Microbial fuel cell (MFC)-based biosensor for combined heavy metals monitoring and associated bioelectrochemical process

To explore the feasibility and related mechanism of MFC biosensor for wastewater detection under the action of combined heavy metals. Cyclic voltammetry (CV) and scanning electrochemical impedance spectroscopy (EIS) were used to explore the related bioelectrochemical process. The response of the reactor to single/combined heavy metals, low/high heavy metal concentrations, and the differences in ohmic resistance (Rs) and charge transfer resistance (Rct) were investigated using Ni as the core heavy metal and the combined action of Cd, Cu and Zn. The results indicated that there was a linear relationship between the concentration and output voltage of the MFC biosensor under the action of combined heavy metals (R² = 0.8803–0.973). However, the internal resistance (Rint) of the MFC biosensor under the action of single heavy metal was far less than that of the combined heavy metal group, and the power density (19.849 W m^?3) was 4 times that of the combined heavy metal group (3.109–4.589 W m^?3). The Rs of the biosensors in the combined heavy metal group were 0.868Ω and 0.860, which were higher than 0.768Ω of the single heavy metal sensor. With the increase of the concentration of heavy metals in the influent, the increase of Rct was more obvious in the combined group, while the Rs in the single group significantly increased (P < 0.05). The results imply that it is possible for MFC biosensors to be used in the detection of actual water polluted by various heavy metals, but the biosensor performance is mainly limited by Rct, which needs to be further improved.     

A NEW OIL SEEPAGE IN THE OMAN MOUNTAINS AND ITS GEOLOGICAL,GEOCHEMICAL AND PETROLEUM SYSTEMS CONTEXT

A minor natural oil seepage is described from an unlikely setting in the Oman Mountains. The host rocks are fractured pelagic limestones of the lower member of the Triassic – Lower Jurassic Matbat Formation of the Hamrat Duru Group in the lower part of the allochthonous Hawasina Complex. This paper summarises Oman's established oil families and documents previously recorded oil seepages as context for describing the new seepage, its geochemistry, and possible source rock. The seep oil is different to those known from Oman's oil fields and probably derived from a poor quality, Mesozoic clastic source rock containing a mix of terrigenous and marine organic matter. The most likely source appears to be the Toarcian turbiditic upper member of the Matbat Formation, equivalent to the clastic Mafraq Formation of the Arabian Platform. The occurrence of source rocks in the allochthonous sediments of the NeoTethyan Hawasina Basin has been suspected previously, though their commercial significance remains to be established.     

水力空化改质对重质原油沥青质及性质的影响

利用水力空化过程产生局部的高温、高压、高射流以及强大的剪切力等极端化学物理条件改质处理沙特重质原油，试验结果表明：沙特重质原油经过水力空化改质后粘度由13.61降低至7.22mm2/s，残碳由7.16%降低至6.48%，实沸点蒸馏后减压渣油降低1个百分点。进一步采用APPI FT-IR MS、XRD、FT-IR、SEM和粒度分布等技术研究了水力空化改质对沙重原油分子组成，沥青质团聚体微晶结构、沥青质胶束粒径分布、沥青质官能团、沥青质形貌等方面的影响，从分子角度阐述空化改质重油的机理。研究结果表明：水力空化改质后沙重原油分子量分布、芳烃类化合物缔合作用变小；沥青质对低DBE化合物吸附性能降低；沥青质团聚体微晶结构更加松散；沥青质胶束粒度分布降低；沥青质分子相互团聚作用力减弱。进一步考察了水力空化改质前后减压渣油延迟焦化性能，改质处理后焦炭产率降低1.85个百分点，液体收率和气体产率分别增加1.52和0.33个百分点，水力空化改质对沥青质性质、结构特点的改善能够有效的提高其加工性能。     

济阳坳陷页岩油储层矿物组分最优化反演方法

针对页岩油储层矿物组分复杂多样、矿物体积含量模型不统一、矿物组分准确定量评价困难等问题,以济阳坳陷陆相页岩油储层的岩心X衍射全岩矿物岩心分析和薄片鉴定等实验资料为基础,引入有机骨架,构建页岩油储层“双骨架”矿物组分岩石物理体积模型,在经过储层三孔隙度校正之后,采用最小二乘法-奇异值分解最优化反演方法计算页岩油储层有机骨架和无机骨架矿物组分体积含量。研究表明,采用最优化反演方法计算得到的矿物体积含量与X衍射测量结果相关性达到0.60以上,并在实际井中得到验证应用。研究成果可为页岩油储层精细评价提供有力支撑。     

Antioxidant Activity of Piceatannol in Canola Oil

Piceatannol has shown to be a strong antioxidant in vivo, however, its ability to suppress lipid oxidation in foods has not been examined. The present study is to examine the antioxidant effect of piceatannol on heated canola oil compared with that of butylated hydroxytoluene (BHT). The oxidation of canola oil is conducted at 60, 90, 120, and 150 °C by monitoring the depletion of oxygen, the decrease in unsaturated fatty acids, and the changes of primary and secondary oxidation products. Results demonstrated that piceatannol can suppress lipid oxidation of canola oil in a dose-dependent manner with its effect being more effective than BHT. Practical Applications: Lipid oxidation is a major factor in the deterioration of food quality. Synthetic antioxidants, such as BHT and butylated hydroxyanisole, are used to inhibit oxidation in foods, but their safety has been always concerned. Piceatannol has exhibited a strong antioxidant activity to attenuate lipid oxidation and it should be further explored for use as a natural antioxidant in foods.     

核磁共振波谱法测定臭氧化橄榄油中的活性成分含量

以橄榄油为原料,经臭氧氧化制备臭氧化橄榄油。利用核磁共振(NMR)采集碳谱数据,积分碳谱特征峰,计算橄榄油被氧化成分的相对含量。结果表明:臭氧化橄榄油与橄榄油碳谱有明显的区别,臭氧化橄榄油在δ103.1处出现新峰,对应δ130.1处的峰高减弱,这是由于橄榄油中的不饱和双键被氧化。采用该方法测得5个臭氧化油中活性成分含量分别为21.46%、21.03%、21.31%、18.71%和24.42%。采用核磁共振波谱法测定臭氧化橄榄油的活性成分含量具有操作简单,不需要预处理,结果可靠的优点。     

无黏土相盐水储层钻开液体系构建及其抗污染性能评价

采用NaCl/KCl/HCOONa复配欠饱和盐水作为钻开液的基础液相,自研的聚合物VIS-B作为流型调节剂,可酸溶的改性淀粉STA作为体系的降失水剂,Dua及Jqw作为暂堵材料,构建了一套无黏土相钻开液体系。该体系在密度1.10~1.28 g/cm^3间稳定可调,抗温可达130℃,具有较高的低剪切速率黏度和较好的润滑性能,且能有效抵抗各类储层污染物的污染,满足了Missan油田不同储层段的作业需求。     

一种植物油中苯并（a）芘含量测定的固相萃取前处理方法

为了建立一种准确性高、成本低的植物油中苯并(a)芘测定的样品前处理方法，基于GB 5009.7—2016以自制氧化铝柱为固相萃取柱，采用单因素试验对称样量、洗脱剂量、洗脱流速、吸附剂存放时间、吸附剂量这5个影响植物油中苯并（a）芘洗脱的因素进行研究，优化前处理条件，并对测定方法进行考察。结果表明：优化的前处理条件为称样量0.100 0 g、洗脱剂量120 mL、吸附剂（氧化铝）量22 g、洗脱流速1滴/2 s、吸附剂存放时间少于12周；方法检出限为0.2 μg/L，样品加标回收率为94.23%～100.00%，RSD为1.20%～7.36%；同一样品测定结果与SGS测定值接近，相对平均偏差为2.36%～3.50%。说明本试验方法测定结果准确，可应用于油脂企业植物油中痕量苯并（a）芘的测定。     

Heterogeneously Catalyzed Methanolysis of Gmelina Seed Oil to Biodiesel

The heterogeneous catalysis of transesterification of gmelina seed oil to biodiesel is evaluated. The oil was extracted from the seeds with n‐hexane by solvent extraction and characterized to determine its physiochemical properties. Response surface methodology was applied to optimize the effect of process variables on the biodiesel yield. The base‐activated clay catalyst performed as montmorillonite clay with the characteristic property of a Brønsted acid. It has an improved surface area after activation that enhanced its catalytic activity on transesterification reaction. Under optimal conditions, the biodiesel yield was 70.1 %, thus demonstrating that the model predicted well the biodiesel production.