基于单光子计数激光雷达的Bayesian检测研究

在单光子计数激光雷达检测领域,目前的检测方法在低信噪比情况下虚警概率会增加,同时也无法适应噪声变化的问题。针对这些问题,提出了一种基于Bayesian的检测方法,该方法首先通过雷达方程估计回波信号光子数的范围,将其作为先验信息,而后结合二项分布建立了累计概率模型,基于Bayesian判决准则计算得到检测阈值,此阈值能够在检测概率与虚警概率中间择其平衡。这种方法不仅克服了低信噪比检测困难的情况,还减少了先验信息的获取难度。实验结果表明,对比固定阈值其虚警概率降低了10倍。对比“恒虚警”其检测概率提高了约20。验证了方法具有良好的检测效果,具备一定的可操作性。     

基于误差估值累加开环校正的诱导式欺骗检测方法

诱导式卫星欺骗干扰可诱导航空器逐渐偏离预定航迹，难以被发现，因此及时有效地检测干扰是飞行安全的保障。在现有紧组合导航体制基础上，设计了一种基于误差估值累加开环校正的紧组合导航结构，并证明了其性能与传统闭环校正紧组合导航性能等效。在此结构中，将紧组合导航系统与自适应序贯概率比检测方法结合，提出了一种基于误差估值累加开环校正的诱导式欺骗检测方法，融合紧组合导航信息与其他不受欺骗影响的导航信息，构建欺骗检测统计量进行诱导式欺骗检测。仿真结果表明，开环校正结构可避免随时间累加的惯性导航系统误差所导致的组合导航滤波器发散问题，同时欺骗检测方法可进一步提高算法对“最坏”情形下微小诱导式欺骗的检测效果。     

A 6-DOF humanoid wall-climbing robot with flexible adsorption feet based on negative pressure suction

A wide range of dangerous and special tasks have witnessed the applications of wall-climbing robots, but they still cannot adapt well torough or sloping walls. This paper proposes a 6-DOF (degree of freedom) humanoid wall-climbing robot (HWCR) based on the principle of negative pressure suction. HWCR has the advantages of flexible adsorption feet, strong adaptability, strong anti-subversion performance, and high friction to the wall. We deduce mechanics formulas and carry out a parametric design of the foot structure so that it can meet the requirement of robot wall climbing. We use Fluent to analyze the flow field of the adsorption foot and determine the motor speed that can provide a reliable adsorption force. Using the D-H matrix to plan gait, we also design a compound cycloid-based foot trajectory to reduce the impact between the HWCR and the wall. Experiments on the uneven wall and sloping wall show that the vehicle can walk with an ideal gait, and the resistance value of the servo on each joint is much lower than the critical value, which ensures the smooth movement of the HWCR.     

Study on vapour dispersion and explosion from compressed hydrogen spill: Risk assessment on a hydrogen plant

Hydrogen produced from renewable resources is one of the cleanest fuels and could be used to store intermittent solar, wind and other energies. The main concern about using hydrogen is its hazards, such as high storage pressure, wide-range flammability, low mass density, and high diffusion. This study investigated the hazards of compressed hydrogen storage by developing a CFD model to understand the gas dispersion behaviour. The model was validated using the past experimental data and showed a good agreement, which could demonstrate the diffusion characteristics and gas stratification of a buoyant gas. A case study of an accidental release of compressed hydrogen from a storage tank was investigated to evaluate the risk of a hydrogen plant. A mathematical model of the jet spill was used to account for the choking effect from a high-pressure release to ensure the input velocity in CFD simulation is suitable for modelling gas dispersion using verified spatial and temporal scales, then the simulation results were used as inputs of vapour cloud explosions (VCEs) to investigate the potential overpressure effect. It was found the CFD model could predict a more reasonable flammable gas amount in cloud than using the bulk hydrogen release rate. The safety distance based on the overpressure prediction was reduced by 35%. The method proposed in this study can provide more validity for the consequence analysis as part of risk assessment.     

Combined effect of channel to rib width ratio and gas diffusion layer deformation on high temperature – Polymer electrolyte membrane fuel cell performance

The present study investigates the combined influence of Channel to Rib Width (CRW) ratio and clamping pressure on the structure and performance of High Temperature-Polymer Electrolyte Membrane Fuel Cell (HT-PEMFC) using a three-dimensional numerical model developed previously. It also considers the impact of interfacial contact resistance between the Gas Diffusion Layer (GDL) and Bipolar Plate (BPP). The structural analysis of the single straight channel HT-PEMFC geometry shows that the von-Mises stress greatly increases in the GDL under the ribs as the CRW ratio increases resulting in considerably high deformation. The cell performance analysis depicts the significance of ohmic resistance and concentration polarization for different CRW ratios, particularly at higher operating current densities. However, in low to medium current density regions, the CRW ratio has little influence on cell performance. A substantial impact on the species, overpotential, and current distributions is observed. The findings also reveal that the CRW ratio significantly affects the temperature distribution in the cell.     

有砟轨道路基翻浆冒泥模型试验系统的研发与应用

为研究既有线有砟轨道路基的翻浆冒泥机理，自主研发了一套能够模拟循环荷载–湿化耦合作用的模型试验系统。模型试样直径500 mm，由厚度分别为350 mm的路基土和200 mm的道砟组成，整个试样在高强度透明有机玻璃模型筒中制备完成。模型试验系统配备有监测荷载、位移、体积含水率和孔隙水压力的4种传感器，并通过高清相机对颗粒迁移过程进行图像捕捉。基于所研发的试验系统，针对辛泰铁路典型翻浆冒泥病害路段土样，开展翻浆冒泥模型试验。试验结果表明：动孔隙水压力是导致翻浆冒泥病害产生的关键因素。随着体积含水率的增加，动孔隙水压力引起的颗粒迁移量逐渐增加；在饱和状态下，会引起大量颗粒迁移，翻浆冒泥现象显著。试验结束时，道砟污染指数达到25%，在实际工程中已严重影响铁路的正常运营，有必要对污染道砟进行换填。     

基于5G时长驻留的分析及优化提升方法

随着中国移动5G网络的逐步发展，目前已实现城区的5G网络连片覆盖，全网5G用户大规模增长。本文通过对经分数据用户产生的话单，结合用户使用的网络类型，利用成熟的经分平台，实现直接针对用户使用的网络、流量、时长等方面的分析，直观的体现了用户在5G网络的驻留时长占比以及5G网络的流量占比，为网络优化工作提供了重要分析依据。     

Effect of nitrogen on deflagration characteristics of hydrogen / methane mixture

In order to study the influence of nitrogen on the deflagration characteristics of premixed hydrogen/methane, the explosion parameters of premixed hydrogen/methane within various volume ratios and different dilution ratios were studied by using a spherical flame method at room temperature and pressure. The results are as follows: The addition of nitrogen makes the upper limit of explosion of hydrogen/methane premixed gas drop, and the lower limit rises. For explosion hazard (F-number), hydrogen/methane premixed fuel with a hydrogen addition ratio of 10% has the lowest risk, and nitrogen has a greater impact on the dangerous degree of hydrogen and methane premixed gas whose hydrogen addition ratio does not exceed 30%. In terms of flame structure, the spherical flame was affected by buoyancy instability as the percentage of nitrogen dilution increased, but the buoyancy instability gradually decreased as the percentage of hydrogen addition increased. The addition of diluent gas reduces the spreading speed of the stretching flame and reduces the stretching rate in the initial stage of flame development. The laminar flame propagation velocity calculated by the experiment in this paper is consistent with the laminar flow velocity of the hydrogen/methane premixed gas calculated by GRI Mech 3.0. Considering the explosion parameters such as flammability limit, laminar combustion rate and deflagration index, when hydrogen is added to 70%, it is the turning point of hydrogen/methane premixed fuel.     

日本の寒地，北海道における2030年代の水稲生育への温暖化の影響予測とその対応(日语原文)

北海道では1980年代から2010年代まで，水稲圃場栽培期間である5–9月の気温は年代とともに上昇した。そこで，直近の2010年代（2010—2019年平均）と比べて， 2つの2030年代の予測気象から，既報の関係式より水稲生育を予測した。その結果，2030年代では2010年代に比べ，限界移植日（移植早限）が水稲栽培17地域の平均で8～9日早い。また，早限出穂期が1～5日早く，晩限出穂期が1～5日遅く，安全出穂期間が2～10日長い。出穂期は1～3日早い。出穂期から晩限出穂まで2～9日長いため，遅延型冷害の発生がやや少ない。生育期別気象は，出穂前24日以降30日間では生育が早いため平均気温が同じかやや低い。出穂前10日以降40日間および出穂期以降40日間では平均気温がやや高く，日射量はやや少ない。そのため，玄米収量は96～98％とやや低く，潜在収量性を示す気候登熟量示数は同じである。障害不稔発生に関係する穂ばらみ期冷害危険期の平均気温はわずかに低いかほぼ同じであるため，冷害発生の危険性は残る。一方，不稔発生をもたらす低温域の出現頻度には，地域間で差異がある。精米蛋白質含有率は同じであるが，アミロース含有率はやや低く，やや良食味である。米粒外観品質では被害粒歩合と着色粒歩合は一定の傾向がなく，未熟粒歩合はやや高い。精米白度は同じであるが，玄米白度はやや高い。以上の予測に対する技術的対応方向を示した。