Determination of the width of the transition layer between the crystalline and amorphous zones in nylon 1010 by SAXS

The width of the transition layer between the crystalline and amorphous zones in nylon 1010 was determined by SAXS with point collimation and long-slit collimation, respectively. The width of the transition layer, E, was found to be 1.7 nm. The results show that the width of the transition layer is independent of crystallinity.     

泥沙输移矢量式及其应用

本文基于Parker等人泥沙输移矢量式的分析和研究，增加了上举力的作用，并考虑了泥沙颗粒受力非平衡条件，采用牛顿力学的矢量分析法，推导了泥沙输移的通用矢量式。经对公式简化，且用Ikeda和笔者试验资料的验证，证明计算值与试验值吻合较好。     

强度调制／直接检测（IM／DD）光纤通信系统色散限制的研究

通过引入归一化脉宽Ｐ和相对脉冲展宽因子ｑ，提出了一个适用于ＩＭ／ＤＤ系统中各种眼图恶化量ｘ和归一化脉宽Ｐ的色散限制改进公式。通过与其它理论的比较、计算机仿真和对实验数据的分析，验证了该公式的正确性，并给出了其它结果的限制条件。研究表明：当眼图恶化量ｘ为１ｄＢ左右时，对２．５Ｇｂ／；外调制信号（α＝０）而言，非色散位移光纤ＩＭ／ＤＤ系统的色散因子γ约等于０．７９，所对应的系统再生中继距离约为９００余公里。     

Extensions of LDA by PCA mixture model and class-wise features

Linear discriminant analysis (LDA) is a data discrimination technique that seeks transformation to maximize the ratio of the between-class scatter and the within-class scatter. While it has been successfully applied to several applications, it has two limitations, both concerning the underfitting problem. First, it fails to discriminate data with complex distributions since all data in each class are assumed to be distributed in the Gaussian manner. Second, it can lose class-wise information, since it produces only one transformation over the entire range of classes. We propose three extensions of LDA to overcome the above problems. The first extension overcomes the first problem by modelling the within-class scatter using a PCA mixture model that can represent more complex distribution. The second extension overcomes the second problem by taking different transformation for each class in order to provide class-wise features. The third extension combines these two modifications by representing each class in terms of the PCA mixture model and taking different transformation for each mixture component. It is shown that all our proposed extensions of LDA outperform LDA concerning classification errors for synthetic data classification, hand-written digit recognition, and alphabet recognition.     

一种激光测厚装置

介绍一种新型激光测厚装置 ,描述了它的结构框架及工作过程     

Onset of gas self-induction and power consumption after gas induction in an agitated tank

The behavior of inducted gas from liquid surface and the; power requirements in an agitated tank using a mechanical agitator are studied in order to increase the amount of gas self-induction and the gas retention time for gas absorption. A 45° six-blade downward impeller turbine was utilized in this study. Air and water, air and 40 wt% 60 wt%, and 80 wt% of glycerin water, and air and 106 cP silicon oil were employed as gas and liquid phases. Variables which were studied included geometrical factors (immersed depth of impeller, baffle with and diameter of impeller) and the physical properties of the liquid (viscosity, density, and surface tension). The correlations for the onset speed of impeller and power consumption after gas induction in the agitated tank are established from our experimental results. The amount of gas self-induction from the liquid surface in the agitated tank increases with increasing impeller diameter and speed and decreases with increasing baffle width, depth of impeller and viscosity of liquid.     

脉冲啁啾对干涉相关测宽的影响及其消除方法

本文深入讨论了脉冲啁啾的非线性起源及其对干涉相关测宽(等值宽度和条纹计数)法的影响。提出根据干涉相关曲线下包络最大值位置适当降低等值宽度位置和用计算机平均处理干涉相关信息的技术以消除啁啾的影响。     

一种简易可靠的射频激光调制器

采用ＰＩＮ电调衰减器、ＴＬ４９４等元件组成了射频（ＲＦ）大功率ＣＯ２激光调制器，调制频率、占空比和调制度单独可调。给出了电路的工作原理和测试结果。     

Service Load Effective Compression Flange Width in Fiber Reinforced Polymer Deck Systems Acting Compositely with Steel Stringers

This paper reports on the field study of a steel stringer-fiber reinforced polymer (FRP) deck composite bridge in Pennsylvania. The objective of the study is to assess the effective compression flange width in the FRP deck and floor systems when they act compositely with underlying steel girders at service conditions. The research results reported herein support the notion of employing a design approach, for both interior and exterior girders of a composite floor system, that is philosophically consistent with current practice related to steel girders acting compositely with concrete decking. It appears from the results presented herein that FRP decks and floors acting compositely with underlying steel girders exhibit an effective width that is close to the actual girder spacing for interior beams, and approximately one-half this value for exterior beams.