Discharge coefficient for vertical sluice gate under submerged condition using contraction and energy loss coefficients

A novel method is suggested for the determination of flow discharge in vertical sluice gates with considerably small bias. First, in order to derive an equation for the discharge coefficient, energy-momentum equations are implemented to define the physical realization of the phenomenon. Afterward, the discharge coefficient is presented in terms of contraction and energy loss coefficients. Subsequently, discharge coefficient, contraction, and energy loss coefficients were determined through an implicit optimization technique on the data. Data analysis illustrated that there is a meaningful power relationship between the contraction and energy loss coefficients. Thereafter, dimensional analysis is performed and an explicit best-fit regression equation is developed for defining the energy loss coefficient. The obtained equations for contraction and energy loss coefficients were then used in the computation of the discharge coefficient and determination of the flow discharge in the vertical sluice gate. The performance of the developed approach is validated against the selected benchmarks existing in the literature.     

Effect of an abrupt change in pulling rate on microstructures of directionally solidified Al2O3-Er3Al5O12 eutectic and off-eutectic composite ceramics

Directionally solidified microstructures of Al₂O₃-Er₃Al₅O₁₂ eutectic and off-eutectic in situ composite ceramics were explored under abrupt-change pulling rate conditions. Corresponding temperature distributions and interface locations were studied. In eutectic composition, fluctuation of eutectic spacing occurred when the pulling rate increased abruptly. A gradually increase or abrupt increase in eutectic spacing was observed when the pulling rate decreased abruptly. In hypoeutectic and hypereutectic compositions, formation of the primary phases were suppressed when the pulling rate increased abruptly from 10?µm/s to 100?µm/s, while primary phases precipitated when the pulling rate decreased abruptly from 100?µm/s to 10?µm/s. The interface altitude decreased after the pulling rate increased abruptly, but increased after the pulling rate decreased abruptly. The liquid composition restriction (around the eutectic composition) at the eutectic interface plays an important role in the suppression of the primary dendrite and coupled eutectic oxides can be obtained in off-eutectic compositions even under higher solidification rate conditions.     

Characteristic of rotating detonation wave in the H2/Air hollow chamber with Laval nozzle

To pinpoint the relationship between high frequency tangential instability(HFTI) and continuous rotating detonation (CRD), series of H₂/Air rotating detonations are experimentally achieved in the hollow chamber with Laval nozzle. The contraction ratio of the nozzle has a significant effect on the detonation. The detonation waves number increases with the increasing of equivalence ratio (ER) or nozzle contraction ratio. Based on its character, a new type of detonation is defined as two dominant peak one wave mode (TDPO). The velocities of detonation waves propagating in this new mode are larger than the Chapman-Jouguet (CJ) theoretic value. On the assumption that the reflection wave is rotated with the detonation wave, this mode is well illustrated. The forming process of two waves is also given. The results show that the appearance of combustion mode is relative to the reflection wave generated at the contraction section of the nozzle. The inner mechanism of the refection wave is illustrated. These works make a foundation to investigate the relationship between rotating detonation and tangential instability.     

不均匀地基埋地箱涵伸缩缝的地震位移响应研究

对位于不均匀地基的某核电厂地下排水箱涵的地震反应进行了数值研究,着重探讨了箱涵伸缩缝的位移反应特性。采用场地相关地震动时程,考虑土体为理想弹塑性材料,基于FLAC~（3D）软件进行了非线性动力分析。结果表明,在地震作用过程中,埋地箱涵的位移取决于周围岩土体的运动;各管段的整体位移虽较大但各伸缩缝的相对位移数值较小;相邻箱涵段轴向不会发生碰撞;选择及设置伸缩缝止水带时应注意其横向最大变形应大于最大横向地震位移,以免发生剪切破坏。     

核电站安全壳表面裂缝成因分析及对策研究

根据核电站安全壳表面裂缝的表现形式,分析了裂缝的形成原因,通过建立ANSYS分析模型,研究了夏季和冬季时安全壳的表面温度应力。结果表明,运营期间裂缝产生的主要原因为混凝土收缩应力和温度应力造成的,并针对安全壳表面裂缝提出了处理建议。     

A Unified Structure Theory for Polycyclic Conjugated Hydrocarbons--A Review of What Every Chemist Should Know!

The important concepts of a formula periodic table set, aufbau principle, elementary substructures, excised internal structure/circumscribing algorithm, leapfrog algorithm, and hexagonal-to-pentagonal ring contraction algorithm will be reviewed. These concepts have been instrumental in organizing polyhex/polypent systems from benzenoid hydrocarbons to fullerene carbons. Some recent experimental verification of our prior predictions in this work will be noted.     

Chemomechanical Systems: Study of Contraction and Mechanical Work of Poly(Acrylonitrile) Gel Fibers

Poly(acrylonim1e) fibers were preoxidated under stress, in the presence of air, then saponified by boiling in alkaline solutions. The chemomechani-cal behavior of these fibers, expressed as contraction and mechanical work, under different loads and in different solvent-nonsolvent and/or base-acid systems were investigated. Total nitrogen content, carboxyl groups content, tensile strength, and cross-link density were determined. Both contraction and mechanical work were expressed as functions of applied load in every studied system. The results of chemomechanical measurements were connected to those of chemical and physical investigations. Significant differences in chemomechanical behavior were found to be the result of different stress conditions during the preoxidation stage.     

Anomalous Contraction Scour? Vertical-Contraction Case

Clear-water scour due to a short vertical (pressure flow) contraction was investigated in a laboratory channel. Two approach velocities were studied for a (nominally) single configuration of depth and degree of contraction, with experiments conducted for various durations up to a maximum of 48 h, and the evolution of the scour hole over time monitored. The location of maximum scour in both cases was observed to occur downstream of the contraction, with maximum scour depths substantially in excess of values predicted by published models, even though equilibrium scour conditions were not reached.     

Effect of viscoelasticity on drop dynamics in 5:1:5 contraction/expansion microchannel flow

Recently, we reported how viscoelasticity affects drop dynamics in a microchannel flow using the finite element-front tracking method (FE-FTM). In this work, we investigate drop dynamics for a wider range of parameters: viscosity ratio between droplet and medium (χ), capillary number (Ca), droplet size, and fluid elasticity. The Oldroyd-B model is adopted as the constitutive equation for the viscoelastic fluid. We observe that the drop deformation in a microfluidic channel is dependent on Ca, which is more pronounced for smaller χ values. The present work shows that viscoelasticity plays an important role in drop dynamics with increasing χ values for Newtonian droplet in viscoelastic medium, which can be attributed to high normal stress developed in narrow film thickness between droplet and channel for higher χ values. We also study circulation problem inside droplets, which is important in practice, such as in droplet reactor application. The present work shows that circulation intensity is enhanced with decreasing χ values. We find that the relevance of viscoelastic effects on internal circulation is dependent on χ values, and the circulation intensity is distinctively decreased with increasing elasticity for high χ values for Newtonian droplet in viscoelastic medium. We expect that the present work be helpful not only in controlling droplets but also to improve our physical insight on drop dynamics in microchannel flows.     

Direct Solution to Problems of Open-Channel Transitions: Rectangular Channels

The specific energy equation has many applications in rectangular open-channel flow problems. The existing methods of solving this equation are as follows: trial-and-error solution, graphical solution, and design tables prepared from the specific energy equation expressed in dimensionless form. No direct solutions are available in the technical literature for this equation to date because it was presumed that finding roots of this equation requires a series of substitutions. In this technical note, the writer develops an analytical solution for transitions located in rectangular open channels: (1) to avoid the inconvenience in available solutions; (2) to derive a less time consuming method; and (3) to achieve more accurate results than those as a result of using existing methods.