全文获取类型
收费全文 | 5855篇 |
免费 | 636篇 |
国内免费 | 307篇 |
专业分类
电工技术 | 100篇 |
技术理论 | 1篇 |
综合类 | 520篇 |
化学工业 | 1634篇 |
金属工艺 | 53篇 |
机械仪表 | 40篇 |
建筑科学 | 2343篇 |
矿业工程 | 319篇 |
能源动力 | 86篇 |
轻工业 | 162篇 |
水利工程 | 483篇 |
石油天然气 | 530篇 |
无线电 | 36篇 |
一般工业技术 | 275篇 |
冶金工业 | 120篇 |
原子能技术 | 36篇 |
自动化技术 | 60篇 |
出版年
2024年 | 5篇 |
2023年 | 56篇 |
2022年 | 112篇 |
2021年 | 208篇 |
2020年 | 177篇 |
2019年 | 158篇 |
2018年 | 156篇 |
2017年 | 200篇 |
2016年 | 166篇 |
2015年 | 216篇 |
2014年 | 335篇 |
2013年 | 340篇 |
2012年 | 417篇 |
2011年 | 476篇 |
2010年 | 427篇 |
2009年 | 402篇 |
2008年 | 350篇 |
2007年 | 407篇 |
2006年 | 385篇 |
2005年 | 342篇 |
2004年 | 302篇 |
2003年 | 248篇 |
2002年 | 213篇 |
2001年 | 127篇 |
2000年 | 125篇 |
1999年 | 99篇 |
1998年 | 71篇 |
1997年 | 66篇 |
1996年 | 40篇 |
1995年 | 39篇 |
1994年 | 30篇 |
1993年 | 20篇 |
1992年 | 15篇 |
1991年 | 19篇 |
1990年 | 12篇 |
1989年 | 7篇 |
1988年 | 5篇 |
1987年 | 1篇 |
1986年 | 3篇 |
1985年 | 3篇 |
1984年 | 2篇 |
1983年 | 4篇 |
1982年 | 2篇 |
1981年 | 1篇 |
1979年 | 8篇 |
1959年 | 1篇 |
排序方式: 共有6798条查询结果,搜索用时 15 毫秒
1.
采用天然黄原胶对黏土进行加固,通过一系列无侧限抗压强度试验,对不同养护时间和黄原胶掺量条件下改良黏土的无侧限抗压强度特性进行试验研究,并对其加固机理进行较为深入的分析。试验结果表明:黄原胶作为添加剂可以在很大程度上提高黏土的无侧限抗压强度;随着黄原胶掺量和养护时间的增加,改良黏土试样的抗压强度也随之增加,并最终趋于稳定;黄原胶改良黏土的最适宜掺量是1.5%,最佳养护时间是14 d,当养护时间为14 d时,黄原胶掺量0.5%、1.0%、1.5%和2.0%的改良黏土样抗压强度相对素土样分别增加13.43%、20.85%、29.87%和34.70%。黄原胶基质通过增强黏土颗粒相互间的粘聚作用,增强了土样的整体性,从而达到增强黏土样抗压强度的目的。 相似文献
2.
综合运用薄片鉴定、扫描电镜、恒速压汞、X衍射、流体包裹体测温、激光拉曼成分分析及伊利石同位素测年等技术方法,分析了东海陆架盆地西湖凹陷中北部花港组储层致密化过程,并探讨了储层致密化控制因素。花港组储层非均质性受孔喉结构控制,喉道半径小于1 μm即为致密储层;埋藏压实是储层普遍低渗、致密的主因,差异成岩作用加剧了储层的差异演化,当地温超过160℃,环边绿泥石对胶结作用的抑制明显减弱,中成岩B期碱性封闭环境使得大量含铁碳酸盐、绒球状绿泥石及搭桥状伊利石富集直接堵塞喉道,造成花港组储层规模性致密。对花港组储层关键成岩期演化过程进行恢复,推测花港组H4、H5砂层组在9~7 Ma进入规模性致密,龙井运动强烈侧向挤压加速了致密化进程。 相似文献
3.
4.
为了探寻黏土强度时效性的微观机理,将时效强度与板状黏土颗粒搭接方式和相互作用势能联系起来,颗粒间的相互作用力使颗粒朝着势能较低的位置搭接,当颗粒间相互作用势能最低时,时效强度达到稳定值。提出了可考虑两板状颗粒间夹角θ和距离d影响的颗粒相互作用总势能公式,可用Zeta电位代替表面电位来计算势能,计算结果与实际情况相吻合。通过计算可知:①黏土时效强度与电解质浓度有很大关系,电解质浓度较低时(≤10-3mol/L),两颗粒相互垂直时的总势能最低;电解质浓度较高时(≥10-1mol/L),两颗粒相互平行时的总势能最低,时效强度几乎不变,甚至会减小;中间电解质浓度是过渡状态;②两黏土颗粒的稳定搭接方式主要是垂直和平行,两颗粒之间总会趋于向稳定搭接方式转化,这也是时效强度经历一定时间而达到稳定值的过程;③解释了黏土触变强度恢复的原因,即颗粒会一直趋于搭接强度最高的垂直稳定搭接。 相似文献
5.
为研究粘粒对土体管涌发生发展的影响以及管涌破坏后的力学性质,配置不同粘粒含量的土样,进行室内管涌试验模拟,并取破坏后的土样进行三轴压缩试验。对各土样水力梯度-流速曲线、应力应变曲线进行分析,研究结果表明:(1)含粘粒土样的临界水力梯度和开始发生管涌破坏时的水力梯度与粘粒含量呈负相关,破坏时流速与粘粒含量呈正相关。(2)管涌后的土体,土层深度越深,土体细颗粒流失量越大,土体的强度损失越大,土体应变软化趋势越不明显。(3)粘粒含量对土体细颗粒流失起到促进作用,使得管涌后含粘粒的土样强度损失更大,粘粒含量越大,这种促进作用越明显,强度损失越大。 相似文献
6.
T.V. Vakalova L.P. Devyashina Sh.M. Sharafeev N.P. Sergeev 《Ceramics International》2021,47(11):15282-15292
One of the drawbacks of fusible clays is the narrow sintering interval due to a sharp increase in the amount of iron-silicate melt at a temperature of 1000–1100 °C, which hardens in the form of a glass phase upon cooling. This leads to a relatively low mechanical strength of the calcined samples and causes the danger of melting the granular material surface from such clays during the firing process. To increase the strength of samples of fusible clays, the influence of diabase and granitoid rocks was considered. It was found that the strengthening effect of diabase and granitoid rock additives in an amount of 20–50% in a mixture with fusible clay is due to an increase of total content of the crystalline phase (mullite, cristobalite and residual quartz) from 18–20% in clays without additives to 22–28 % - in mixtures with diabase and to 28–34% - with granitoid additives) at a temperature of 1050–1100 °C. This increase is due to the activation of synthesis processes of secondary mullite and crystallization from alkali-rich feldspar melt of amorphous silica, released from the structure of clay minerals. The established influence of the igneous rocks used made it possible to develop compositions and propose process flow sheet for producing aluminosilicate proppants based on fusible clays. The use of granitoid and diabase rocks in an amount of 20–70% with fusible clays produces lightweight aluminosilicate proppants with bulk density of 1.40–1.46 g/cm3 at temperature range of 1050–1100 °C, which can endure destructive pressures up to 34.5–52 MPa. 相似文献
7.
研究了石粉中含不同黏土矿物种类和含量的泥粉与亚甲蓝值的相互关系,探究不同黏土矿物吸附性能对亚甲蓝(MB)值的影响。结果表明:随着纯石粉含量的增加,MB值逐渐增大,但也远小于1.00,增幅较小、变化不大。纯泥粉和混合泥粉对MB值影响较大,呈现出线性关系;蒙脱土和以蒙脱土为主的混合泥粉对MB值影响最大,分别高达8.00、4.20;高岭土、伊利土的MB值最大为1.75、1.05,而以其为主要成分的2种混合泥粉MB值最大为2.10、1.95,影响相对较小;含有不同黏土矿物成分的混合泥粉较纯泥粉,能更好的减少对MB值的影响。与纯石粉相比,亚甲蓝对黏土矿物变化较为敏感,由大到小顺序为:蒙脱土、高岭土和伊利土,即蒙脱土的吸附能力最强。 相似文献
8.
为了分析新场气田沙二段气藏不同砂组之间产能差异较大的原因,本文利用物性分析和气水两相渗流实验,对覆压渗透率和气水两相渗流特征进行了评价和研究。结果表明,常规岩心物性证实主力层和难采层砂组渗透率平均值基本接近,但在覆压条件下,主力层和难采层渗透率差异明显;黏土矿物含量越高且产状越复杂,喉道越细小,喉道闭合越大,渗透率降低幅度越大,应力敏感性越强。难采层气相相对渗透率最大值低,临界含水饱和度高,水相上升快且相对渗透率最大值比主力层高。在开发过程中,难采层气井见水早,产水量比主力层大,井底积液、水锁伤害比主力层严重。 相似文献
9.
10.
《Ceramics International》2022,48(22):33167-33176
This study evaluates the luminescence performance of fired clay bricks coated with SrAl2O4:Eu/Dy phosphor. To do so, SrAl2O4:Eu/Dy phosphor was first produced using the traditional solid-state reaction synthesis technique. The prepared phosphor was then used for coating fired clay bricks to analyze the luminescence performance via spectral analysis, decay characteristics, and microstructure of the bricks. The results reveal that excitation and emission spectra of the phosphor coated bricks range from 200 to 480 nm and 455 to 650 nm, respectively, suggesting that the phosphor coated bricks have the capacity of absorbing light with a wide range of wavelengths. The peak wavelength projected at 511 nm in the emission spectrum is achieved, which indicates 4f65 d1-4f7 transition of Europium (Eu2+). The repeated excitation and deexcitation of Eu2+ by using hole traps and trap levels offered by Dysprosium (Dy3+), exist between the ground and the excited state of Eu2+ leads to luminescent phenomenon. Moreover, the decay characteristics has revealed that phosphor coated bricks can emit light for a considerable amount of time (>8.5 min) upon the removal of the excitation source. The results reveal that phosphor coated bricks has the potential of increasing energy efficiency of residential and commercial buildings. 相似文献