价值网络语境下企业设计价值创新路径研究

目的 在新的视角下，提出一种价值创新路径模型，对设计驱动型企业的价值实现方式进行有效补充。方法 通过文献研究，论述了企业关系由价值链到价值网转变的历史趋势;通过比较研究，对价值实现过程中主客体之间的4种关系进行了类比分析，提出了不同主客体关系状态下设计实践的具体表现方式。结果 在价值网络语境下，以价值论为理论依据，从主客体之间的关系入手，构建设计价值创新路径模型。结论 通过分析证明:“主客体统一状态”是企业价值创造的理想状态;主客体关系一直处于动态的变化过程中;客体对主体的“意义”也一直处于动态变化中。在这种动态变化的关系网络中，设计驱动方式已经成为企业创新的重要模式，企业如何捕获并诠释“意义”，成为价值实现的关键所在。     

快速近似计算Shapley值的归因解释方法

Shapley值归因解释方法虽然能更准确量化解释结果, 但过高的计算复杂度严重影响了该方法的实用性. 本文引入KD树重新整理待解释模型的预测数据, 通过在KD树上插入虚节点, 使之满足TreeSHAP算法的使用条件, 在此基础上提出了KDSHAP方法. 该方法解除了TreeSHAP算法仅能解释树结构模型的限制, 将该算法计算Shapley值的高效性放宽到对所有的黑盒模型的解释中, 同时保证了计算准确度. 通过实验对比分析, KDSHAP方法的可靠性, 以及在解释高维输入模型时的适用性.     

Convolutional Neural Network Auto Encoder Channel Estimation Algorithm in MIMO-OFDM System

Higher transmission rate is one of the technological features of prominently used wireless communication namely Multiple Input Multiple Output-Orthogonal Frequency Division Multiplexing (MIMO–OFDM). One among an effective solution for channel estimation in wireless communication system, specifically in different environments is Deep Learning (DL) method. This research greatly utilizes channel estimator on the basis of Convolutional Neural Network Auto Encoder (CNNAE) classifier for MIMO-OFDM systems. A CNNAE classifier is one among Deep Learning (DL) algorithm, in which video signal is fed as input by allotting significant learnable weights and biases in various aspects/objects for video signal and capable of differentiating from one another. Improved performances are achieved by using CNNAE based channel estimation, in which extension is done for channel selection as well as achieve enhanced performances numerically, when compared with conventional estimators in quite a lot of scenarios. Considering reduction in number of parameters involved and re-usability of weights, CNNAE based channel estimation is quite suitable and properly fits to the video signal. CNNAE classifier weights updation are done with minimized Signal to Noise Ratio (SNR), Bit Error Rate (BER) and Mean Square Error (MSE).     

基于数值模拟的挤压参数对AZ91镁合金管转角焊合室分流挤压焊合压力的影响规律研究

提出了一种镁合金管材转角焊合室分流挤压新工艺，该工艺可在有效延长焊合室长度和焊合时间前提下保证舌针刚度，从而保证管材尺寸精度，并且可通过转角剪切变形机制增加预焊合金属变形量和动态再结晶程度，从而有利于提高管材性能和焊缝焊合性能。利用有限元法揭示了转角焊合室分流挤压成形过程中金属的流动特征，应变分布特征和焊合室内的静水压力分布特征。结果表明，整个挤压过程无金属折叠，从而保证管材的表面质量；流经转角后预焊合金属变形量明显增加，有利于提高管材质量和焊缝质量。最后，研究揭示了坯料初始温度，挤压速度和模具转角对焊合室内静水压力的影响规律。结果表明，随着挤压速度的增加和模具转角的增大，转角焊合室内静水压力增大；随着坯料预热温度的增加，转角焊合室内静水压力呈先增大后减小的趋势。     

改装元素分析—稳定同位素比值质谱联用仪测定固体样品硫同位素

本文对元素分析—稳定同位素比值质谱联用仪（EA-IRMS）进行改装，并利用其测定不同形态硫同位素标准物质和样品。结果表明，在色谱柱后加装SO₂气体捕集管，可捕集氧化还原产生的SO₂气体，并重复调用作为参考气使用，无需外部引入高纯SO₂气体，减小了其对仪器管路腐蚀和实验室环境危害；硫酸钡进样量约400 μg时，捕集管中的SO₂气体可提供至少20次峰中心聚焦；改装后的EA-IRMS系统测试硫同位素标准物质（IAEA-SO-5、 IAEA-S-2、IAEA-S-3、EMA-P1），当硫元素进样量为20 μg时，δ³⁴S值测试精度达到0.2‰（n=3），4种国际标准物质测量值与真实值相关系数良好（R²=1），表明硫的不同化合物δ³⁴S值可以相互校准，也表明EA-IRMS改装后可以满足硫同位素测试精度的要求。     

珠江口盆地珠一坳陷古近系高自然伽马砂岩形成机制及油气地质意义

运用放射性元素寻找油气是一种非常规油气勘探手段。近年来,在珠江口盆地珠一坳陷富烃凹陷周边古近系钻遇高自然伽马(GR)砂岩,其GR值(100~300 API)甚至大于同区泥岩的GR值(100~200 API)。为了弄清该特殊现象背后的地质意义,对珠江口盆地珠一坳陷古近系高自然伽马砂岩开展了铀(U)、钍(Th)、钾(K)等3种元素含量与GR值的相关趋势线分析,从井震特征、岩性特征及矿物成分特征等入手分析了砂岩GR值增高的主要原因及成因机制,探讨了放射性元素聚集的条件、运移通道、驱动力以及油气意义。结果表明:西江、惠州地区由U含量增高导致砂岩GR值偏高,恩平、番禺地区由K,Th含量增高导致砂岩GR值偏高;砂岩GR值增高有两大成因机制,一是地下流体带来的放射性元素离子U4+在氧化-还原面处富集后导致地层GR值偏高,这种特殊现象说明在具有连通基底大断裂旁的圈闭中,U4+的富集指示了曾经油气的存在,证实了研究区油气运移通道的有效性,对于油气藏的预测有着非常重要的指导性意义,二是地表流体带来的含放射性元素的矿物大量沉积后导致地层GR值偏高,含放射性元素矿物性质不稳定,可指示近源供给的存在,对于判断物源及沉积环境有着非常重要的意义。该研究成果为预测研究区油气成藏有利区带提供了依据。     

钠冷快堆停堆保护方案研究

在借鉴中国实验快堆（CEFR）热工模型建模经验的基础上，利用Relap5程序建立霞浦示范快堆（CFR）的主要系统模型，并参考快堆安全分析中的预期瞬态无停堆保护（ATWS）的分析方法，对发生反应性意外引入事故时的安全裕度和停堆保护进行仿真研究。仿真结果表明，额定功率下发生反应性引入时，不会触发短周期的报警和停堆；当发生补偿棒失控提升5 s和10 s时的反应性意外引入事故，目前一回路保护参数整定值、信号测量延迟及安全棒落棒时间可以取其他值；当补偿棒失控提升15 s时，在目前的设计下，核功率和功率流量比信号能确保事故下的反应堆状态符合事故验收准则。当其他保护信号失效，堆芯出口钠温所触发的停堆保护若要实现同样的功能，则需保证反应堆在14.85 s之前进入深度次临界。      

Multidirectional focus measure for accurate three-dimensional shape recovery of microscopic objects

Shape from focus (SFF) is a technique to recover the shape of an object from multiple images taken at various focus settings. Most of conventional SFF techniques compute focus value of a pixel by applying one of focus measure operators on neighboring pixels on the same image frame. However, in the optics with limited depth of field, neighboring pixels of an image have different degree of focus for curved objects, thus the computed focus value does not reflect the accurate focus level of the pixel. Ideally, an accurate focus value of a pixel needs to be measured from the neighboring pixels lying on tangential plane of the pixel in image space. In this article, a tangential plane on each pixel location (i, j) in image sensor is searched by selecting one of five candidate planes based on the assumption that the maximum variance of focus values along the optical axis is achieved from the neighborhood lying on tangential plane of the pixel (i, j). Then, a focus measure operator is applied on neighboring pixels lying on the searched plane. The experimental results on both the synthetic and real microscopic objects show the proposed method produces more accurate three-dimensional shape in comparison to conventional SFF method that applies focus measures on original image planes.     

基于归一化水体指数及其阈值自适应算法的水体遥感反演效果分析

归一化水体指数（NDWI）是水体遥感反演的一种重要指标，其阈值及修正直接影响反演结果的精度。基于Landsat-8与GF-1光学多光谱影像，使用归一化水体指数法阈值0（TH₀）、最大类间方差法（OTSU）自适应阈值（TH_otsu）与均值漂移聚类算法（Mean-Shift）自适应阈值（TH_MS）分别对典型正常水体、云雾覆盖水体、富营养化水体、高含泥沙水体进行水体遥感提取与效果分析，结果表明：正常水体以TH₀为阈值提取精度最高，THMS提取精度次之，TH_otsu提取精度最差；而云雾覆盖水体、富营养化水体以及含泥沙水体使用THMS提取精度最高，尤其少量云雾覆盖下的水体，TH_MS具有更明显的优势，TH₀提取精度次之，TH_otsu提取精度最差；对于不同的阈值，Land?sat-8比GF-1总体表现出更高的水体提取精度。Mean-Shift算法应用于NDWI阈值修正与水体遥感反演具有快速、水质适应性强、效果稳定的优势，对尤其是复杂条件下的水体信息遥感反演具有较好的提取效果。     

Effect of the modified high methoxyl pectin on the stability of the fermented milk beverage

Stability of milk drinks could be improved by adding high methoxyl pectin. In this work, effect of the modified high methoxyl pectin (MHMP) on the fermented milk beverage (FMB) was investigated by the characteristics of adsorption, viscosity, rheological properties, particle size, zeta-potential (ζ-potential), microstructure, and phase behavior. The low concentration of MHMP (<0.2%, w/v) and final pH (<4.0) might easily cause the instability among the particles inducing from the bridging flocculation. The FMB system obviously had a good stability as the adding of 0.4% MHMP. Meanwhile, the particle size had a slight downward trend with decreasing the value of pH. The increase of MHMP concentration could increase the properties of viscosity and ζ-potential. However, the ζ-potential of the system had a decreasing trend by reducing the pH of the FMB with the same concentration of MHMP. The microstructure of the FMB was thick and dense compared with the sample without MHMP. As the concentration of MHMP was above 0.4%, the FMB system presented the uniform dispersion and only slight stratification water occurred for the phase behavior. Besides, it was also indicated that most part of MHMP was not adsorbed onto the casein micelles but was involved in a network with MHMP/casein complexes in the FMB.