首页 | 本学科首页   官方微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   367篇
  免费   40篇
  国内免费   3篇
电工技术   6篇
综合类   4篇
化学工业   92篇
金属工艺   20篇
机械仪表   31篇
建筑科学   2篇
矿业工程   1篇
能源动力   20篇
武器工业   4篇
无线电   78篇
一般工业技术   66篇
冶金工业   3篇
原子能技术   5篇
自动化技术   78篇
  2025年   6篇
  2024年   10篇
  2023年   52篇
  2022年   32篇
  2021年   32篇
  2020年   18篇
  2019年   12篇
  2018年   18篇
  2017年   33篇
  2016年   32篇
  2015年   33篇
  2014年   17篇
  2013年   11篇
  2012年   12篇
  2011年   3篇
  2010年   8篇
  2009年   15篇
  2008年   5篇
  2007年   10篇
  2006年   10篇
  2005年   6篇
  2004年   3篇
  2003年   1篇
  2002年   6篇
  2001年   2篇
  2000年   1篇
  1999年   3篇
  1997年   1篇
  1996年   1篇
  1995年   1篇
  1994年   2篇
  1992年   1篇
  1987年   4篇
  1986年   2篇
  1984年   1篇
  1981年   1篇
  1972年   1篇
  1966年   1篇
  1965年   1篇
  1964年   1篇
  1960年   1篇
排序方式: 共有410条查询结果,搜索用时 0 毫秒
1.
《Ceramics International》2016,42(9):10758-10763
Large size Ba4.2Nd9.2Ti18O54 (BNT) ceramics doped with MnCO3, CuO and CoO were prepared by the conventional solid-state method. Only a single BaNd2Ti4O12 phase was formed in all samples. No second phase was found in the XRD patterns. The bulk density increases slightly because of the dopants. The SEM results showed that the grain size of Mn2+and Cu2+-doped BNT ceramics became larger with the increasing amount of dopants. The permittivity of all samples stays the same. However, the Q×f value of BNT ceramics increases by doping, especially with Mn2+ ions. The conductivity of BNT ceramic doped with Mn2+(0.5 mol‰) under high temperature is lower than that without doping. There are fewer defects in Mn2+-doped BNT ceramics. The XPS results indicated that Ti reduction was suppressed in BNT ceramics doped with 0.5 mol‰ Mn2+. BNT ceramics doped with 0.5 mol‰ Mn2+ ions sintered at 1320 °C for 2 h exhibited good microwave dielectric properties, with εr=88.67, Q×f=7408 GHz and τf = 82.98 ppm/°C.  相似文献   
2.
    
《Thin solid films》2006,515(2):615-618
Silver tantalate AgTaO3 (ATO) and silver niobate AgNbO3 (ANO) films have been grown on to the LaAlO3 (001) and sapphire Al2O3 (0112, r-cut) single crystals by pulsed laser deposition technique from stoichiometric ATO and ANO targets. X-ray diffraction study revealed epitaxial quality of ATO and ANO films on the LaAlO3 (001) whereas on the sapphire r-cut substrate they are preferential (110) and (001) oriented. To characterize microwave films properties in the range from 1 to 40 GHz, coplanar line interdigital capacitors were fabricated by photolithography and lift-off technique. ANO film capacitors show superior properties: frequency dispersion was as low as 13%, voltage tunability (40 V, 200 kV/cm) was about 4.6% at 20 GHz, loss tangent ∼0.106 at 20 GHz, K-factor = tunability / tanδ from 49% @ 10 GHz to 33% at 40 GHz.  相似文献   
3.
    
For the first time, the results of single crystal determination of the true Nasicon are given. The structure refinement yielded the following composition: Na3.09(8)Zr2.01(1)P0.91Si2.09O12. Evidence of the total occupancy of the Zr octahedron is found, displaying that only the Si/P non-stoechiometry mechanism is present in the Nasicon crystal.For the two temperatures which have been investigated (R.T. and 623K), the structures are very close to that of the Nasicon analog: Na3Sc2P3O12. However the Si/P substitution prevents the sodium long range ordering even in the monoclinic low temperature phase and therefore the cross over to the rhombohedral symmetry only involves very small atomic displacements. For both structures, a new sodium position (mid-Na) is displayed in the conduction channel, intermediate between the usual Na(1) and Na(2) sites.  相似文献   
4.
5.
文中针对某宇航相控阵天线在随机振动验收试验过程中的振动故障,首先通过罗列故障树和摸底试验进行故障定位,分析认为DSP芯片引脚在振动过程中应力过大是造成其开裂的主要原因;然后通过有限元法计算试验条件下DSP芯片引脚处的加速度和应力响应,仿真结果与试验结果比较一致;最后根据有限元模型开展相控阵天线主结构的优化设计,增加主结...  相似文献   
6.
基于FSVM的转炉终点光辐射状态识别   总被引:1,自引:0,他引:1       下载免费PDF全文
周木春  赵琦  陈延如  邵艳明 《红外与激光工程》2018,47(7):726004-0726004(6)
针对转炉冶炼终点传统人工肉眼看火判断存在着诸多不确定性问题,研究了一种基于模糊支持向量机的光辐射状态识别实现转炉终点判断的方法。设计了非接触式炉口光辐射采集系统,基于炉口火焰辐射规律分析,分别提取了通过高斯函数拟合表征光谱整体特征的三参数和两个发射峰离散谱参数作为支持向量机的输入,通过相关性分析选出生产过程中氧量、动枪幅度、爽枪时间、加料量参数构建子样本特征量,采用样本到类间距离的方法计算隶属度因子,建立了模糊支持向量机识别模型并进行了测试实验。实验结果表明,提出的方法对不同操作工况下的终点光辐射识别精度优于人工方法和传统SVM方法,可为转炉终点的准确判断提供依据。  相似文献   
7.
基于ARM的GPRS远程数据传输模块设计   总被引:8,自引:0,他引:8  
讨论了一种基于ARM的GPRS远程数据传输方案,为了实现野外环境的远程监测,依托现有移动通信GSM网络的GPRS服务作为数据传输的通道,硬件系统采用功能强大的S3C44B0X ARM7嵌入式系统作为数据传输的控制中心,GPRS模块采用内置TCP/IP协议的SIM300作为数据传输的工具,从而既保证了数据传输的实时性和可靠性,而且非常经济实用.  相似文献   
8.
星载天线在发射及在轨阶段将面临严酷的力学环境,要求具有极高的可靠性。为了验证其刚度和强度,缩短研发周期,文中采用NX Nastran软件建立了某星载大口径天线子系统的力学仿真模型;为了验证仿真的有效性,进行了该天线子系统的模态测试,经对比发现两者数据一致性较好;基于建立的有限元模型,分析了该天线子系统在正弦振动和热循环环境工况下的结构响应和受力情况,得到了相应的加速度、位移和应力云图。结果表明,该天线子系统的结构刚强度均满足星载环境要求。该仿真分析对星载天线子系统的结构设计具有重要的指导意义。  相似文献   
9.
针对目前现场总线技术无法满足工业控制领域对信息传输的速率以及信息传输实时性的较高需求,PROFINET实时协议迅速发展起来,该协议在通信方面较现场总线技术有更好的实时性以及更高的传输速率;首先对标准TCP/IP协议进行了研究,分析了PROFINET对标准TCP/IP协议的优化方式;然后详细介绍了PROFINET RT和PROFINET IRT的帧结构以及基于具体数据的实时性分析,为西门子STEP7对PROFINET的组态配置提供了一定的借鉴作用;最后采用西门子的PROFINET IO设备、IO控制器等,通过STEP7的组态配置,验证了PROFINET IO之间的通信。  相似文献   
10.
随着集成电子等技术逐渐成熟,无人飞行器得到了广泛的关注和应用;其中,由于飞行器在飞行阶段具有高响应速度、耦合动力学和非线性等特点,使其在飞行阶段的姿态控制成为该领域重点研究的方向之一;针对该研究方向,文章提出了一种基于反步法技术的反馈线性化无人飞行器姿态跟踪控制方案来解决其在受到环境干扰的条件下可以精准跟踪姿态角度的问题;在该方法中,设计了反步法技术拆分简化模型和反馈线性化减少调节参数,并利用扩张状态观测器(ESO)来对扰动进行估计和补偿,同时给出了ESO的收敛性和闭环系统的稳定性来证明该方法的可实施性;最后给出了仿真结果,验证了该方法在干扰的环境下仍可以精准控制无人飞行器姿态。  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司  京ICP备09084417号