一种植物油中苯并（a）芘含量测定的固相萃取前处理方法

为了建立一种准确性高、成本低的植物油中苯并(a)芘测定的样品前处理方法，基于GB 5009.7—2016以自制氧化铝柱为固相萃取柱，采用单因素试验对称样量、洗脱剂量、洗脱流速、吸附剂存放时间、吸附剂量这5个影响植物油中苯并（a）芘洗脱的因素进行研究，优化前处理条件，并对测定方法进行考察。结果表明：优化的前处理条件为称样量0.100 0 g、洗脱剂量120 mL、吸附剂（氧化铝）量22 g、洗脱流速1滴/2 s、吸附剂存放时间少于12周；方法检出限为0.2 μg/L，样品加标回收率为94.23%～100.00%，RSD为1.20%～7.36%；同一样品测定结果与SGS测定值接近，相对平均偏差为2.36%～3.50%。说明本试验方法测定结果准确，可应用于油脂企业植物油中痕量苯并（a）芘的测定。     

Prediction of Flooding in Packed Liquid-Liquid and High-Pressure Extraction Columns Using a Gaussian Process

Reliable prediction of flooding conditions is needed for sizing and operating packed extraction columns. Due to the complex interplay of physicochemical properties, operational parameters and the packing-specific properties, it is challenging to develop accurate semi-empirical or rigorous models with a high validity range. State of the art models may therefore fail to predict flooding accurately. To overcome this problem, a data-driven model based on Gaussian processes is developed to predict flooding for packed liquid-liquid and high-pressure extraction columns. The optimized Gaussian process for the liquid-liquid extraction column results in an average absolute relative error (AARE) of 15.23 %, whereas the algorithm for the high-pressure extraction column results in an AARE of 13.68 %. Both algorithms can predict flooding curves for different packing geometries and chemical systems precisely.     

基于面元素重排的三维网格模型数据隐藏算法

目的 为了解决目前三维数据隐藏算法不能兼顾无失真和盲提取的问题，提出一种新的完全无失真的三维网格模型数据隐藏盲算法。方法 首先使用混沌逻辑映射选择嵌入与提取模式，保证数据的安全性。然后利用面元素重排，完全不会造成三维模型失真的性质，通过不同嵌入模式规则对三角面元素进行重排，以嵌入秘密数据。接收端则可根据相应的提取模式规则提取秘密数据。结果 仿真结果与分析表明，该算法不会对三维模型造成任何失真，嵌入容量为每顶点2比特，且能抵抗仿射变换攻击、噪声攻击和平滑攻击等。结论 这种三维数据隐藏盲算法无失真，容量大、安全性高、鲁棒性强，适用于三维载体不容修改的情形，如军事、医学、秘密通信和版权保护等。     

Simultaneous fractionation of multiple classes of polyphenols from honeybush tea using solid-phase extraction

The structural diversity of polyphenols and the inherent limitations of current extraction techniques pose a challenge to extract polyphenols using a simple and green method. Hence, in this study, a method was developed to simultaneously fractionate multiple classes of polyphenols by only varying ethanol-water solutions. Honeybush tea, which is rich in polyphenols, was selected as a model for this study. Solvent extraction followed by solid-phase extraction (SPE) was developed to obtain a polyphenol-rich fraction from six honeybush samples. Based on a gradient elution programme (10%, 30%, 50%, 70% and 90% (v/v) ethanol-water solution) of SPE, the Strata X cartridge showed a better recovery of most targeted polyphenols under 0.9 mL of the drying volume and 1 mL min⁻¹ of the dispensing speed. The elution programme for fractionating most polyphenols was as follows: single elution with 50% ethanol, followed by twice elution with 70% ethanol. The antioxidant capacity was used to analyse the differences among the polyphenol-rich fractions from six honeybush samples. Principal component analysis (PCA) revealed that unfermented C. genistoides (GG) has the greatest antioxidant capacity among the honeybush species studied. Additionally, mangiferin, isomangiferin and vicenin-2 were the main contributors to the antioxidant capacity in six honeybush fractions according to the correlation study.     

Predictive formulas for different measures of cheese yield using milk composition from individual goat samples

The objective of this study was to develop formulas based on milk composition of individual goat samples for predicting cheese yield (%CY) traits (fresh curd, milk solids, and water retained in the curd). The specific aims were to assess and quantify (1) the contribution of major milk components (fat, protein, and casein) and udder health indicators (lactose, somatic cell count, pH, and bacterial count) on %CY traits (fresh curd, milk solids, and water retained in the curd); (2) the cheese-making method; and (3) goat breed effects on prediction accuracy of the %CY formulas. The %CY traits were analyzed in duplicate from 600 goats, using an individual laboratory cheese-making procedure (9-MilCA method; 9 mL of milk per observation) for a total of 1,200 observations. Goats were reared in 36 herds and belonged to 6 breeds (Saanen, Murciano-Granadina, Camosciata delle Alpi, Maltese, Sarda, and Sarda Primitiva). Fresh %CY (%CY_CURD), total solids (%CY_SOLIDS), and water retained (%CY_WATER) in the curd were used as response variables. Single and multiple linear regression models were tested via different combinations of standard milk components (fat, protein, casein) and indirect udder health indicators (UHI; lactose, somatic cell count, pH, and bacterial count). The 2 %CY observations within animal were averaged, and a cross-validation (CrV) scheme was adopted, in which 80% of observations were randomly assigned to the calibration (CAL) set and 20% to the validation (VAL) set. The procedure was repeated 10 times to account for sampling variability. Further, the model presenting the best prediction accuracy in CrV (i.e., comprehensive formula) was used in a secondary analysis to assess the accuracy of the %CY predictive formulas as part of the laboratory cheese-making procedure (within-animal validation, WAV), in which the first %CY observation within animal was assigned to CAL, and the second to the VAL set. Finally, a stratified CrV (SCrV) was adopted to assess the %CY traits prediction accuracy across goat breeds, again using the best model, in which 5 breeds were included in CAL and the remaining one in the VAL set. Fitting statistics of the formulas were assessed by coefficient of determination of validation (R²_VAL) and the root mean square error of validation (RMSE_VAL). In CrV, the formula with the best prediction accuracy for all %CY traits included fat, casein, and UHI (R²_VAL = 0.65, 0.96, and 0.23 for %CY_CURD, %CY_SOLIDS, and %CY_WATER, respectively). The WAV procedure showed R²_VAL higher than those obtained in CrV, evidencing a low effect of the 9-MilCA method and, indirectly, its high repeatability. In the SCrV, large differences for %CY_CURD and %CY_WATER among breeds evidenced that the breed is a fundamental factor to consider in %CY predictive formulas. These results may be useful to monitor milk composition and quantify the influence of milk traits in the composite selection indices of specific breeds, and for the direct genetic improvement of cheese production.     

A Feature Extraction Method for scRNA-seq Processing and Its Application on COVID-19 Data Analysis

Single-cell RNA-sequencing (scRNA-seq) is a rapidly increasing research area in biomedical signal processing. However, the high complexity of single-cell data makes efficient and accurate analysis difficult. To improve the performance of single-cell RNA data processing, two single-cell features calculation method and corresponding dual-input neural network structures are proposed. In this feature extraction and fusion scheme, the features at the cluster level are extracted by hierarchical clustering and differential gene analysis, and the features at the cell level are extracted by the calculation of gene frequency and cross cell frequency. Our experiments on COVID-19 data demonstrate that the combined use of these two feature achieves great results and high robustness for classification tasks.     

基于SVD和SSA-VMD降噪的轴承故障特征提取

针对强噪声背景下轴承故障特征提取困难的问题，提出一种基于奇异值分解和参数优化变分模态分解联合降噪的轴承故障特征提取方法(SSVMD)：首先，对原始信号进行奇异值分解(Singular Value Decomposition，SVD)处理，运用奇异值差分谱法选取有效奇异值并将原始信号重构得到初步降噪信号；其次，为防止故障信息丢失，将残余信号进行麻雀算法(Sparrow Search Algorithm，SSA)优化的变分模态分解(Variational Mode Decomposition，VMD）算法处理，得到最佳的模态个数K和惩罚参数α，选取峭度值最大、包络熵最小的IMF分量与初步降噪信号叠加得到最终降噪信号，并对信号进行包络分析；最后，通过仿真和试验数据分析得出，该方法能在信噪比很低的情况下降低噪声含量并提取轴承故障特征，为设备的状态监测和故障诊断提供理论依据。     

Facile synthesis of a carbon-rich SiAlCN precursor and investigation of its structural evolution during the polymer-ceramic conversion process

A liquid carbon-rich SiAlCN precursor is facilely synthetized by hydrosilylation between liquid polyaluminocarbosilane (LPACS) and 1,3,5,7-tetravinyl- 1,3,5,7-tetramethylcyclotetrasilazane {[CH₃(CH₂CH₂)SiNH]₄} (TeVSZ). The structural evolution during the polymer-ceramic conversion process is investigated by various methods. The results show that the main cured mechanism is β-addition on hydrosilylation, although α-addition on hydrosilylation, polymerization of vinyl groups and dehydrocoupling reaction between N–H bonds also occur during the cured process. During the pyrolysis process, dehydrogenation and dehydrocarbonation condensation reactions, transamination reactions occur, leading to formation of a three-dimensional network inorganic structure at 400–800 °C, where part of Al–O bonds convert to Al–N bonds. Then the network inorganic structure undergoes demixing and separation into amorphous SiAlCN(O) phase, where the amorphous turbostratic free carbon phase also form at 800–1200 °C. With demixing and decomposition of the amorphous carbon-rich SiAlCN(O) phase, the crystalline β-SiC and graphitic carbon start to form at about 1400 °C, the crystalline sizes of them both enlarge with increasing temperature. However, the crystal growth of β-SiC is distinctly inhibited due to existence of the rich carbon phase, tiny amounts of Al₂O₃ and AlN. In addition, a small amount of AlN can promote the formation of α-SiC at 1800 °C.     

Influence of applied voltage and conductive material in DIET promotion for methane generation

The utilization of biological-, electrode- and conductive material-mediated direct interspecies electron transfer (DIET) between exoelectrogenic bacteria and methanogenic archaea for enhancing methane productivity is widely reported in the literature. However, two cardinal questions are still controversial, i.e., which applied voltage value would be more recommended to enhance methane generation? and how the DIET over IIET has the upper hand in enhancing methane productivity? Herein, the influence of different applied voltages to promote biological-, conductive- and electrode-mediated DIET was investigated in MEC-AD reactors with conductive material. Polarized bioelectrodes induced electrode-mediated DIET (eDIET) and biological DIET (bDIET), in addition to cDIET (conductive material-mediated DIET), improved the methane yield to 315.40 mL/g COD_r with an applied voltage of 0.9 V. Whereas further increase of applied voltage 1.2 V, lessened methane production efficiency due to high-voltage inhibition and adverse effect on DIET promotion. The anaerobic digestion coupled microbial electrolysis cells with optimal electric potential selectively promotes the DIET through polarized electrodes were confirmed through microbial analysis. As the contribution of DIET increased to 80%, the methane yield increased, and the substrate residue decreased, resulting in a significant improvement in methane production.     

Thermal and photon effects on the reaction of H2 and O2 to water over Ag–Pd/TiO2

The reaction of H₂ and O₂ to water are studied over a Ag–Pd/TiO₂ anatase catalyst, under dark and photo-irradiation conditions in the gas and liquid phases. The catalyst consisted of metal particles of mean size of ca.1 nm dispersed over 10–15 nm TiO₂ particles. Kinetic parameters including order of reaction (n), rate constant (k), and activation energy (E_a), were evaluated. E_a for the thermal reaction was found to be 49-47 kJ mol^?1. The oxidation reaction rate constant was found to be ca. 3 times higher in the presence of photons when compared to dark reaction at room temperature. The overall quantum yield of the reaction in the slurry phase was found to be 0.09. Considering the number of metal particles on TiO₂, the photon yield per metal particle was found to be 0.16. A possible explanation of the changes in kinetics with respect to experimental conditions is given.