煤泥燃烧过程中汞的迁移行为研究

采用在线汞测试方法，以山西省低热值煤电厂中掺烧的煤泥为研究对象，利用实验室小型流化床，研究煤泥中汞的热转化行为差异及共性特征、影响煤泥热转化过程中汞迁移的关键因素，以揭示煤泥热转化过程中汞污染物的迁移机理。结果表明，同一种煤泥，相同气氛，800、900、1 000 ℃下，燃烧温度对煤泥中的汞的释放比例没有变化；相同温度，汞的释放比例为氮气>空气>氧气。3种煤泥在相同燃烧条件下，汞的释放特征相似，元素汞的释放量和释放比例差异较大。释放量与煤泥中的汞含量正相关，释放比例与煤泥中汞的赋存形态有一定关系。     

Experimental study on mitigating wind erosion of calcareous desert sand using spray method for microbially induced calcium carbonate precipitation

Wind erosion is one of the significant natural calamities worldwide, which degrades around one-third of global land. The eroded and suspended soil particles in the environment may cause health hazards, i.e. allergies and respiratory diseases, due to the presence of harmful contaminants, bacteria, and pollens. The present study evaluates the feasibility of microbially induced calcium carbonate precipitation (MICP) technique to mitigate wind-induced erosion of calcareous desert sand (Thar desert of Rajasthan province in India). The temperature during biotreatment was kept at 36 °C to stimulate the average temperature of the Thar desert. The spray method was used for bioaugmentation of Sporosarcina (S.) pasteurii and further treatment using chemical solutions. The chemical solution of 0.25 pore volume was sprayed continuously up to 5 d, 10 d, 15 d, and 20 d, using two different concentration ratios of urea and calcium chloride dihydrate viz 2:1 and 1:1. The biotreated samples were subjected to erosion testing (in the wind tunnel) at different wind speeds of 10 m/s, 20 m/s, and 30 m/s. The unconfined compressive strength of the biocemented crust was measured using a pocket penetrometer. The variation in calcite precipitation and microstructure (including the presence of crystalline minerals) of untreated as well as biotreated sand samples were determined through calcimeter, scanning electron microscope (SEM), and energy-dispersive X-ray spectroscope (EDX). The results demonstrated that the erosion of untreated sand increases with an increase in wind speeds. When compared to untreated sand, a lower erosion was observed in all biocemented sand samples, irrespective of treatment condition and wind speed. It was observed that the sample treated with 1:1 cementation solution for up to 5 d, was found to effectively resist erosion at a wind speed of 10 m/s. Moreover, a significant erosion resistance was ascertained in 15 d and 20 d treated samples at higher wind speeds. The calcite content percentage, thickness of crust, bulk density, and surface strength of biocemented sand were enhanced with the increase in treatment duration. The 1:1 concentration ratio of cementation solution was found effective in improving crust thickness and surface strength as compared to 2:1 concentration ratio of cementation solution. The calcite crystals formation was observed in SEM analysis and calcium peaks were observed in EDX analysis for biotreated sand.     

载气热提取法测定熔敷金属中扩散氢收集条件的探究

探究了GB/T 3965—2012《熔敷金属中扩散氢测定方法》中载气热提取法收集条件对测定扩散氢含量的影响,并与水银法进行了对比。研究结果表明,样本炉温设定为400℃,A型试块的内部温度大约在51 min时稳定在358℃左右,B型试块内部温度大约在27 min时稳定在391℃左右;载气热提取法电信号曲线收集结束点的电信号及斜率均接近0时获得的结果与水银法具有较好的一致性。     

Research on slag-resistance of ZrN-SiAlON-SiC-C composite refractory in different atmospheres

The ZrN-SiAlON composite powder was synthesized using low-grade zircon and bauxite by carbothermal reduction nitridation at first and then ZrN-SiAlON-SiC-C composite refractory were fabricated with the ZrN-SiAlON powder, SiC particles, and a small amount of Si powder as raw materials and sucrose as the binder. The slag resistance of these composites in O₂, N₂ and Ar atmosphere was investigated by X-ray diffraction, scanning electron microscopy, and energy dispersion spectra. The results show that the pores in the inside of ZrN-SiAlON-SiC-C composite refractory were enlarged in oxygen atmosphere due to oxidation, which leads to the decrease in slag resistance. In argon atmosphere, blast furnace slag destroyed the sintered body of zircon, corundum, and cristobalite with the formation of CaZrO₃, then infiltrated into and filled the pores inside the refractory to form a dense layer, which hindered the further erosion of the blast furnace slag. In the reducing atmosphere, the interfacial energy of the gas-liquid phases became larger due to the reactions between blast furnace slag liquid and the gas, resulting in a larger wetting angle which prevented the erosion.     

钢包包衬侵蚀对内衬温度和钢水温降的影响

为了研究包衬侵蚀对钢水温降的影响规律,通过ANSYS有限元软件以及ParaMesh网格随移技术建立了考虑包衬侵蚀的钢包传热计算模型,研究并分析了包衬侵蚀对包衬及钢水温度的影响规律。结果表明,包衬侵蚀对包衬温度影响较大,在相邻两个修包周期内,包衬侵蚀造成渣线和包壁的包衬内部(工作层与永久层交界处)温差为14～114 K;包衬侵蚀导致包壳外表面温度升高,包壳向外散热增加,与此同时,包衬受侵蚀变薄,蓄热减少,两者同时作用导致包衬侵蚀对钢水温降影响不大,最高不超过1 K,在实际生产中可以适当地忽略钢包侵蚀对钢水温降的影响。     

Peracetic acid as a single endodontic irrigant: effects on microhardness,roughness and erosion of root canal dentin

The aim was to assess the effects of 1% peracetic acid (PAA) as a single endodontic irrigant on microhardness, roughness, and erosion of root canal dentin, compared with 2.5% sodium hypochlorite (NaOCl) and with 2.5% NaOCl combined with 17% EDTA. Forty human, single‐rooted tooth hemisections were submitted to Knoop microhardness test, before and after the following irrigation protocols: PAA = 1% PAA; NaOCl = 2.5% NaOCl; NaOCl‐EDTA‐NaOCl = 2.5% NaOCl +17% EDTA +2.5% NaOCl; and SS = saline. Another 40 roots were instrumented, irrigated with the same protocols, and sectioned longitudinally. The roughness analysis was performed on the mesial section using a confocal laser scanning microscope, whereas erosion was analyzed on each third of the distal section, using a scanning electron microscope. The data were analyzed using ANOVA and Tukey post‐tests, and Kruskal‐Wallis and Dunn post‐tests (α = .05). The PAA and NaOCl‐EDTA‐NaOCl groups showed no significant differences (p > .05); both promoted reduction in microhardness and increase in roughness, compared with the NaOCl and SS groups (p < .05). NaOCl‐EDTA‐NaOCl promoted higher erosion in the cervical and middle thirds than the other groups (p < .05); there was no difference among PAA, NaOCl, and SS (p > .05). There was also no difference among the groups regarding the apical third (p > .05). PAA used as a single endodontic irrigant caused reduction in root canal dentin microhardness and increase in roughness in a similar way to NaOCl‐EDTA‐NaOCl; however, PAA caused less erosion than NaOCl‐EDTA‐NaOCl.     

Reduced texaphyrin: A ratiometric optical sensor for heavy metals in aqueous solution

We report here a water-soluble metal cation sensor system based on the as-prepared or reduced form of an expanded porphyrin, texaphyrin. Upon metal complexation, a change in the redox state of the ligand occurs that is accompanied by a color change from red to green. Although long employed for synthesis in organic media, we have now found that this complexation-driven redox behavior may be used to achieve the naked eye detectable colorimetric sensing of several number of less-common metal ions in aqueous media. Exposure to In(III), Hg(II), Cd(II), Mn(II), Bi(III), Co(II), and Pb(II) cations leads to a colorimetric response within 10 min. This process is selective for Hg(II) under conditions of competitive analysis. Furthermore, among the subset of response-producing cations, In(III) proved unique in giving rise to a ratiometric change in the ligand-based fluorescence features, including an overall increase in intensity. The cation selectivity observed in aqueous media stands in contrast to what is seen in organic solvents, where a wide range of texaphyrin metal complexes may be prepared. The formation of metal cation complexes under the present aqueous conditions was confirmed by reversed phase high-performance liquid chromatography, ultra-violet-visible absorption and fluorescence spectroscopies, and high-resolution mass spectrometry.     

Microstructure and corrosion behaviors of FeCrNiBSiMox stainless steel fabricated by laser melting deposition

In this paper, FeCrNiBSiMo_x (x = 1.0, 1.5, 2.0, 2.5) stainless steels were successfully prepared using a laser melting deposition technology, with the aim to investigate the effect of Mo content on microstructure and corrosion behaviors. The results showed that the as-deposited specimens were composed mostly of α-Fe and a small amount of (Cr, Mo)₇C₃, and (Cr, Mo)₇C₃ existed in the inter-dendritic (ID) region. As the Mo content increased, grain refinement could be clearly observed, and the area of the ID region increased from 27% to 54%. The low-angle boundaries accounted for 60–70% of the grain boundaries of the as-deposited specimens. Increasing the content of Mo improved the microhardness of the as-deposited specimens from 652 HV to 813 HV. The corrosion current density of the as-deposited specimens with the Mo mass fractions of 1.0%, 1.5%, 2.0%, and 2.5% were 1.37 × 10⁻⁶, 1.02 × 10⁻⁷, 6.19 × 10⁻⁷, and 3.06 × 10⁻⁷ A/cm², respectively. The as-deposited specimen with Mo content of 1.5% had lower cumulative erosion loss and erosion loss rate than other as-deposited specimens. The FeCrNiBSiMo_x (x = 1.5) specimen exhibited excellent resistance to electrochemical corrosion and cavitation erosion.     

UV/TiO_2光催化氧化工艺脱汞的试验研究

UV/TiO_2光催化技术在TiO_2催化剂的作用下可将烟气中Hg~0氧化脱除。利用自制的UV/TiO_2氧化试验台研究了影响Hg~0去除率的相关因素,结果表明,在无催化剂和有紫外灯情况下可脱除少量Hg~0;Hg~0去除率随催化剂活性组分含量的增加而上升,但上升速率逐渐下降;在温度(50～200)℃范围内,Hg~0去除率无明显变化;Hg~0去除率随着Hg~0初始浓度的升高逐渐下降;Hg~0去除率随着烟气中氧含量先上升后趋于不变。UV/TiO_2氧化工艺脱汞可为燃煤电厂烟气脱汞提供理论指导。     

不同煤阶煤孔隙特征及其吸附能力响应

我国是煤炭资源大国，煤层气储量规模相当可观，但煤储层又具有低孔、低渗的不足，照搬国外或常规石油天然气的开采程序和方法已被证实是走不通的。应结合实际，根据不同地质条件、不同煤阶的开采程序，进行孔隙特征研究。煤孔隙特征、连通性和吸附能力对煤层气开采影响尤为重要，为研究煤孔隙结构特征随煤变质程度的变化关系及其吸附能力的响应特点，采取不同地区不同变质程度煤样，进行压汞测试和等温吸附实验。实验结果表明，煤孔隙度和平均孔径均随变质程度增加呈现降低—升高—降低的趋势；煤中孔隙连通性随煤变质程度增加逐渐变差；随煤变质程度增加，其最大吸附能力也呈现降低—升高—降低的总体趋势。