离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

地应力条件下的凿岩爆破数值模拟

为了研究地应力对凿岩爆破的影响,采用DDA方法模拟爆炸应力波作用下考虑地应力条件时的单孔和多孔凿岩爆破破岩过程。模拟发现,随着初始地应力水平的增加,裂纹扩展半径和破岩区域面积减小,裂纹发育主方向趋于地应力的最大主应力方向,初始地应力对裂纹的抑制和引导作用明显;初始地应力水平的增加,对拉伸裂纹的抑制作用更为显著,从而降低了拉伸破坏对爆破破岩的贡献。模拟也表明,在初始地应力存在的条件下,通过对爆破载荷和炮孔布置进行针对性的优化,可以克服地应力带来的影响,并取得预期的爆破效果。本研究对地应力条件下的凿岩爆破工程具有理论和参考意义。     

Application of artificial neural network method to predict the breakage properties of PGE bearing chromite ore

In the present investigation, systematic grinding experiments were conducted in a laboratory ball mill to determine the breakage properties of low-grade PGE bearing chromite ore. The population balance modeling technique was used to study the breakage parameters such as primary breakage distribution (B_{i, j}) and the specific rates of breakage (S_i). The breakage and selection function values were determined for six feed sizes. The results stated that the breakage follows the first-order grinding kinetics for all the feed sizes. It was observed that the coarser feed sizes exhibit higher selection function values than the finer feed size. Further, an artificial neural network was used to predict breakage characteristics of low-grade PGE bearing chromite ore. The predicted results obtained from the neural network modeling were close to the experimental results with a correlation of determination R² = 0.99 for both product size and selection function.     

In-situ measurement of mineral phase transition and kinetics in roasting process of Bayan Obo mixed rare earth concentrate by sodium carbonate

In this study, the Bayan Obo rare earth concentrates mixed with Na₂CO₃ were used for roasting research. The phase change process of each firing stage was analyzed. The kinetic mechanism model of the continuous heating process was calculated. This study aims to recover valuable elements and optimize the production process to provide a certain theoretical basis. Using X-ray diffraction (XRD), Fourier infrared spectroscopy, scanning electron microscopy with energy dispersive spectrometry, the reaction process and the existence of mineral phases were analyzed. The variable temperature XRD and thermogravimetric method were used to calculate the roasting kinetics. The phase transition results show that carbonate-like substances first decompose into fine mineral particles, and CaO, MgO, and SiO₂ react to form silicates, causing hardening. Further, REPO₄ and NaF can directly generate CeF₃ and CeF₄ at high temperatures, and a part of CeF₄ and NaF forms a solid solution substance Na₃CeF₇. Rare earth oxides calcined at a high temperature of 750 °C were separated to produce Ce_0.6Nd_0.4O_1.8, Ce₄O₇, and LaPrO_3+x. Then, BaSO₄, Na₂CO₃, and Fe₂O₃ react to form barium ferrite BaFe₁₂O₁₉; the kinetic calculation results show that during the continuous heating process, the apparent activation energy E reaches the minimum in the entire reaction stage in the temperature range of 440–524 °C, and the reaction order n reaches the maximum, which indicates that the decomposition product REFO significantly impacts the reaction system and reduces the activation energy. The mechanism function is F(α) = [?ln (1?α)]^1/3. The reaction order n reaches the minimum in the temperature range of 680–757 °C, and the apparent activation energy E is large. The difficulty of the reaction increases during the final stage. The reaction mechanism function is F(α) = [1?(1?α)^1/3]². Observing the entire reaction stage, the step of controlling the reaction rate changes from random nucleation to three-dimensional diffusion (spherical symmetry).     

Synthesis,microstructures, and corrosion behaviors of multi-components rare-earth silicates

Multi-components and equimolar rare earth monosilicates, (Y_1/3Dy_1/3Er_1/3)₂SiO₅, (Y_1/3Dy_1/3Lu_1/3)₂SiO₅, (Y_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ and (Yb_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅, were prepared by solid-state reactions and the following hot-pressing. Dense microstructures with uniform elemental distributions were obtained for all samples. These investigated multi-components monosilicates exhibit low thermal conductivities and similar coefficients of thermal expansion with SiC. Moreover, they exhibit high corrosion resistances in 1400 °C water vapor, especially, four-components (Y_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ and (Yb_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ experienced almost invariable weights after small weight losses during the initial 0.5 h. All those results indicate that multi-components rare earth monosilicates are promising candidates of environmental barrier coatings for SiC/SiC composites.     

基于现代审美下的赣傩艺术元素分析与设计应用

目的 赣傩艺术元素内容丰富并保存完整,是研究我国古代赣傩地区文化与艺术的珍贵史料.研究赣傩艺术元素的提取及衍生图案的设计方法,在设计应用中表达赣傩傩面具、选取傩舞形和构筑傩庙魂,能给当代赣傩艺术元素的产品设计以指引.方法 通过直接引用、形意结合和局部强化的设计方法,增厚其丰富内涵、设计个性和主题意蕴.通过现代化审美中"绿色化、感性化、地域化"的要求,遵循"以退为进,化繁为简""多元并存,个性体现"的原则,强化赣傩艺术元素的独特风格.结论 用现代的手法,将特色的赣傩艺术元素植入到理性的产品设计中去,使赣傩艺术元素与现代设计思想有机结合.在继承传统文化与现代流行中找到契合点,深入挖掘赣傩艺术元素蕴含的文化精神、文化胸怀和文化自信,使中华传统文化在现代审美下进行创新再现.     

Synthesis and luminescence enhancement of red-emitting Sr9Y(PO4)7:Eu3+ phosphor through Gd3+ co-doping for white light-emitting diodes

A series of Sr₉Y(PO₄)₇:Eu³⁺ and Sr₉Y(PO₄)₇:Eu³⁺, Gd³⁺ red-emitting phosphors were prepared via a high-temperature solid-state method, Gd³⁺ ion was co-doped in Sr₉Y(PO₄)₇:Eu³⁺ as sensitizer to enhance the luminescence property. The X-ray diffraction results verify that the structure of the as-prepared samples is consistent with the standard Sr₉Y(PO₄)₇ phase. All the Sr₉Y(PO₄)₇:Eu³⁺ samples show both characteristic emission peaks at 594 nm and 614 nm under near-ultraviolet excitation of 394 nm. The co-doping of Gd³⁺ significantly improves the luminescence intensity of the Sr₉Y(PO₄)₇:Eu³⁺ phosphors due to the crystal field environment effect and energy transfer of Gd³⁺→Eu³⁺ caused by the introduction of Gd³⁺, especially Sr₉Y(PO₄)₇:0.11Eu³⁺, 0.05Gd³⁺, which emission intensity is higher than that of Sr₉Y(PO₄)₇:0.11Eu³⁺ by 1.21 times. The color purity and lifetime of Sr₉Y(PO₄)₇:0.11Eu³⁺, 0.05Gd³⁺ phosphor are 88.26% and 3.7615 ms, respectively. A w-LED device was packaged via coating the as-prepared phosphor on n-UV chip of 395 nm with commercial phosphors. These results exhibit that the Sr₉Y(PO₄)₇:Eu³⁺, Gd³⁺ red-emitting phosphor can be used as a red component in the w-LEDs application.