Effect of phosphogypsum on saline-alkalinity and aggregate stability of bauxite residue

A column experiment was conducted to investigate the effect of phosphogypsum (PG) on the saline- alkalinity, and aggregate stability of bauxite residue. Results showed that: with increasing leaching time, the concentrations of saline-alkali ions decreased while the concentration increased in bauxite residue leachate; compared with CK (control group) treatment, pH, electric conductivity (EC), exchangeable sodium percentage (ESP), sodium absorption ratio (SAR), and exchangeable Na⁺ content of bauxite residue were reduced following PG treatment; average particle sizes in aggregates following CK and PG treatments were determined to be 155 and 193 nm, respectively. SR-μCT test results also confirmed that bauxite residue following PG treatment acquired larger aggregates and larger pore diameter. These results indicate that the PG treatment could significantly modulate the saline-alkalinity, and simultaneously enhance aggregate stability of bauxite residue, which provides a facile approach to reclaim bauxite residue disposal areas.     

离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

机械活化对粉煤灰提铝影响研究

为提高粉煤灰中铝提取率, 采用机械活化对粉煤灰进行预处理, 探讨了机械活化对粉煤灰焙烧-酸浸效果的影响。结果表明: 机械活化能提高粉煤灰比表面积、增加反应活性点, 促进活化反应的进行; 通过机械活化, 在Na₂CO₃与Al₂O₃物质的量比1.6、850 ℃下焙烧50 min后酸浸, 铝浸出率达到91.58%。     

水酶法加工花生过程中酸浸工艺的研究

花生是一种重要的植物油脂和蛋白资源,水酶法处理花生能够同时得到油脂和具有特定功能的水解蛋白。为提高花生水解蛋白的纯度,在酶解前设计了酸浸过程,以除去花生体系中的可溶性糖和盐类等杂质。在单因素试验的基础上,通过正交试验优化酸浸工艺条件。结果表明,料液比和温度对蛋白质损失率及可溶性糖脱除率都有极显著或显著影响。酸浸工艺的最佳条件为料液比1∶6,处理时间30 min,pH 5,温度50℃。在最佳条件下,可溶性糖脱除率为(83. 11±0. 33)%,蛋白质损失率为(6. 19±0. 13)%。酸浸处理花生后可显著减少花生蛋白中糖的含量,但同时也伴有少量蛋白质损失。     

A comparative study on the effect of carbon-based and ceramic additives on the properties of fiber reinforced polymer matrix composites for high temperature applications

Ablative composites have been in use for thermal protection of space vehicles for decades. Carbon-phenolic composites have proven to perform exceptionally well in these applications. However with development in aerospace industry their performance needs improvement. In this field, different carbon-based and ceramic additives have been introduced into ablative composite systems. This review article gives a comparative analysis of researches done in this field in the recent past. Density, ablative, thermal and mechanical properties of ablative composites with different ultra-high temperature ceramic particles i.e. ZrSi₂, Cenosphere, nano-SiO₂, BN etc. and carbon-based nanoparticles i.e. CNTs, nano-Diamonds, Graphene oxide etc. used as additives, have been compared and discussed. Emphasis is put on carbon-phenolic composite systems although some epoxy matrix systems have also been discussed for comparison.     

渣油催化临氢热转化钼铁双金属催化剂的研究

Replacement of precious single metal catalysts with cost-effective, highly-dispersed composite catalysts for catalytic hydrothermal conversion of residue holds tremendous promise for the residue upgrading technologies. Organic metals were added to the feed as the oil-soluble precursors, and transformed into the catalytic active phases in this work. Physical properties and structures of the composite catalysts had been investigated by X-ray fluorescence spectroscopy, X-ray photoelectron spectroscopy, X-ray diffraction, scanning electron microscope and transmission electron microscopy. The composite catalysts were found to be highly efficient in the catalytic hydrothermal conversion of both model compound and residue. Increased metal dispersion and synergistic effects of two metals played indispensable roles in such catalytic system. Results showed that under the test conditions in the article, the catalyst had the best catalytic performance when the mass ratio of molybdenum to iron was 1.5.     

中国与日本兽药残留限量标准比较分析研究

目的研究我国与日本兽药残留限量标准的异同。方法根据中华人民共和国国农业部第235号公告以及日本肯定列表、厚生劳动省第370号公告,比较两国法律法规涉及的禁用与限量物质清单在兽药种类、残留食品种类、残留限量指标值等方面的异同。结果我国兽药残留限量标准涉及123种兽药、3大类食品、12种动物与9种靶组织、550个限量指标,日本则涉及243种兽药、4大类食品、16种动物与8种靶组织、3705个限量指标。两者相比,我国83种兽药与日本相同, 445个限量指标与日本810个限量指标具有可比性。在中日标准涉及的具有可比性的限量指标中,我国有215个指标与日本等同,有80个指标比日本严格,有139个指标比日本宽松。结论在兽药残留限量标准涉及的可比指标值方面,我国二分之一的指标值与日本对应指标值是等同的。     

我国粮食中农药残留限量标准现状

现行食品中农药最大残留限量标准中涉及食品类别繁多,每类食品农药最大残留限量特点各异,尚未有针对粮食这一大类别农药残留限量的特点分析。本文重点介绍了我国粮食中农药残留限量总体状况,比对了GB 2763-2016、GB 2763.1-2018与GB 2763-2014标准中粮食农药残留限量的变化,包括农药种类、残留限量指标值、检测方法等内容,使广大粮油检测工作者全面系统了解粮食中农药残留限量现状,为今后监测工作提供帮助。同时在分析涉粮农药残留限量标准基础上,探讨了GB 2763-2016农残限量标准存在的问题,并提出了修改建议,对完善我国粮食农药残留限量标准具有现实意义。     

2017~2018年江苏省食品添加剂风险监测结果分析

目的研究江苏省食品添加剂的产品质量及存在的风险点。方法对江苏省范围内的食品添加剂进行风险监测,通过对江苏省2017-2018年食品添加剂抽样检查结果的汇总,分析近2年江苏省范围内食品添加剂的质量水平,总结食品添加剂的风险点并制定相应的监督防控措施。结果 2017～2018年江苏省共完成173批次食品添加剂的风险监测,抽检的食品添加剂样品涉及3类:单一食品添加剂、食品用香精及复配食品添加剂,其中溶剂残留检出9批次,塑化剂检出23批次,铝含量超过100 mg/kg检出6批次,检出未标识添加剂5批次。结论当前江苏省食品添加剂存在的风险点主要是溶剂残留、塑化剂残留、高铝成分检出及未如实标注添加剂成分等情况。食品添加剂生产企业及食品加工企业应加强对该类风险点的防控,同时监管部门需增强对食品添加剂的监管力度,制定对食品添加剂生产企业相关风险点的监管措施。