially increase its performance by up to three times. Copyright © 2005 Society of Chemical Industry     

Mechanical and microstructure studies on the modification of CA film by blending with PS

DriedMusa paradiciaca (banana) stem and veins of the leaves, which were hitherto discarded as a waste, were collected and used as starting material for the preparation of cellulose and cellulose acetate. This cellulose acetate was mixed with polystyrene to form blend of cellulose acetate-polystyrene in order to provide enhanced stability and extended utility to the end products. The films of these composites or their individual partners were made separately and studied for their mechanical properties, chemical modification and morphological changes. We report here that banana stem is good source of cellulose and that cellulose completely undergoes modification upon esterification.     

反应精馏法制备高纯度醋酸甲酯

在中试反应精馏塔中以浓硫酸为催化剂进行了醋酸与甲醇反应制备醋酸甲酯的试验。反应精馏塔的精馏段为填料,反应段为立体催化精馏塔板,采用连续操作,考察了回流比、甲醇进料位置、停留时间、催化剂用量对反应精馏的影响。试验结果表明,当回流比为1.2、甲醇进料位置为第11～15块塔板、停留时间为2.2～2.5h、催化剂与醋酸的质量比为1.07∶100时,塔顶醋酸甲酯的质量分数达到99.50%以上,醋酸的转化率达到99.85%以上。     

磷铝杂原子固体酸催化剂催化合成乙酸异丙酯

以丙烯和乙酸为原料 ,自制的磷铝杂原子固体酸作催化剂催化合成了乙酸异丙酯 ,考察了反应温度、反应压力、反应空速 (LHSV)及催化剂用量对酯化反应的影响 ,同时考察了固体酸催化剂的重复使用性。确定了最佳合成条件 :反应压力 1 5MPa,反应温度 1 60℃ ,反应空速2 0h-1,催化剂用量 2 0g。在此条件下 ,酯化率可达 91 5 % ,乙酸异丙酯选择性达 99 0 % ,且催化剂的重复使用性良好。     

Vinyl acetate monomer—a pilot plant study

The kinetics of the reaction of acetic acid and acetylene over zinc acetate-activated carbon catalyst was investigated over a wide range of process variables in a pilot reactor. Although various catalytic reaction mechanisms were postulated, the rate of reaction was most satisfactorily correlated by a mechanism of surface reaction between charged adsorbed acetic acid and acetylene, which assumes that the rate controlling step was the irreversible charged adsorption of acetylene and acetic acid.     

醋酸铅在离子液体中溶解机理的研究

通过[bmim]Cl和Pb(OAc)2混合反应后析出PbCl2沉淀,制备得到溶解有醋酸铅的离子液体[bmim]OAc。实验发现,即使使用过量的醋酸铅,PbCl2仍然不能沉淀完全,这表明离子液体中的Pb2+离子并不是以游离形式存在的,而是以配位的形式存在,并且由离子液体包裹着。因此,醋酸铅在离子液体[bmim]OAc中的溶解度得到增加,平均溶解度达到1 1mmol/ml,最大溶解度达到3 0mmol/ml。     

Evaluation of a two-temperature control structure for a two-reactant/two-product type of reactive distillation column

Several different control structures have been proposed for reactive distillation columns. The appropriate control structure depends on the flowsheet and on the type of reactions occurring in the column. If two reactants are involved and if it is desirable to operate the process without any excess of reactant, it is necessary to manage the fresh feed streams so that the stoichiometry is exactly balanced. A composition analyzer that measures an internal composition in the column is often required. However, if two products are produced, it is possible to avoid the use of an analyzer by using two temperatures in the column to adjust the two feed streams. This type of structure was proposed by Roat et al. [Roat, S., Downs. J., Vogel, E., Doss, J., 1986. Integration of rigorous dynamic modeling and control system synthesis for distillation columns. In: Chemical Process Control—CPC III. Elsevier, Amsterdam.] for the ideal reaction A+B↔C+D in one of the earliest papers dealing with reactive distillation control.The purpose of this paper is to explore the effectiveness of this two-temperature control structure for various column designs (number of reactive stages) to quantify the impact of design on controllability. We also discuss the issues of the selection of the trays whose temperatures are to be controlled and the tuning of the two interacting temperature controllers. Disturbances in production rate and fresh feed compositions are made to examine the rangeability of this control structure. Both an ideal reaction system and the methyl acetate system are studied. One of the main conclusions is that the locations of the temperature control trays should be made such that the two temperature controllers both have direct action (an increase in temperature increases feed), which requires negative openloop process gains for both loops.