离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

地应力条件下的凿岩爆破数值模拟

为了研究地应力对凿岩爆破的影响,采用DDA方法模拟爆炸应力波作用下考虑地应力条件时的单孔和多孔凿岩爆破破岩过程。模拟发现,随着初始地应力水平的增加,裂纹扩展半径和破岩区域面积减小,裂纹发育主方向趋于地应力的最大主应力方向,初始地应力对裂纹的抑制和引导作用明显;初始地应力水平的增加,对拉伸裂纹的抑制作用更为显著,从而降低了拉伸破坏对爆破破岩的贡献。模拟也表明,在初始地应力存在的条件下,通过对爆破载荷和炮孔布置进行针对性的优化,可以克服地应力带来的影响,并取得预期的爆破效果。本研究对地应力条件下的凿岩爆破工程具有理论和参考意义。     

In-situ measurement of mineral phase transition and kinetics in roasting process of Bayan Obo mixed rare earth concentrate by sodium carbonate

In this study, the Bayan Obo rare earth concentrates mixed with Na₂CO₃ were used for roasting research. The phase change process of each firing stage was analyzed. The kinetic mechanism model of the continuous heating process was calculated. This study aims to recover valuable elements and optimize the production process to provide a certain theoretical basis. Using X-ray diffraction (XRD), Fourier infrared spectroscopy, scanning electron microscopy with energy dispersive spectrometry, the reaction process and the existence of mineral phases were analyzed. The variable temperature XRD and thermogravimetric method were used to calculate the roasting kinetics. The phase transition results show that carbonate-like substances first decompose into fine mineral particles, and CaO, MgO, and SiO₂ react to form silicates, causing hardening. Further, REPO₄ and NaF can directly generate CeF₃ and CeF₄ at high temperatures, and a part of CeF₄ and NaF forms a solid solution substance Na₃CeF₇. Rare earth oxides calcined at a high temperature of 750 °C were separated to produce Ce_0.6Nd_0.4O_1.8, Ce₄O₇, and LaPrO_3+x. Then, BaSO₄, Na₂CO₃, and Fe₂O₃ react to form barium ferrite BaFe₁₂O₁₉; the kinetic calculation results show that during the continuous heating process, the apparent activation energy E reaches the minimum in the entire reaction stage in the temperature range of 440–524 °C, and the reaction order n reaches the maximum, which indicates that the decomposition product REFO significantly impacts the reaction system and reduces the activation energy. The mechanism function is F(α) = [?ln (1?α)]^1/3. The reaction order n reaches the minimum in the temperature range of 680–757 °C, and the apparent activation energy E is large. The difficulty of the reaction increases during the final stage. The reaction mechanism function is F(α) = [1?(1?α)^1/3]². Observing the entire reaction stage, the step of controlling the reaction rate changes from random nucleation to three-dimensional diffusion (spherical symmetry).     

Synthesis,microstructures, and corrosion behaviors of multi-components rare-earth silicates

Multi-components and equimolar rare earth monosilicates, (Y_1/3Dy_1/3Er_1/3)₂SiO₅, (Y_1/3Dy_1/3Lu_1/3)₂SiO₅, (Y_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ and (Yb_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅, were prepared by solid-state reactions and the following hot-pressing. Dense microstructures with uniform elemental distributions were obtained for all samples. These investigated multi-components monosilicates exhibit low thermal conductivities and similar coefficients of thermal expansion with SiC. Moreover, they exhibit high corrosion resistances in 1400 °C water vapor, especially, four-components (Y_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ and (Yb_1/4Dy_1/4Ho_1/4Er_1/4)₂SiO₅ experienced almost invariable weights after small weight losses during the initial 0.5 h. All those results indicate that multi-components rare earth monosilicates are promising candidates of environmental barrier coatings for SiC/SiC composites.     

Synthesis and luminescence enhancement of red-emitting Sr9Y(PO4)7:Eu3+ phosphor through Gd3+ co-doping for white light-emitting diodes

A series of Sr₉Y(PO₄)₇:Eu³⁺ and Sr₉Y(PO₄)₇:Eu³⁺, Gd³⁺ red-emitting phosphors were prepared via a high-temperature solid-state method, Gd³⁺ ion was co-doped in Sr₉Y(PO₄)₇:Eu³⁺ as sensitizer to enhance the luminescence property. The X-ray diffraction results verify that the structure of the as-prepared samples is consistent with the standard Sr₉Y(PO₄)₇ phase. All the Sr₉Y(PO₄)₇:Eu³⁺ samples show both characteristic emission peaks at 594 nm and 614 nm under near-ultraviolet excitation of 394 nm. The co-doping of Gd³⁺ significantly improves the luminescence intensity of the Sr₉Y(PO₄)₇:Eu³⁺ phosphors due to the crystal field environment effect and energy transfer of Gd³⁺→Eu³⁺ caused by the introduction of Gd³⁺, especially Sr₉Y(PO₄)₇:0.11Eu³⁺, 0.05Gd³⁺, which emission intensity is higher than that of Sr₉Y(PO₄)₇:0.11Eu³⁺ by 1.21 times. The color purity and lifetime of Sr₉Y(PO₄)₇:0.11Eu³⁺, 0.05Gd³⁺ phosphor are 88.26% and 3.7615 ms, respectively. A w-LED device was packaged via coating the as-prepared phosphor on n-UV chip of 395 nm with commercial phosphors. These results exhibit that the Sr₉Y(PO₄)₇:Eu³⁺, Gd³⁺ red-emitting phosphor can be used as a red component in the w-LEDs application.     

The effects of the modification of the BST-system solid solutions with rare earth elements

The conditions for the preparation of the solid solutions of a binary system of barium-strontium titanates with the substitutions in the A-sublattice with the rare-earth elements (REE), including the solid-phase synthesis, mechanical activation and sintering of dispersed-crystalline products by the conventional ceramic technology, were optimized. The presence (absence) of the impurity phases was established depending on the size effect of the REE. The precision X-ray diffraction analysis revealed the features of the phase formation in the studied solid solutions and showed that the “behavior” of the structural characteristics of the solid solutions with the participation of the REE is determined by the limiting conditions of the isomorphism and anion excess of the media under study. An assumption is made about the nature of the formation of a fine-grained landscape of the modified solid solutions, associated with the multicluster structure of the crystallite structure and the formation of the ballast phases during their synthesis. The dependences of the dielectric properties of the solid-state solution on the external influences – temperature, frequency of an alternating electric field and strength of a constant field – have been established. The possibility of choosing on the basis of the obtained data, promising for practical applications of the compositions is shown.     

Preparation and properties of Eu and Dy co-doped strontium aluminate long afterglow nanomaterials

The long afterglow nanomaterials of strontium aluminate co-doped by Eu and Dy have been synthesized by co-precipitation combined hydrothermal method. The effects of hydrothermal time, calcination time, pH value, the amount of aluminum nitrate, activator, co-activator and flux H₃BO₃ on the fluorescence properties of the product were investigated by means of single factor optimization experiment. Then the orthogonal experiment was employed to obtain the optimal synthesis conditions that are as follows: n_Dy/n_Eu = 2.5, t_c = 2.5?h, n_Eu/n_Sr = 0.02, t_h = 8?h. Subsequently, the optimal synthesis conditions were verified by three repeated experiments, and the obtained products were analyzed by X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDX) and fluorescence spectrometer. The results showed that the synthesized target products all were the mixed crystal phase of SrAl₂O₄ and Sr₄Al_l4O₂₅. The particles presented regular spherical-like with size ~ 100?nm. The dopants Eu and Dy were confirmed existed in the SrAl₂O₄ powders. The fluorescence and afterglow data of the target products were better than that in the orthogonal experiment scheme. The primary emission spectra band was in the range of 400–600?nm with characteristic peak located at ~ 460?nm corresponding to the transitions of Eu²⁺ ions from 4f⁶5d→4f⁷, and the blue light can be observed by naked eyes. The similar fast-decaying and slow-decaying processes were displayed in all the afterglow curves, and the initial afterglow brightness of the target product is apparently higher than that of products synthesized by the orthogonal experiment. The synthesized target products, which show excellent long afterglow performance, present a great application prospects in the aspects of ceramics, plastics, arts and crafts, ink and coating.     

基于MSA的土石坝群体地震易损性研究

针对地震发生后亟需对土石坝群体震害进行快速评估的问题,基于统计数据和MSA方法,提出了土石坝群体震害易损性分析方法。通过分析土石坝群体震害数据,对震损大坝进行等级划分,结合地震破坏损失比和破坏比建立土石坝地震易损性矩阵。并引入MSA方法,建立土石坝群体震害易损性评估模型,计算出四种烈度下易损性参数及易损性曲线和概率,为土石坝群体震害快速评估提供了依据。