Theoretical study of a thermoelectric-assisted vapor compression cycle for air-source heat pump applications

This paper proposes a thermoelectric-assisted vapor compression cycle (TVCC) for applications in air-source heat pump systems which could enhance the heating capacity of the system. Performances of TVCC are calculated and then compared with that of basic vapor compression cycle (BVCC). The simulation results show that when coefficients of performance (COPs) of the two cycles are almost equal, the TVCC under maximum COP condition of the thermoelectric modules still performs better than BVCC by 13.0% in heating capacity through selecting the appropriate intermediate temperature. In addition, the TVCC can also achieve an improvement of 16.4%–21.7% in both the heating COP and capacity when compared with the BVCC with an assistant electric heater that is provided with the equivalent power input of thermoelectric heat exchanger. Thus, the TVCC could be beneficial to the applications in small heat pumps if there is always need for auxiliary electric heat.     

原料扩重的中压加氢改质装置投产

介绍燕山石化公司为扩大1Mt／a中压加氢改质装置的原料来源，改用大庆减二线油和重油催化裂化柴油组成的混合料开工投产的经验以及装置初期的运行条件。中压加氢改质技术可以生产优质柴油和蒸汽裂解制乙烯的原料，还可增产喷气燃料。     

强度调制／直接检测（IM／DD）光纤通信系统色散限制的研究

通过引入归一化脉宽Ｐ和相对脉冲展宽因子ｑ，提出了一个适用于ＩＭ／ＤＤ系统中各种眼图恶化量ｘ和归一化脉宽Ｐ的色散限制改进公式。通过与其它理论的比较、计算机仿真和对实验数据的分析，验证了该公式的正确性，并给出了其它结果的限制条件。研究表明：当眼图恶化量ｘ为１ｄＢ左右时，对２．５Ｇｂ／；外调制信号（α＝０）而言，非色散位移光纤ＩＭ／ＤＤ系统的色散因子γ约等于０．７９，所对应的系统再生中继距离约为９００余公里。     

基于非锐化掩模的实时自适应图像增强算法

针对传统的非锐化掩模算法的局限性,依据图像中各像素点及以其为中心的若干相邻像素点的均方差值,提出了自适应图像增强算法的原理,并分析其硬件实现方法,然后给出了该算法与其它算法应用于图像增强的对比结果,最后在FPGA（field programmable gate array）实验板上进行验证.实验结果表明,此算法有效的增强图像的细节区域,防止图像边缘区域出现过冲现象,抑制图像平坦区域的噪声放大.因此,该算法取得了良好的视觉效果,硬件实现简单,适合于实时条件下图像的增强.     

三塘湖盆地上古生界烃源岩镜质组反射率异常研究

镜质组反射率是评价有机质成熟度的重要指标 ,然而由于地质因素和测试技术的原因 ,镜质组反射率测量值常与预计值有一定的偏差。在三塘湖盆地上古生界烃源岩中 ,可以观察到镜质组反射率的局部增强和镜质组反射率的抑制。局部增强多分布在上二叠统的烃源岩中 ,主要与火山活动有关。这种反射率的增强在平面上分布广泛 ,但纵向上影响范围较小。反射率的抑制是在上古生界烃源岩含有较高含量的腐泥组分背景下产生的。用氢指数模板方法对抑制进行了校正 ,抑制的幅度最大可达 0 .3%     

Dough mixing and breadmaking properties of quinoa-wheat flour blends

Flour blends of quinoa-wheat containing 0, 5, 10, 15, and 20% of manually dehulled quinoa meal or flour were evaluated for dough mixing and breadmaking properties and liking of the bread by a small panel. Increasing amounts of quinoa meal or flour increased farinograph absorption and dislike of bread for most of the panel. Dough development time increased with increase in meal but decreased with increase in quinoa flour. At 10% inclusion levels differences in liking from control 100% wheat flour bread were smaller for flour or water extracted meal to most of the panel, than with 10% non-extracted meal. This suggests that 10% inclusion of flour or water extracted meal may have potential for further investigation.     

Anion Sensing Porphyrin Functionalized Nanoparticles

Disulfide and dithiocarbamate functionalized porphyrins have been synthesized and used as protecting ligands for gold nanoparticle formation either via ligand substitution reactions or by direct synthesis. These nanoparticles have been shown to recognize anions via changes in the absorbance spectrum of the surface adsorbed porphyrin moieties. Association constants, derived from quantitative titrations, indicate a remarkable surface enhancement effect where the surface bound porphyrins bind anions much more strongly than the free receptor in solution.     

Pulsating Jet Impingement Heat Transfer Enhancement

This article presents results from a numerical study of pulsating jet impingement heat transfer. The motivation is to seek conditions offering a significant enhancement compared to steady flow impingement drying. The CFD software package FLUENT was used for simulating slot-type pulsating jet impingement flows with confinement. The parameter study included velocity amplitude ratio, mean jet velocity, and pulsation frequency. The distance from nozzle exit to surface was three times the hydraulic diameter of the nozzle. The Reynolds number based on the nozzle hydraulic diameter and jet temperature was 2,460 with a mean jet velocity of 30 m/s, which is the base case of the numerical experiments. Results showed that time-averaged surface heat transfer increased with increasing velocity amplitude for the same mean jet velocity. Large velocity amplitudes helped enhance heat transfer by two mechanisms: high jet velocity during the positive cycle and strong recirculating flows during the negative cycle. For the cases with different mean jet velocities but the same maximum velocity, time-averaged surface heat flux decreased with decreasing mean jet velocity. As for the effects of pulsation frequency, with high-velocity amplitude ratio, time-averaged surface heat fluxes were at the same level regardless of frequency. However, at low-velocity amplitude ratio, high frequency caused stronger recirculating flows resulting in greater heat transfer compared to the cases with a lower frequency.     

提高润滑油基础油氧化安定性的组合工艺

以生产润滑油基础油的老三套工艺为基础，开发了改善油品氧化安定性的组合工艺。该工艺的主要特点是包括一步络合脱氮过程。实验证明，该组合工艺既可以有效地提高基础油的氧化安定性，又能降低溶剂精制深度，提高基础油收率。     

蒸发式冷凝器管束中强制对流空气CFD模拟

运用FLUENT软件对圆管、椭圆管及交变曲面波纹管管束中强制对流空气热力过程进行了模拟,模拟数据经过Tecplot.10处理后直观地表征了3种管型管束中空气的速度场、压力场及温度场。结果表明,交变曲面波纹管在提高流体湍动程度及强化传热温差方面优于其它两种管型。