Non-Platinum Group Metal Electrocatalysts toward Efficient Hydrogen Oxidation Reaction

Developing non-platinum group metal (non-PGM) electrocatalysts for the hydrogen oxidation reaction (HOR) represents the efforts towards the more economical use of hydrogen fuel cells and hydrogen energy, which has attracted tremendous attention recently. However, non-PGM electrocatalysts for the HOR are still in their early development stages as compared with the significant advances in those for the oxygen reduction reaction and hydrogen evolution reaction. Herein, this paper summarizes the recent progresses and highlights the key challenges for the rational design of non-PGM electrocatalysts, aiming to promote the development of non-PGM HOR electrocatalysts. Fundamental understandings of the HOR mechanism are firstly reviewed, where theoretical interpretations on the low HOR kinetics in alkaline media, including the hydrogen binding energy theory, the bifunctional mechanism, and the water molecule reorganization, are particularly discussed. Subsequently, progresses of typical non-PGM HOR electrocatalysts in acid and alkaline media are summarized separately. For the HOR under alkaline conditions, the superiorities and challenges of Ni-based catalysts are discussed with a particular focus as they are the most promising non-PGM electrocatalysts. Finally, this paper highlights the challenges and provide perspectives on the future development directions of non-PGM HOR electrocatalysts.     

Deep eutectic solvent-based supramolecular gel polymer electrolytes for high-performance electrochemical double layer capacitors

Gel polymer electrolytes (GPEs) can avoid the electrolyte leakage risk of electrochemical double layer capacitors (EDLCs). But aqueous GPEs often suffer from narrow electrochemical windows. Herein, a series of deep eutectic solvent (DES)-based supramolecular GPEs are firstly developed for carbon-based EDLCs with wide voltage windows. The as-fabricated DES-based GPE shows an ionic conductivity of ~58 mS cm^?1, which makes the stable voltage window of a carbon-based EDLC reach 2.4 V. The carbon-based EDLC exhibits a specific capacitance of 32.1 F g^?1, an energy density of 24.6 Wh kg^?1 and a capacitance retention of ~90% after 15,000 charge-discharge cycles. Moreover, when quinhydrone is added into the DES-based GPE, the specific capacitance and energy density of the corresponding EDLC can be further expanded to 60 F g^?1 and 43.6 Wh kg^?1, respectively. Therefore, our work may present a universal strategy to prepare novel supramolecular GPEs for high-performance EDLCs with wide voltage windows.     

深圳抽水蓄能电站引水系统灌浆质量控制与分析

抽水蓄能电站引水系统灌浆质量控制,决定了水道系统渗水量的大小,关系到电站长期运行的经济指标及水道安全。详细介绍了深圳抽水蓄能电站灌浆参数的设计和灌浆中采取的管理措施与技术措施,分析了灌浆检测成果。电站投入运行以来,引水系统结构稳定,无渗漏。通过总结深圳抽水蓄能电站灌浆过程,对水道引水系统灌浆质量控制提出了几点建议,可供类似工程借鉴。     

一种5 重real-time PCR筛查转基因水稻方法的建立

以转基因水稻中最常用的CaMV35S启动子、NOS终止子、Cry1Ab/Ac基因、HPT基因及SPS水稻内标基因为研究对象，利用5 种不同的荧光信号（FAM、HEX、Taxas Red、Cy5、Cy5.5）进行多重实时聚合酶链式反应（real-time polymerase chain reaction，real-time PCR）检测方法的研究。通过引物组合筛选、反应体系优化、特异性测试、灵敏度测试、适用性测试等一系列实验，建立了5 重real-time PCR方法，灵敏度可达0.032%。此方法具有灵敏度高、结果准确、通量大等优点，可实现水稻中转基因成分的快速、高效检测。     

循证之证与康复之途*—— CCRC社区中的康复花园循证设计探索

疫情下医养机构封闭化管理已经步入 常态化，老年居民的心理健康受到了抑郁、焦虑 等问题的挑战。康复花园作为养老社区中重要 的心理生理康复空间，需以循证设计为原则， 为新形势下的养老社区提供切实可行的康复空 间。本文以西南地区某持续照护型（CCRC）养 老社区项目实践为载体，梳理阐述循证设计在 康复花园中完整的运用实践路径，总结我国循 证设计流程模型，为风景园林的循证实践提供 全链条式的解析和验证。本文尝试提出基于系 统医学评估指标的证据收集创新体系，为康复 花园循证设计提供运用实例，对康复花园的康 复绩效提出基于证据的定量评估模式。     

严寒地区室内多层贯通空间热湿环境实测研究

通过对严寒地区贯通空间温湿度在水平方向及垂直方向上的连续实测，分析了供暖前后，太阳辐射、建筑开口、供暖等因素对贯通空间热湿环境的影响有很大差异。结果表明供暖前贯通空间受到太阳辐射、建筑开口的影响较大，温湿度波动明显；供暖期间受供暖因素影响，温差波动不稳定但幅度小。水平方向上非供暖期最大温差为2℃，供暖期最大温差为8℃；垂直方向上非供暖期的最大温差为3℃，供暖期最大温差为7℃。     

新型AMBBR-MBBR-MBR工艺处理紫外线吸附剂厂废水

根据传统工艺处理紫外线吸附剂厂UV-P废水中高级氧化作为预处理成本高,单一A₂O生化工艺出水不稳定,并且出水污染物浓度高等缺点,首先采用零价铁强化水解和预曝气作为预处理,以新型AMBBR-MBBR-MBR工艺进行处理。工程MBBR采用三维多孔泡沫陶瓷填料为生物载体,MBR采用Si O₂平板陶瓷膜。长期调试运行效果表明,出水水质优于≤城镇污水处理厂污染物排放标准≥GB 18918-2002表1中一级A标准,即COD<50 mg/L,氨氮<5 mg/L,总氮<15 mg/L,硝基苯<2.0 mg/L,挥发酚<0.5 mg/L,苯胺类<0.5 mg/L等。水处理运行费用为4.9元/m³。     

基于深度学习的四旋翼无人机单目视觉避障方法

针对无人机避障问题，提出一种基于深度学习的四旋翼无人机单目视觉避障方法。首先通过目标检测框选出目标在图像中的位置，并通过计算目标选框上下边距的长度，以此来估量出障碍物到无人机之间的距离；然后通过协同计算机判断是否执行避障动作；最后使用基于Pixhawk搭建的飞行实验平台进行实验。实验结果表明，该方法可用于无人机低速飞行条件下避障。该方法所用到的传感器只有一块单目摄像头，而且相对于传统的主动式传感器避障方法，所占用无人机的体积大幅减小。该方法鲁棒性较好，能够准确识别不同姿态的人，实现对人避障。