基于多相滤波器的信道化接收机及其应用研究

本文主要研究了应用多相滤波技术的信道化接收机建模问题。在给定信道频谱划分方案下,推导了基于多相 滤波器的信道化接收机数学模型。并由此模型设计了一个四信道模拟系统。最后用仿真实验结果验证了模型的正确性。     

带通采样在数据采集中的应用研究

在数据采集中采用带通采样，可大大降低采样率，但系统中的抗混叠滤波器会造成相位的非线性。采用对滤波后的信号进行带通采样，然后再用FRR滤波器校正相位的非线性，从而不失真地还原原信号，最后在Matlab中进行仿真，验证了该方法的有效性。     

Bandpass filters using periodically loaded combline resonators

A novel combline filter is proposed for cellular‐radio base stations. The Q‐factor is significantly improved. The eigenvalue equation is expressed with the single‐team approximation in the gap region of the combline resonator. A two‐pole combline filter is designed. The calculation, simulation, and experiment results are presented and are in good agreement. © 2005 Wiley Periodicals, Inc. Int J RF and Microwave CAE, 2006.     

高炉煤气脉冲布袋除尘技术的应用

介绍了韶钢6号高炉脉冲布袋除尘技术的工艺流程、主要设备、控制措施及节能效果。     

跟踪系统中跟踪器延迟的自适应预测补偿方法

跟踪系统中跟踪器的延迟会对系统的稳定性和跟踪精度产生不利影响。为此以典型Ⅱ型系统为例，理论上定理地分析了跟踪器延迟对跟踪系统的影响，并提出了将采用LMS算法和横向滤波器结构的自适应滤波器用于延迟预测补偿的方法。仿真结果验证了方法的有效性。     

Significance of fluid regime in biological filtration

A dispersed flow model previously developed to study substrate utilization in unsaturated media was experimentally verified and its practical application was considered. For this purpose, measurements were made using tap water and a synthetic feed solution. The importance of the change in fluid regime as regards to the simultaneous transport and reaction within biological filters were demonstrated. The effect of drop formation and the breakage of liquid jets inside the filters on substrate utilization was also shown.     

Results of the ASTM field test of tristimulus weighting functions

In 1993, the American Society for Testing and Materials carried out a field test of newly calculated tristimulus weighting factors. These weighting factors had been calculated by a method proposed by Venable. the test also included a method of correction for bandpass dependence put forth by Stearns. the purpose of the trial was to assess the possible reduction in bandpass dependence introduced by each of these sets of weights. A large number of sets of spectral data were gathered from the cooperators in the field test. Results of integration by the various sets of tristimulus weighting factors were calculated. A total of 15 120 color differences were calculated and statistics were derived to test the probable error resulting from each method of correction. Errors attributable to bandpass dependence were on the order of a few tenths to as much as one CIELAB unit when uncorrected weight sets were used. These errors could be reduced to a few hundreths of a CIELAB unit, and in some cases to a few thousandths of a unit, by employing one correcting strategy or the other. an overall mix of strategies was ultimately chosen to minimize the bandpass dependence over the entire range of weight sets. Utilizing this mixed strategy, the median error introduced into 10-nm integration by bandpass dependence was only 0.004 CIELAB units. © 1995 John Wiley & Sons, Inc.     

电流模式n阶传输函数的OA-OTA实现

提出了一种新的实现任意 n阶电流模式传输函数的网络结构。该电路仅含运算放大器 (OA)和运算跨导放大器 (OTA)有源器件 ,因而适于全集成。适当设置 OTA的跨导值能实现任意高阶传输函数 ,且传输函数的系数可独立调整。文中推导了滤波器的设计公式 ,并给出了截止频率为 1 0 0 k Hz的三阶巴特沃斯低通滤波器实例 ,PSPICE仿真结果表明所提电路及设计公式是正确的     

任意型一维FIR数字滤波器设计新方法

本文介绍了一种设计任意型（宽带、窄带、低阶、高阶、低通、高通、带通、带阻）一维FIR数字滤波器新方法．给出设计不同类型滤波器的统一方法。各种类型滤波器脉冲响应的设计公式简单、计算方便。该方法消除了Gibbs现象．不仅克服了优化设计中收敛速度、设计精度及初值选取等问题，而且减少设计高阶滤波器的时间。最后，本文给出了各种类型滤波器设计的仿真结果。     

SAW滤波器简化衍射频响的计算方法

提出了由一个变迹ＩＤＴ叉指换能器和一个均匀ＩＤＴ组成的ＳＡＷ滤波器简化衍射频响的计算方法，即将均匀ＩＤＴ简化成单根指计算其衍射频响。该方法与未简化衍射频响的计算方法相比，计算量大为减小，前者约为后者的（Ｎ为均匀ＩＤＴ的指对数）。并给出了一个实例，用未简化与简化方法分别计算了其衍射频响，结果表明，两者符合得较好。