三氯乙酸终止液对木瓜蛋白酶酶活测定的影响研究

本实验研究了不同的三氯乙酸终止液,对木瓜蛋白酶酶活的影响。通过使用两种检测方法,不同配方的三氯乙酸终止液进行实验。结果表明,使用两种不同配方的三氯乙酸终止液所得的结果相差2倍多。用不同稀释浓度的三氯乙酸终止液,在高浓度时,不同浓度的三氯乙酸终止液得到的结果差别很大,随着三氯乙酸浓度的降低,所测得的酶活不断升高;但是在低浓度时,不同浓度的三氯乙酸终止液得到的结果差别不大。     

黑龙江省节水增粮行动(2012—2015年)实施方案

文章通过对黑龙江省高效节水现状,存在问题的分析,结合黑龙江省高效节水发展的支撑能力,阐述黑龙江省节水增粮目标、任务及总体布局,为黑龙江省2012—2015年节水增粮实施提供依据。     

Annular‐ring slot antenna designs with circular polarization radiation

The design of a microstrip‐fed annular‐ring slot antenna (ARSA) with circular polarization (CP) radiation is initially studied. To obtain CP radiation with broad 3‐dB axial ratio (AR) bandwidth that can cover the WiMAX 2.3 GHz (2305–2320 MHz, 2345–2360 MHz) and WLAN 2.4 GHz (2400–2480 MHz) bands, a novel technique of extending an inverted L‐shaped slot from the bottom section of the annular‐ring is proposed. To suppress the harmonic modes induced by the CP ARSA, the technique of integrating a defected ground structure into the annular‐ring slot is further introduced. From the measured results, 10‐dB impedance bandwidth and 3‐dB AR bandwidth of 44.86 and 9.68% were achieved by the proposed harmonic suppressed CP ARSA. Furthermore, average gain and radiation efficiency of ～4.7 dBic and 71%, respectively, were also exhibited across the bands of interest. © 2014 Wiley Periodicals, Inc. Int J RF and Microwave CAE 25:337–345, 2015.     

中原油田岩石可钻性与声波时差关系研究

选取中原油田的大量岩心，采用常规岩石力学测试方法测定了岩石的可钻性、声波测试方法测定了岩石和岩屑声波时差，通过对测得的岩石可钻性级值和声波时差进行回归拟合，得出了中原油田岩石可钻性与声波时差的关系式。现场应用表明，该关系式较好地反映了中原油田地层岩石可钻性与声波时差的关系，可以在优选钻头时作为参考或直接应用。     

Modeling node mobility for reliable packet delivery in mobile ip networks

In this paper, we analyze node mobility for reliable packet delivery in mobile IP networks. In mobile IP, packets destined to roaming nodes are intercepted by their home agents and delivered via tunneling to their care of addresses (CoA). A mobile node may roam across multiple subnets. At each boundary crossing, a handoff is initiated such that the CoA is updated and a new tunnel is established. We consider both basic mobile IP handoff and smooth handoff. We find that reliable packet delivery in mobile IP networks can be modeled as a renewal process, because the retransmission over a new tunnel after each boundary crossing is independent of the previous history. We then derive the probability distribution of boundary crossings for each successful packet, based on which the packet reliable delivery time can be obtained. Our analytical model is derived based on a general distribution of residence time in a subnet and a general distribution of successful retransmission attempts in each subnet. The results can be readily applied to any distributions for both items. We also provide numerical examples to calculate the probability distribution of boundary crossings, and conduct simulations to validate our analytical results     

射频电缆组件组装工艺浅谈

近年来国内外射频电缆组件的发展很快,射频电缆组件的性能不断提高,对射频电缆组件组装工艺也提出了更高的要求.射频电缆组件组装过程多是手工操作,产品的一致性及性能很难控制,要求有良好的工艺保证,为此介绍了射频电缆组件组装工艺,包括电缆的裁剪及剥皮、内导体的连接、外导体的连接和电气性能的测试;探讨了在组装过程中应注意的问题,以及针对内导体焊接易出现虚焊问题进行研究.     

Dissolution processes,hydrolysis and condensation reactions during geopolymer synthesis: Part I—Low Si/Al ratio systems

Initial geopolymeric reaction processes governing dissolution of solid aluminosilicate particles in alkali solutions have been investigated using conventional experimental techniques, and the data analysed by speciation predictions of the partial charge model (PCM). For metakaolin powders activated with 5.0 M NaOH, solid-state nuclear magnetic resonance (NMR) spectra disclose the existence of monomeric [Al(OH)₄]⁻ species after two hours of dissolution, consistent with PCM predictions. However, no equivalent monomeric silicate species were observed for 5.0–10.0 M NaOH activator solutions characteristic of systems with nominal Si/Al ≤ 1. The apparent absence of monomeric silicate species suggest rapid condensation of silicate units with [Al(OH)₄]⁻ to generate aluminosilicate species, as indicated by the evolution of the shoulder at around −87 ppm in the ²⁹Si NMR spectra. Of the two possible stable silicate species [SiO₂(OH)₂]²⁻ and [SiO(OH)₃]⁻, the latter appears most likely to condense with [Al(OH)₄]⁻ to produce aluminosilicate oligomers, from which larger oligomers subsequently form through further condensation with [Al(OH)₄]⁻ leading to a gradual build up of aluminosilicate networks and a lowering of system alkalinity. This dissolution and hydrolysis sequence at the early stages of synthesis suggests a reaction path wholly consistent with predictions of the partial charge model.     

负载化非茂单活性中心催化剂乙烯聚合的研究

在硅胶上负载了双(N-环己基-3-叔丁基水杨醛亚胺基)二氯化锆配合物,得到负载化非茂单活性中心催化剂。该催化剂用于乙烯聚合,考察了配合物用量、共聚单体1-己烯用量、聚合温度、聚合压力、聚合时间、三乙基铝用量对乙烯聚合性能的影响及对聚合物的相对分子质量、相对分子质量分布、熔体流动指数和密度的影响。实验结果表明,负载化非茂单活性中心催化剂保持了原均相催化剂的乙烯聚合性能;该催化剂在淤浆聚合工艺中聚合平稳,所得聚合物的颗粒形态良好。     

Use of Fiber Bragg Grating Sensors for Determination of a Simply Supported Rectangular Plane Plate Deformation

A measurement method has been developed to determine the full-field deformation of a simply supported plane plate under transverse load. The method utilizes strain information provided by a set of four fiber Bragg grating sensors mounted on the plate in a way that all sensors measure strains along one certain direction. The sensors were interrogated using a wavelength swept fiber laser. Utilizing the strain information and the first four terms of Navier solution of simply supported rectangular plate, the necessary parameters for determining the deflection could be computed. By substituting the values of x- and -y- coordinates of each position on the rectangle plate, the full-field deformation information can be obtained. Single-point loading tests were experimentally performed to verify the accuracy of the method.     

High-yield synthesis of single-crystalline 3C-SiC nanowires by a facile autoclave route

Single-crystalline 3C-SiC nanowires have been synthesized in large scale through a one-step autoclave route by the reaction of SiCl₄, (C₅H₅)₂Fe and metallic Na at 500 °C. Electron microscopy investigations show that the nanowires have typical diameters of 15-50 nm, lengths up to several tens of micrometers and grow along the [111] direction. The possible growth mechanism of the nanowires is discussed.