轻质滤料滤池的试验与研究

轻质滤料滤池是以比水密度略小的滤料为滤床的滤池，通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象，所取得的结果表明：下向流轻质滤料滤池对浊度和悬浮固体（SS）的去除率分别可以达到80％和45％，而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。     

Pure perceptual-based sequence learning.

Learning a sequence of target locations when the sequence is uncorrelated with a sequence of responses and target location is not the response dimension (pure perceptual-based sequence learning) was examined. Using probabilistic sequences of target locations, the author shows that such learning can be implicit, is unaffected by distance between target locations, and is mostly limited to first-order transition probabilities. Moreover, the mechanism underlying learning affords processing of information at anticipated target locations and appears to be attention based. Implications for hypotheses of implicit sequence learning are discussed. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

气相色谱在线分析变压吸附法制纯氢中的总碳

利用带镍加氢转化炉的气相色谱仪 ,在线分析变压吸附法制纯氢中的总碳。该法用变压吸附法制的纯氢作燃气 ,在检测器前端将氢气中的CO和CO2 转化为CH4,然后用氢火焰离子化检测器检测 ,直接以检测器的信号 (mV)进行定量。当氢气中总碳体积分数在 1 9～ 5 0 0 μl/L时 ,FID信号值与总碳体积分数有良好的线性关系。方法回收率为 99 90 %～ 10 1 9%,相对标准偏差 <1%。     

纯铜双层辉光离子渗钛组织形成机理及性能分析

采用双层辉光离子渗金属技术对纯铜进行了渗钛处理。用配有能谱仪(EDS)的扫描电子显微镜(SEM)、X射线衍射仪和透射电子显微镜对合金层的显微组织形貌、钛含量分布、相组成及相结构类型进行了观察与测定，对合金层的形成机理进行了探讨，并对其性能进行了对比测定。结果表明：渗钛层由合金层和扩散层组成，合金层主要由TiCu (Cu)固溶体 TiCu4构成，TiCu4为Dla型有序相，TiCu为B2型有序相，扩散层为(Cu)固溶体。渗钛处理后纯铜的表面得到显著强化。     

超纯汞生产新工艺的技术研究

本文着重介绍了超纯汞生产新工艺的基本原理的理论探讨及生产工艺过程的控制。     

A prediction method for thermal conductivity of alternative refrigerants in the liquid phase

A prediction method for the thermal conductivity of halocarbon refrigerants in the saturated liquid state in the reduced temperature range 0.3 to well above 0.9 is presented in this paper. The aim of the method is to present a very simple calculation of the transport property useful for engineering purposes. The method determines thermal conductivity as a sole function of the reduced temperature and requires the knowledge of a parameter dependent upon easily available physical constants characteristic of each compound. The method is validated against experimental data available in the literature, giving average absolute deviations which are usually less than 5%, with maximum absolute deviations generally less than 10%. An extension of the method to estimate thermal conductivity of binary mixtures is also presented, along with a comparison with the few experimental data available in the literature.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

In situ FTIR spectroscopy on rhodium-exchanged NaX zeolite with different metal dispersion during syngas reaction

In situ FTIR spectroscopy has been applied to study the reason of the different selectivity behaviour of rhodium in the CO hydrogenation reaction in dependence on the different particle size. Several forms of molecularly adsorbed CO are observed, such as linearly- and bridgedbonded CO on metallic rhodium as well as dicarbonyl species with Rh(I) centres formed by oxidation of Rh(0) with protons in presence of CO. Furthermore, non-reactive formate, acetate, and carbonate species are produced as side products of the reaction. The higher selectivity to oxygenates, particularly to methanol, is explained by the existence of multiple-bonded CO present only on small rhodium crystallites. The multiple-bonded CO formed at low temperatures is converted at higher temperatures to the highly reactive formyl species, which is hydrogenated to methanol.     

纯铝等径角挤技术（I）——显微组织演化

研究了纯铝在 3种 (A、B和C)不同等径角挤工艺中的显微组织演化。结果表明 :纯铝经过等径角挤压变形后 ,其显微组织特征与加工路线有很大的关系。提出了立方元素扭转模型 ,分析了 3种不同加工路线的剪切面和剪切方向 ,较好地解释了采用 3种不同路线挤压后材料显微组织的演化规律。在路线C(各道次挤压间试样旋转 180°)中 ,每次挤压样品总是在相同的剪切面上发生剪切 ,每相邻道次之间的剪切方向相反 ,前一次变形产生的剪切应变被随后紧接着的下一次挤压所抵消 ,这导致了多余的剪切应变 ;在路线A(各道次挤压间试样不旋转 )中 ,有两个相交成 6 0°的剪切面 ,剪切交替地在两个剪切面上进行 ;在路线B(各道次挤压间试样旋转 90°)中 ,存在 4个不同的剪切面和剪切方向 ,挤压交替地在 4个剪切面上进行 ,X ,Y和Z平面上的晶粒都发生了剪切 ,这有利于等轴晶结构的形成     

纯铜动态再结晶的Monte Carlo法模拟

本文建立了一种基于能量判据的确定动态再结晶各个阶段临界应变的方法，并基于此种方法Monte Carlo(MC)法进行了纯铜动态再结晶的二维模拟，定量计算了变形引起的存储能与变形之间的关系，计算出了发生动态再结晶的临界应变。模拟结果表明，采用MC法可以揭示动态再结晶的形核生长过程与应变历史之间的关系。结合本文所建立的基于能量判据的确定动态再结晶各个阶段临界应变的方法，可以预测开始发生动态再结晶的临界变形条件。