Holographic polymer‐dispersed liquid crystal fabrication under electric field

The transmission mode of holographic polymer‐dispersed liquid crystals (HPDLCs) was developed an under electric field. It is reported that orientation of LC molecules under an electric field induces orientation of oligomer molecules giving rise to low off‐state diffraction and small grating shrinkage. Copyright © 2005 Society of Chemical Industry     

电控平行排列液晶光栅的光衍射特性研究

对电控平行液晶光栅的理论进行了分析,并配以结构原理图。通过对平行排列及90°扭曲排列液晶指向矢的计算,得出液晶盒中相应的折射率、相位差与电压之间的关系图,两者经比较证明平行排列更具适用性,并在实验中观测到了平行排列液晶光栅衍射特性与电压的关系。     

高效率窄线宽光纤激光器

本文报道了一种环形腔掺饵光纤激光器，得到了泵浦效率高达22.6%，输出线宽小于0.1nm的激光输出。     

Theoretical Discussion of Couple-Mode Using Chirped Fiber Grating for Dispersion Compensation

１ＩｎｔｒｏｄｕｃｔｉｏｎＡｔｐｒｅｓｅｎｔ，ａｓｔｈｅｅｒｂｉｕｍｄｏｐｅｄａｍｐｌｉｆｉｅｒｓｈａｖｅｓｕｃｅｓｆｕｌｙｂｅｅｎａｐｐｌｉｅｄｔｏｏｐｔｉｃａｌｆｉｂｅｒｌｉｎｋｓ，ｔｈｅｌｏｎｇｈａｕｌｈｉｇｈｂｉｔｒａｔｅｏｆｏｐｔｉｃ...     

高质量的一级光栅1．55μmDFB激光器

本文详细叙述了ＤＦＢ激光器的设计要点和新的工艺。采用一级全息光栅和二步液相外延法批量研制出高稳定单纵模工作的１．５５μｍ分布反馈激光器（ＤＦＢ—ＬＤ）。外延片成品率＞４０％。器件特性：２５℃时阈值电流２０ｍＡ，单面光功率＞１０ｍｗ，主边模抑制比ＳＭＳＲ达４３ｄＢ（λ／４相移光栅），谱线宽度△ν－２０ｄＢ＝０．３ｎｍ，调制速率＞１．８ＧＨｚ。可靠性测试显示：高温监测光谱稳定，２５°Ｃ时阈值退化率△Ｉｔｈ／ｔ＜０．３ｍＡ／ｋｈ，对应器件预估寿命将超过１０万ｈ。     

可变波长光纤光栅滤波器用微驱动器的研制

为了研制可调谐光纤光栅滤波器而采用拉伸装置和光纤光栅一体化的微小器件结构。实现方法是由微细加工技术加工制造一种新的波长可变光纤光栅滤波器用驱动器，该微型驱动器采用电磁式驱动，由上下两层线圈构成，每个线圈有21匝平面线圈，产生约0．2μNm的扭矩，对应光纤光栅的反射波长变化约5nm。它可应用于可谓谐光纤光栅滤波器的驱动。     

一种基于FBG和LPG的温控报警模型

文章依据FBG温度传感的原理以及LPG滤波技术,提出了一种新的光纤光栅温度报警模型.用MATLAB对系统所采用的方法进行了模拟,结果表明该系统能满足温度报警的要求.     

差动光栅在精密测试中的应用

提出差动光栅概念,举例说明差动光栅在光纤面板刀口响应测试和材料形变自动监测系统等精密测试中的应用。     

Numerical simulation and error analysis for thermal diffusivity measurements using laser-induced thermal grating technique

The laser-induced thermal grating technique has been used to determine the thermal diffusivity of liquids and liquid mixtures. But the dynamic behaviour of the transient thermal grating has not yet been thoroughly investigated, and the systematic errors, which result from the departures from one-dimensional heat conduction, have scarcely been studied quantitatively. In this paper. a three-dimensional numerical simulation and results of the transient thermal grating technique are presented, which enable a good understanding of the dynamic behaviour of the transient thermal grating. The results of this simulation are important for the proper design of the experimental setup to keep the systematic errors for the diffusivity measurement small. Based on the simulation method, the systematic errors were analyzed quantitatively. Here, the following effects were studied: (I) sample thickness, (2) intersection angle, (3) absorption, (4) Gaussian beam intensity distribution and focusing of heating laser beam, and (5) heating pulse duration and laser power. This error analysis makes it possible to specify the criteria for optimum measuring conditions, to correct the measured thermal-diffusivity values for systematic errors, and to estimate the accuracy of the measurements.     

时分复用光纤光栅传感阵列中DFB激光器的高精度温控设计

针对时分复用光纤光栅(TDM-FBG)传感阵列中使用的分布反馈(DFB)激光器高波长稳定度的要求,设计了一个高精度的DFB温控方案,包括温度测量与设定、热敏电阻线性化、PID补偿回路、H桥驱动、温度电压采集与显示等。使用DFB内置的热敏电阻和半导体制冷器(TEC)对温控电路进行了测试,其精度在180s内达到±0.04℃,温控后激光器温度变化引起的应变测量误差为±3.4με左右,满足TDM-FBG传感阵列的要求。