全文获取类型
收费全文 | 22193篇 |
免费 | 2624篇 |
国内免费 | 1859篇 |
专业分类
电工技术 | 2378篇 |
技术理论 | 3篇 |
综合类 | 2830篇 |
化学工业 | 1525篇 |
金属工艺 | 1434篇 |
机械仪表 | 1616篇 |
建筑科学 | 3397篇 |
矿业工程 | 1861篇 |
能源动力 | 760篇 |
轻工业 | 347篇 |
水利工程 | 1168篇 |
石油天然气 | 1317篇 |
武器工业 | 515篇 |
无线电 | 1192篇 |
一般工业技术 | 2918篇 |
冶金工业 | 902篇 |
原子能技术 | 277篇 |
自动化技术 | 2236篇 |
出版年
2024年 | 22篇 |
2023年 | 292篇 |
2022年 | 640篇 |
2021年 | 824篇 |
2020年 | 869篇 |
2019年 | 750篇 |
2018年 | 550篇 |
2017年 | 766篇 |
2016年 | 803篇 |
2015年 | 886篇 |
2014年 | 1442篇 |
2013年 | 1498篇 |
2012年 | 1714篇 |
2011年 | 1836篇 |
2010年 | 1370篇 |
2009年 | 1460篇 |
2008年 | 1274篇 |
2007年 | 1428篇 |
2006年 | 1402篇 |
2005年 | 1122篇 |
2004年 | 934篇 |
2003年 | 813篇 |
2002年 | 711篇 |
2001年 | 538篇 |
2000年 | 452篇 |
1999年 | 392篇 |
1998年 | 298篇 |
1997年 | 271篇 |
1996年 | 217篇 |
1995年 | 206篇 |
1994年 | 156篇 |
1993年 | 120篇 |
1992年 | 112篇 |
1991年 | 83篇 |
1990年 | 74篇 |
1989年 | 61篇 |
1988年 | 59篇 |
1987年 | 26篇 |
1986年 | 19篇 |
1985年 | 24篇 |
1984年 | 19篇 |
1983年 | 20篇 |
1982年 | 11篇 |
1981年 | 7篇 |
1980年 | 8篇 |
1979年 | 17篇 |
1963年 | 7篇 |
1960年 | 8篇 |
1959年 | 8篇 |
1955年 | 7篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
1.
硅橡胶复合绝缘子因其优异的憎水性及憎水迁移性而具备较好的防污闪能力,往往作为应对污闪事故的首选方案。但在部分特殊工业粉尘地区,复合绝缘子在短时间运行后会出现爬电及蚀损现象,并发展为绝缘失效。为研究特殊工业粉尘地区复合绝缘子的腐蚀失效过程,测试了某特殊工业园区内运行的复合绝缘子的表面污秽度及污秽成分、污闪电压梯度、憎水性能及微观性能,并分析了其腐蚀失效过程。主要结论如下:绝缘子表面等值盐密为0.1~0.2 mg/cm2,其污秽成分与化工污源类似;存在自然污秽时绝缘子表面憎水性良好,但其憎水性的减弱、恢复及迁移特性均不能满足运行要求;绝缘失效的起因是电晕放电导致憎水性降低,进而导致伞裙电蚀损,最后发展为绝缘失效。 相似文献
2.
3.
某飞机用30CrMnSiA钢沉头螺栓在拆卸过程中发生断裂,同炉批未曾使用的螺栓经磁粉检测也存在裂纹。为查找失效分析原因,通过对断裂件和同炉批开裂的螺栓外观检查、断口宏微观分析、能谱分析、硬度检测、金相分析等方法对断裂和开裂的螺栓进行了分析。结果表明:断裂螺栓和开裂螺栓断裂类型为氢脆,螺栓氢脆断裂主要与抗拉强度和热处理工艺有关,通过改善热处理工艺参数,适当降低螺栓的强度,增加酸洗后的除氢时间降低氢含量,从而避免氢脆发生的可能性。 相似文献
4.
为了获取TC11钛合金拉伸性能随应变率的变化规律,对该材料开展了宽应变率范围下的单轴拉伸试验。结果表明,随着应变率从准静态增加到动态,TC11钛合金的屈服强度略有上升,而应变硬化模量下降。此外,在准静态和动态拉伸下,TC11钛合金均发生了剪切断裂,但动态断裂面上韧窝尺寸小于准静态断面上韧窝尺寸。进一步对材料在变形过程中的温升进行了分析,结果发现,高应变率下材料断裂面上更小尺寸的韧窝和材料更容易发生应变软化归因于动态加载情况下材料中产生了更高的温升。 相似文献
5.
6.
7.
8.
9.
Andrew P. Karman Susan E. Ebeler Nitin Nitin Stephanie R. Dungan 《Journal of the American Oil Chemists' Society》2021,98(10):979-992
Using headspace solid-phase microextraction (HS–SPME), equilibrium distributions could be determined for hydrophobic solutes in closed systems containing vapor and aqueous solution, either in the absence or presence of two short-chain phospholipids, dihexanoyl-phosphatidylcholine (diC6PC) and diheptanoyl-phosphatidylcholine (diC7PC). Without phospholipid, HS–SPME with short extraction times was used to measure water–vapor partition coefficients for d-limonene at five temperatures within 15–40°C, with results in good agreement with existing literature. The temperature dependence of yielded the enthalpy of volatilization 34.5 kJ/mol for limonene. At 25°C, solubility values for d-limonene, 1-octanol, and n-decane were obtained using similar measurements above aqueous solutions of various solute concentrations. Short-time HS–SPME extraction of limonene in closed vials containing diC6PC or diC7PC micelles was also used to evaluate distributions of solute between vapor, aqueous dissolution, and micelles, for various surfactant concentrations at 15–40°C. Resulting vapor phase concentrations were analyzed using a mass balance and measured values, to obtain micelle–water partition coefficients and critical micelle concentrations. in diC6PC solutions (1–2 mM−1) weakly increased with temperature, but decreased significantly with increased temperature for diC7PC micelles (2–4 mM−1). Solubilization in short-chain PC micelles has previously received little attention, and our results show that the extent of partitioning into these diacyl (i.e., two-tailed) lipids is comparable to that for single-tailed anionic or nonionic surfactants. 相似文献
10.