Fluorescence and IR characterization of epoxy cured with aliphatic amines

Cure reactions of the stoichiometric mixtures of diglycidyl ether of bisphenol A (DGEBA) and two very low molecular weight aliphatic polyether diamines (PED) were studied by using fluorescence and mid- and near-IR spectroscopic techniques. As the cure proceeded, the primary amine groups in PED are converted to the secondary and the tertiary amines. Near-IR spectral analysis was used to calculate the concentration of the three amine groups as a function of cure time. The decrease in the fluorescence intensity of DGEBA at about 307 nm was observed due to more effective quenching of the tertiary amine groups in PED, in comparison to the primary and the secondary amine groups. A large decrease in fluorescence intensity at 75 and 95 °C cure was observed. The amount of all the amine species was estimated from NIR spectra to shed light on the cure kinetics of PPO (polypropylene oxide) in comparison with PEO (polyethylene oxide) epoxy, as well as to explain their fluorescence behavior.The fluorescence intensity changes were correlated to the extent of epoxy reaction obtained by mid- and near-IR spectroscopy.     

月桂醇聚氧乙烯醚硝酸酯助燃降污性能的研究

通过柴油发动机台架试验证明 ,月桂醇聚氧乙烯醚硝酸酯用作柴油添加剂 ,既可提高柴油的燃烧性能 ,又可降低排放尾气中的一氧化碳 (CO)、未燃碳氢化合物 (HC)、氮氧化物 (NOx)含量及烟度等多种功能 ,是一种良好的多功能柴油助燃消烟添加剂。     

镁钴铝类水滑石催化合成安息香甲醚

采用共沉淀法制备了镁钴铝类水滑石化合物(MgCoAl-HTLcs),并用 X 射线衍射、扫描电子显微镜、NH_3程序升温脱附等方法对 MgCoAl-HTLcs 进行了表征,并以 MgCoAl-HTLcs 为催化剂催化苯甲醛与甲醇反应合成安息香甲醚,研究了n(Mg):n(Co):n(Al)、催化剂用量、原料配比、反应温度、反应时间对合成反应的影响。表征结果显示,MgCoAl-HTLcs 的晶相完整,表面主要为弱酸、弱碱性。催化合成安息香甲醚的适宜条件为:MgCoAl-HTLcs 催化剂用量0.10 g(约为原料总质量的0.23%),n(Mg):n(Co):n(Al)=0.4:1.6:1.0,V(苯甲醛):V(甲醇)=3:50,反应温度50℃,反应时间150 min。在此条件下,苯甲醛的平衡转化率达77.49%,安息香甲醚选择性接近100%。为洁净合成安息香甲醚开辟了一条新的途径。     

相转移催化合成芳基烷基醚

报道了以四丁基溴化铵为相转移催化剂，简便地合成了１０个芳基烷基醚，反应几乎是定量地快速进行。     

由碳五馏分合成甲基叔戊基醚工艺的研究

以催化裂化C_5馏分与工业甲醇为原料,D005型大孔强酸型阳离子交换树脂为催化剂,采用筒式膨胀床双反应器,考察了甲基叔戊基醚的合成工艺条件。一阶反应器的操作条件为：循环比为2：1,醇烯比为1.2：1,入口温度为70℃,空速为6 h~(-1),平均转化率为53.63%；二阶反应器的操作条件为：入口温度为50℃,空速为1.2h~(-1),平均转化率为71.32%,全调合方案可以使催化裂化汽油的辛烷值平均提高0.55个单位。     

Mechanical and microstructure studies on the modification of CA film by blending with PS

DriedMusa paradiciaca (banana) stem and veins of the leaves, which were hitherto discarded as a waste, were collected and used as starting material for the preparation of cellulose and cellulose acetate. This cellulose acetate was mixed with polystyrene to form blend of cellulose acetate-polystyrene in order to provide enhanced stability and extended utility to the end products. The films of these composites or their individual partners were made separately and studied for their mechanical properties, chemical modification and morphological changes. We report here that banana stem is good source of cellulose and that cellulose completely undergoes modification upon esterification.     

新的载体媒介传递膜

总结了近几年研究和发展的几种载体媒介传递膜。与支撑液膜相比，这些膜具有好的稳定性和长的寿命。对某些物质，如重金属离子、小分子中性碳氢化合物、氨基酸等有高的选择性和通量。它们的传递机理为固定位置跳跃或移动和固定载体2种机理结合。这些研究有望在环境、生物等技术领域中应用。     

Inter- and intra-molecular ionic interactions of polyampholyte: Carboxymethyl-2-diethylaminoethylcellulose

Carboxymethyl-2-diethylaminoethylcellulose (CM-DEAE cellulose) was prepared by etherification of carboxymethylcellulose with diethylaminoethyl chloride in a NaOH solution. The behaviour of CM-DEAE cellulose in aqueous solution was studied by viscosity and GPC measurements. The degree of substitution (DS) and existing states of DEAE substituents were examined by the use of proton NMR, and those of the CM substituents were observed with FT-IR. The results reveal that the reduced viscosity and apparent molecular size of CM-DEAE cellulose vary with the concentration of sodium chloride and changes in pH and DS. These phenomena can be explained in terms of inter- and intra-molecular ionic interactions.     

氧浓度对近临界水中纤维素分解的影响

研究了不同初始氧浓度对纤维素在近临界水中分解的影响，实验结果表明，氧浓度显著地影响产物总碳收支平衡，液相不同组分的收率、气体的产量以及气相产物的组成，微量氧对产物总碳收支平衡影响不大，而对液相不同组分的收率有一定的影响。从实验结果可以看出，离子型反应机理在纤维素水解的第一步中起主导作用。而单糖的进一步分解是一个以自由基反应机理为主的过程。