二苯氨基脲分光光度法测定饮水机热罐中六价铬含量

为了探讨饮水机热罐水中浸出六价铬的含量,采用快速测定六价铬含量的方法:二苯氨基脲分光光度法。试验中对样品进行平行处理并测定浸泡水中六价铬含量,评价热罐水中六价铬的浸出量。结果表明,使用该方法测定饮水机热罐中六价铬含量很稳定,曲线线性良好,线性回归方程为I=0.761 2c+0.002 5,R²=0.999 93,饮水机中热罐浸出六价铬含量为0.010 mg/L。该法对输配水设备产品中浸出六价铬含量的测定具有一定的指导意义。     

坚硬顶板下巷道锚网索喷联合支护技术实践

干河煤矿+80水平三采区皮带巷上部赋存坚硬岩层,围岩压力较大;针对坚硬顶板条件,拟定以强主动支护为主的对策,即采用锚网索喷联合支护技术;应用表明,该巷道围岩变形量不大,验证了该支护技术安全可靠。     

Preparation of magnetic zeolite/chitosan composite using silane as modifier for adsorption of Cr(VI) from aqueous solutions

This study aimed to prepare an efficient, cost-effective, and separable magnetic zeolite/chitosan composite (MZFA/CS) adsorbent from solid waste to deal with the water pollution of Cr(VI). The MZFA/CS was characterized by X-ray fluorescence (XRF), Fourier transform infrared (FTIR) spectroscopy, X-ray diffraction (XRD), and vibrating sample magnetometer (VSM) techniques. Then, the effect of pH, temperature, initial concentration of Cr(VI) ions, and contact time was considered in the study. For a sorbent dose of 0.1 g in 50 mL of a Cr(VI) solution, at a contact time of 30 min, temperature of 30°C, and a pH of 3, an adsorption capacity (q_e) of 16.96 mg g⁻¹ was achieved. Adsorption kinetics and isotherm data obtained for all adsorption systems were well-fitted by pseudo-second-order and Langmuir models, respectively. The thermodynamic study suggested that the adsorption process is spontaneous and endothermic in nature. In summary, the adsorbent with better separability (Ms = 16.83 emu g⁻¹) and adsorbability was successfully fabricated.     

A highly active composite electrocatalyst Ni–Fe–P–Nb2O5/NF for overall water splitting

This work demonstrates a facile Nb₂O₅-decorated electrocatalyst to prepare cost-effective Ni–Fe–P–Nb₂O₅/NF and compared HER & OER performance in alkaline media. The prepared electrocatalyst presented an outstanding electrocatalytic performance towards hydrogen evolution reaction, which required a quite low overpotential of 39.05 mV at the current density of ?10 mA cm^?2 in 1 M KOH electrolyte. Moreover, the Ni–Fe–P–Nb₂O₅/NF catalyst also has excellent oxygen evolution efficiency, which needs only 322 mV to reach the current density of 50 mA cm^?2. Furthermore, its electrocatalytic performance towards overall water splitting worked as both cathode and anode achieved a quite low potential of 1.56 V (10 mA cm^?2).     

The isothermal reduction kinetics of chromium-bearing vanadium–titanium magnetite sinter

The reduction of chromium-bearing vanadium–titanium magnetite sinter (CVTMS) by CO was investigated at 1123–1223?K. The reduction degree increased with increasing temperature. The isothermal reduction kinetics of CVTMS was analysed, according to Sharp analysis and ln–ln analysis, the kinetic mechanism of reduction process for all samples in different basicity can be represented as f(α)?=?1.61(1?α)[?ln(1?α)]^1–1/1.61. The reaction activation energy of all samples (R?=?1.9, 2.1, 2.3, obtained according to the components of the materials burdening used in sintering process) at different reaction degrees were calculated by the model-free method. And the pre-exponential factors of reaction also were calculated by the mathematical method. The rate controlling step for the reduction process under the present reduction condition was chemical reaction.     

硬质道路石油沥青关键组分的研制

筛选出适合制备硬质道路石油沥青关键组分的减压渣油，并以此为原料，考察了蒸馏深拔、深度氧化及溶剂脱沥青工艺制备的硬质道路沥青关键组分的性能。所制备的关键组分能够大幅提升基质沥青的高温性能，且通用性好；将关键组分与基质沥青按适合比例调合可以稳定生产高温性能好的硬质道路石油沥青，其混合料耐高温性能好。同时,为便于硬质沥青关键组分的使用,还开发了关键组分的造粒成型技术,提出其适于成型造粒的黏度范围为0.6～6 Pa?S。采用关键组分生产的硬质道路沥青用于高速公路实体工程，经过2年以上的气候和通车考验，沥青路面无车辙、无开裂，保持优良的使用性能。     

镀液温度实时控制系统的设计与实现

针对镀液温度变化的非线性和滞后性,设计了采用专家规则的镀液温度实时控制系统。该系统在实时监测的基础上,构建了综合评判镀液温度偏差和镀液温度偏差变化率的专家规则,实现了镀液温度的自适应快速调节。仿真分析结果表明,该系统克服了非线性和滞后性的不良影响,能够实现镀液温度的实时控制。     

多晶硅生产中残液搅拌罐密封结构的改造

在处理多晶硅生产中产生的残液时,残液搅拌罐填料密封出现泄漏,针对此问题提出了优化措施,达到了预期效果。     

Biosorption of chromium (VI) from aqueous solution by seed powder of prickly pear (Opuntia ficus indica L.) fruits

ABSTRACT

The solid residue of the cold press oil extraction from prickly pear (Opuntia ficus indica L.) fruit seeds was evaluated as a low-cost biosorbent for biosorption of Cr(VI) from aqueous solutions. Batch experiments were conducted as a function of initial pH, contact time, biosorbent dose, initial Cr(VI) concentration, and temperature. Biosorption was highly pH-dependent and found to be maximum at pH 1.0. Langmuir and Freundlich equations fitted very well with experimental data. The maximum monolayer adsorption capacity was 19.61 mg/g at 298 K and pH 1.0. Biosorption kinetics was controlled by the pseudo-second-order model. Thermodynamic parameters indicated that biosorption of Cr(VI) was a spontaneous, favorable and endothermic process. The activation energy was found to be 40.68 kJ.mol^?1.     

超高压水力割缝增透卸压规律研究与应用

运用FLAC3D软件模拟不同割缝压力和割缝间距条件下,钻孔周围煤体应力分布特征,分析了穿层钻孔水力割缝煤体卸压规律。通过在赵固二矿实施超高压水力割缝增透技术工艺,有效解决了单一低渗坚硬厚煤层瓦斯抽采技术难题,增大了抽采钻孔卸压范围,大幅提高了煤体透气性。