Red-shift and improved afterglow of Sr3Al2-xBxO5Cl2:Eu2+, Dy3+ phosphors via a cation substitution strategy

Sr₃Al_2-xB_xO₅Cl₂:Eu²⁺, Dy³⁺ (x = 0, 0.2, 0.4) long persistent phosphors were prepared via solid-state process. The pristine Sr₃Al₂O₅Cl₂:Eu²⁺, Dy³⁺ phosphor exhibits orange/red broad band emission around 609 nm, which can be attributed to the electric radiation transitions 4f⁶5 d¹→4f⁷ of Eu²⁺. Upon the same excitation, the B³⁺-doped Sr₃Al_2-xB_xO₅Cl₂:Eu²⁺, Dy³⁺ phosphors display red-shift from 609 nm to 625 nm with increasing B³⁺ concentrations. The XRD patterns show that Al³⁺ can be replaced by B³⁺ in the host lattice at the tetrahedral site, which causes lattice contraction and crystal field enhancement, and thereafter achieves the red-shift on the emission spectrum. The XPS investigation provides direct evidence of the dominant 2-valent europium in the phosphor, which can be ascribed for the broad band emission of the prepared phosphors. The afterglow of all phosphors show standard double exponential decay behavior, and the afterglow of Sr₃Al₂O₅Cl₂:Eu²⁺, Dy³⁺is rather weak, while the sample co-doped with B³⁺shows longer and stronger afterglow, as confirmed after the curve simulation. The analysis of thermally stimulated luminescence showed that, when B³⁺ is introduced, a much deeper trap is created, and the density of the electron trap is also significantly increased. As a result, B³⁺ ions caused redshift and enhanced afterglow for the Sr₃Al_2-xB_xO₅Cl₂:Eu²⁺, Dy³⁺ phosphor.     

A new composite of crystalline silicotitanate for sequestration of 137Cs and 90Sr from low-level aqueous waste solution

ABSTRACT

A new composite of crystalline silicotitanate (CST) has been synthesized for the sequestration of Cs and Sr from low-level liquid waste generated in the nuclear industry. The product characterization using X-RAY DEFRACTION (XRD) and Fourier-transform infrared spectroscopy (FTIR) confirmed the presence of CST crystals in the composite. Sorption studies carried out under various test conditions showed that the composite has high affinity for both Cs and Sr. Results of structural characterization of Cs and Sr-loaded CST indicated that the overall structural integrity remained intact after substitution of Na⁺ by Cs⁺ or Sr²⁺. The exceedingly good Cs and Sr sorption performance displayed by the CST composite will find applications in the treatment of nuclear waste.     

Microstructure,magnetic and optical properties of Nb3+ and Y3+ ions co-substituted Sr hexaferrites

Series of SrNb_xY_xFe_12-2xO₁₉ (0.00 ≤ x ≤ 0.05) hexaferrites (HFs) were fabricated via citrate sol-gel approach. Structural and magneto-optical properties of ensembles were investigated in detail. The structural and morphological analyses revealed the formation of M-type Sr hexaferrite nanoparticles. Diffuse reflectance data were registered to estimate the direct optical energy band gaps (E_g) in a range of 1.77 eV-1.87 eV. Room temperature (RT, 300 K) and low temperature (10 K) magnetic hysteresis curves were recorded by enforcing applied dc magnetic field up to ±70 kOe. Magnetic parameters were significantly tuned due to coordination of Nb³⁺ and Y³⁺ rare earth ions. Specified magnetic data reveal the strong ferromagnetic characteristics of pristine SrFe₁₂O₁₉ and co-doped HFs with Nb³⁺ and Y³⁺ ions at both temperatures. RT squareness ratio (SQR) has an exception only for pristine sample as 0.506, which is in the margin of theoretical limit assigning the single-domain nature with uniaxial anisotropy. However, all co-doped samples have SQR = 0.288–0.485 values that are smaller than theoretical limit of 0.50, implying multi-domain nature at RT and at 10 K. Co-doped ions cause lowering in super-exchange interactions between different sites and resulting the decrements of intrinsic magneto-crystalline anisotropy and coercivity fields. The specified magnetic characteristics make our fabricated SrNb_xY_xFe_12-2xO₁₉ (0.00 ≤ x ≤ 0.05) HFs good candidates as permanent magnets applications and high-density recording media.     

Significantly enhanced breakdown field in Ca1-xSrxCu3Ti4O12 ceramics by tailoring donor densities

Significantly enhanced breakdown field of 24.52 kV cm^?1 as well as noteworthy nonlinear coefficient of 8.11 and low dielectric loss of 0.077 were obtained in Ca_0.6Sr_0.4Cu₃Ti₄O₁₂ ceramic. It was proved from impedance spectra that improved breakdown field was attributed to enhanced grain boundary resistance and elevated Schottky barrier height, which was further found resulting from reduced donor densities in C-V measurements. In addition, it was found that the activation energy originated from oxygen vacancies was increased, indicating the generation of oxygen vacancies was suppressed. Since oxygen vacancies acted as donors in depletion layers, it is reasonable to deduce that the reduced donor density was mainly ascribed to the decreased oxygen vacancies. In conclusion, maximum integrated action of strong solid solution effect and weak Sr-stretching effect was achieved when Sr/Ca ratio is 40/60, leading to greatly elevated potential barrier height and enhanced breakdown field consequently.     

Me-TODGA与TODGA萃取锶性能对比

以N,N,N′,N′-四辛基-2-甲基-3-氧戊二酰胺(Me-TODGA)或N,N,N′,N′-四辛基-3-氧戊二酰胺(TODGA)为萃取剂、磷酸三丁酯(TBP)为相改良剂、煤油为稀释剂，对比研究了水相酸度、萃取剂浓度、锶浓度、温度对Me-TODGA-TBP体系和TODGA-TBP体系萃取Sr²⁺的影响，并采用斜率法确定了萃合物的组成。结果表明，2种酰胺荚醚萃取Sr²⁺的分配比(D_Sr)随HNO₃浓度(c(HNO₃)=0.1～2.7 mol/L)、萃取剂浓度(c(萃取剂)=0.05～0.3 mol/L)的增加而增大，随Sr²⁺浓度的升高略有下降，随温度的升高而下降。2种萃取剂的萃合物组成分别为Sr(NO₃)2•3Me-TODGA和Sr(NO₃)2•2TODGA。萃取反应的ΔH分别为-69.46 kJ/mol和-51.39 kJ/mol，ΔS分别为-190.5 J/(mol•K)和-128.4 J/(mol•K)，ΔG分别为-12.68 kJ/mol和-13.12 kJ/mol。相比之下，Me-TODGA萃取Sr²⁺的分配比不到TODGA的1/5。     

Microstructure and electrical conductivity of La0.9Sr0.1 Ga0.8Mg0.2O2.85-Ce0.8Gd0.2O1.9 composite electrolytes for SOFCs

(100-x) wt.% La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 - x wt.% Ce_0.8Gd_0.2O_1.9 (x = 0, 5, 10, 20) electrolytes were prepared by solid-state reaction. The composition, microstructure, and electrical conductivity of the samples were investigated. At 300 ~ 600°C, the pure La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 electrolyte has a higher conductivity compared to the composite electrolytes, but at 650 ~ 800°C the 95 wt.% La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 - 5 wt.% Ce_0.8Gd_0.2O_1.9 composite electrolyte presents the highest conductivity, reaching 0.035 S cm⁻¹ at 800°C. The cell performances based on La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85-Ce_0.8Gd_0.2O_1.9 electrolytes were measured using Sr₂CoMoO₆-La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 as anode and Sr₂Co_0.9Mn_0.1NbO₆ -La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 as cathode, respectively. At 800°C, the measured open-circuit voltages are higher than 1.08 V, and the maximum power density and current density of the fuel cell prepared with 95 wt.% La_0.9Sr_0.1 Ga_0.8Mg_0.2O_2.85 - 5 wt.% Ce_0.8Gd_0.2O_1.9 electrolyte reach 192 mW cm⁻² and 720 mA cm⁻², respectively.     

TiO_(2-x)N_x/Sr_2MgSi_2O_7:Eu~(2+),Dy~(3+)复合材料制备及光催化性能

采用溶胶-凝胶法将TiO2-x N x包覆在长余辉光致发光材料(Sr2MgSi2O7∶Eu2+,Dy3+)表面制备得到TiO2-x N x/Sr2MgSi2O7∶Eu2+,Dy3+复合材料。利用X-射线衍射(XRD)、扫描电子显微镜(SEM)对TiO2-x N x/Sr2MgSi2O7∶Eu2+,Dy3+复合光催化材料的结构及表面形貌进行表征,并研究了TiO2-x N x/Sr2MgSi2O7∶Eu2+,Dy3+复合光催化材料对甲基橙溶液的降解性能。     

Upconversion thermal enhancement of 2H11/2→4I15/2 of Er3+ and blue emission of impurity Tm3+ in Sr3(PO4)2:Er3+/Yb3+

A series of Sr_2.99-x(PO₄)₂:.01Er³⁺/xYb³⁺ (x = .02, .04, .06, .08, .10) phosphors in the presence of impurity Tm³⁺ were synthesized by high temperature solid-state method, and X-ray diffraction results show that these samples are pure R-3 m(166) space group phase. The upconversion luminescence (UCL) of Er³⁺ and impurity Tm³⁺ under 980-nm laser excitation were investigated, and the results show that the intense blue UCL of impurity Tm³⁺ and thermal enhancement of ²H_11/2→⁴I_15/2 of Er³⁺ simultaneously exist. When Er³⁺ doping concentration is kept at .01, both the blue UCL intensity of impurity Tm³⁺ and green and red UCL intensity of Er³⁺ reach the maximum at Yb³⁺ doping concentration of .08. The thermal enhancement effect of ²H_11/2→⁴I_15/2 of Er³⁺ was observed as high as 3.27 times from 303 to 723 K, which is because of lattice distortion and phonon-assisted transition. In addition, the optical temperature performance of Sr_2.91(PO₄)₂:.01Er³⁺/.08Yb³⁺ sample was studied, and the maximum absolute temperature sensitivity was calculated as .00623 K⁻¹ at 538 K. This study suggests that Sr₃(PO₄)₂:Er³⁺/Yb³⁺ phosphors in the presence of impurity Tm³⁺ have a promising application prospect as optical temperature sensor at high temperature.     

Sr对合成Al3Ti/ADC12复合材料微观组织与力学性能的影响

本文研究了不同含量的改性剂Sr对原位合成Al₃Ti/ADC12复合材料微观组织及力学性能的影响。通过光学显微镜以及扫描电镜观察复合材料的微观以及断口组织。实验结果表明：Sr的加入能有效减小α-Al以及Al₃Ti颗粒尺寸以及优化材料形态。Sr的最优加入量为0.25 wt%。在该加入量条件下,共晶硅由针状或短棒状变为颗粒状,α-A1粗枝晶得到较好的细化。实验结果也显示：Sr的加入有效提升了复合材料的机械性能。当加入0.25 wt% Sr时,抗拉强度以及延伸率相较于基体材料增加了36.9% 和 58%。断口形貌表明,在最优加入量条件下所制备的复合材料断口几乎看不到解理面和脆性平坦区,韧窝数量增多,形貌尺寸变得更小且深,同时分布也较为均匀。断口形貌的变化符合材料力学性能变化。