高光谱成像用高帧频CMOS图像传感器北大核心

针对高帧频、全局曝光和光谱平坦等成像应用需求,设计了一款高光谱成像用CMOS图像传感器。其光敏元采用PN型光电二极管,读出电路采用5T像素结构。采用列读出电路以及高速多通道模拟信号并行读出的设计方案来获得低像素固定图像噪声(FPN)和非均匀性抑制。芯片采用ASMC 0.35μm三层金属两层多晶硅标准CMOS工艺流片,为了抑制光电二极管的光谱干涉效应,后续进行了光谱平坦化VAE特殊工艺,并对器件的光电性能进行了测试评估。电路测试结果符合理论设计预期,成像效果良好,像素具备积分可调和全局快门功能,最终实现的像素规模为512×256,像元尺寸为30μm×30μm,最大满阱电子为400 ke^(-),FPN小于0.2%,动态范围为72 dB,帧频为450 f/s,相邻10 nm波段范围内量子效率相差小于10%,可满足高光谱成像系统对CMOS成像器件的要求。     

红外辐射联合回火与冷激杀菌技术对胡萝卜粉品质的影响

首先研究不同红外辐射温度(100,110,120℃)及辐射时间(2.5,5,10 min)对胡萝卜粉微生物及品质的影响,然后根据栅栏效应原理研究红外辐射-回火、红外辐射-冷激联合杀菌对胡萝卜粉微生物、色调值、类胡萝卜素含量等品质的影响。结果表明:100℃、10 min的红外辐射处理使细菌和真菌分别降低了1.9 lg(CFU/g)和2.32 lg(CFU/g),110℃、5 min的红外辐射处使细菌和真菌分别降低了1.58 lg(CFU/g)和2.57 lg(CFU/g)。在上述两种处理条件下胡萝卜粉的水分活度从0.238分别降至0.123和0.147,胡萝卜粉中总类胡萝卜素含量从308.8μg/g降至227.8μg/g和238.8μg/g,色差值(ΔE)为9.11和7.89。与红外辐射单独作用相比,联合回火后的处理没有显著影响细菌数目,处理后保持在5.40~5.80 CFU/g,霉菌、酵母数却在处理过程中显著减少,然而减少量较低,总数仍不低于4.5 lg(CFU/g)。红外辐射-冷激联合处理相比红外辐射单独处理,100℃、10 min联合冷激7 d处理可将细菌数量降低0.25 lg(CFU/g),可将霉菌与酵母数量降低0.28 lg(CFU/g),110℃、5 min联合冷激7 d处可将细菌数量降低0.26 lg(CFU/g),可将霉菌、酵母数量降低0.40 lg(CFU/g),且这些处理下胡萝卜粉的色调值、水分活度、类胡萝卜素含量变化不显著。本试验结果表明,红外辐射-冷激处理具有协同效应,且处理过程中胡萝卜粉的色调值及总类胡萝卜素含量不受影响,这为低水分粉体食品红外辐射联合杀菌提供了参考。     

As the number falls,alternatives to the Hagberg–Perten falling number method: A review

This review examines the application, limitations, and potential alternatives to the Hagberg–Perten falling number (FN) method used in the global wheat industry for detecting the risk of poor end-product quality mainly due to starch degradation by the enzyme α-amylase. By viscometry, the FN test indirectly detects the presence of α-amylase, the primary enzyme that digests starch. Elevated α-amylase results in low FN and damages wheat product quality resulting in cakes that fall, and sticky bread and noodles. Low FN can occur from preharvest sprouting (PHS) and late maturity α-amylase (LMA). Moist or rainy conditions before harvest cause PHS on the mother plant. Continuously cool or fluctuating temperatures during the grain filling stage cause LMA. Due to the expression of additional hydrolytic enzymes, PHS has a stronger negative impact than LMA. Wheat grain with low FN/high α-amylase results in serious losses for farmers, traders, millers, and bakers worldwide. Although blending of low FN grain with sound wheat may be used as a means of moving affected grain through the marketplace, care must be taken to avoid grain lots from falling below contract-specified FN. A large amount of sound wheat can be ruined if mixed with a small amount of sprouted wheat. The FN method is widely employed to detect α-amylase after harvest. However, it has several limitations, including sampling variability, high cost, labor intensiveness, the destructive nature of the test, and an inability to differentiate between LMA and PHS. Faster, cheaper, and more accurate alternatives could improve breeding for resistance to PHS and LMA and could preserve the value of wheat grain by avoiding inadvertent mixing of high- and low-FN grain by enabling testing at more stages of the value stream including at harvest, delivery, transport, storage, and milling. Alternatives to the FN method explored here include the Rapid Visco Analyzer, enzyme assays, immunoassays, near-infrared spectroscopy, and hyperspectral imaging.     

Optimization of room-temperature TCR of polycrystalline La0.9-xSrxK0.1MnO3 ceramics by Sr adjustment

High-density La_0.9-xSr_xK_0.1MnO₃ ceramics (LSKMO, A-site = La, Sr and K, 0 ≤ x ≤ 0.25) are successfully fabricated by using facile sol-gel method. Electrical properties are performed by using combination of phenomenological percolation (PP) model, double exchange (DE) mechanism, and Jahn-Teller (JT) effect. Moreover, X-ray diffraction and scanning electron microscopy are employed to analyze the structure and morphology of LSKMO ceramics. Valence states and ionic stoichiometry are assessed by using X-ray photoemission spectrometry. Results reveal that Sr²⁺ ions, substituting La³⁺ ions, significantly influenced DE mechanism and JT effect. In addition, Sr-doping plays essential role in improving electrical properties of LSKMO ceramics. At optimal doping content of x = 0.09, peak temperature coefficient of resistance (TCR) of the resistivity is found to be 11.56% K^?1 at 297.15 K, which is optimal TCR for A-site K-occupied perovskite manganese oxides. These results confirm that polycrystalline LSKMO ceramics render high room-temperature TCR values due to Sr-doping.     

物料堆场智能化管理经验分享

华润水泥（罗定）有限公司根据物料储存需求，共有三个长堆棚分为9个室内料场堆放原材料及混合材，厂内有4台铲车无规则轮流在这8个料场内作业，同时外来运料货车、公司化验及验收人员也会不间断地进入不同堆棚。由于料场内空间狭窄，驾驶员视线不好，如果堆棚料场内铲车在作业时，有其他人员或车辆进入铲车工作区域共同作业，在没有检测装置对进入的人、车进行识别，提醒铲车驾驶员的情况下，容易发生碾压进入人员或车辆碰撞的安全事故。公司根据现场实际，自2020年起决定实施从堆场出入口智能红外感应技术、装载机车载识别系统、智能声光语音提醒、实时监控显示、照明、堆场硬件设施等五方面实施物料堆场车辆智能化安全预警系统项目。     

Recent advances in rapid and nondestructive determination of fat content and fatty acids composition of muscle foods

Conventional methods for determining fat content and fatty acids (FAs) composition are generally based on the solvent extraction and gas chromatography techniques, respectively, which are time consuming, laborious, destructive to samples and require use of hazard solvents. These disadvantages make them impossible for large-scale detection or being applied to the production line of meat factories. In this context, the great necessity of developing rapid and nondestructive techniques for fat and FAs analyses has been highlighted. Measurement techniques based on near-infrared spectroscopy, Raman spectroscopy, nuclear magnetic resonance and hyperspectral imaging have provided interesting and promising results for fat and FAs prediction in varieties of foods. Thus, the goal of this article is to give an overview of the current research progress in application of the four important techniques for fat and FAs analyses of muscle foods, which consist of pork, beef, lamb, chicken meat, fish and fish oil. The measurement techniques are described in terms of their working principles, features, and application advantages. Research advances for these techniques for specific food are summarized in detail and the factors influencing their modeling results are discussed. Perspectives on the current situation, future trends and challenges associated with the measurement techniques are also discussed.     

Study of macromolecular interactions in low‐fat brined cheese modified with Zedu gum

The functionality of Zedu gum as a fat mimetic in low‐fat brined cheese was studied. The physicochemical, textural, rheological, microstructural and sensory properties of cheese samples modified with 0.1% and 0.25% of Zedu gum were compared to those of control cheeses (low‐fat and full‐fat cheeses with no fat mimetic) during ripening. To obtain further information about the cheeses' structure and interactions between macromolecules (casein protein and Zedu gum), other parameters were analysed by differential scanning calorimetry and Fourier transform infrared (FTIR) spectroscopy. Incorporation of Zedu gum into low‐fat cheese caused an open microstructure and softer texture in comparison with the control low‐fat cheese. The thermal properties and FTIR spectra of the cheeses were influenced by both fat mimetic and ripening time. On days 1 and 60 of ripening time, the lower value of enthalpy of the low‐fat cheese with 0.25 g of Zedu gum/kg of milk (AS 0.25) in comparison with control low‐fat cheese could have been due to the electrostatic nature of the interactions between Zedu gum and casein protein. On both days, the FTIR spectrum of AS 0.25 showed a well separated absorption at 1746 cm^?1 possibly due to the formation of ester groups as a result of the interaction of the carbonyl groups in Zedu gum with the hydroxyl groups of some amino acids in casein.     

红外菲涅尔透镜的注射超声辅助成型优化

为了提升聚合物红外菲涅尔透镜的光学性能,以其表面微沟槽的成型质量为目标,提出了一种高效的注射超声辅助成型方法,并对工艺参数进行了综合质量优化。首先分析了超声振动对聚合物的加热和加压效应,设计了一套一模两腔的对比试验模具;接着以红外菲涅尔透镜的调制传递函数MTF和齿形平均高度h为优化质量目标,设计了四步骤的多目标优化流程,通过试验设计、基于BP神经网络的质量目标与注射工艺参数关系建模、基于NSGA-Ⅱ的多目标优化和试验验证进行工艺参数的综合优化。实验结果表明:该多目标优化流程具有很高的精度,MTF和h的平均预测误差MPE分别为4.16%和3.32%;注射超声辅助成型的菲涅尔透镜微沟槽具有更高的复制质量,其齿沟槽平均高度h增加了15.6%,且h值的波动量随着h值的增大而增大,MTF值受齿高h均匀性的影响大于齿高h对其的影响。