Phosphorylated chitosan/poly(vinyl alcohol) based proton exchange membranes modified with propylammonium nitrate ionic liquid and silica filler for fuel cell applications

In our previous work, phosphorylated chitosan was modified through polymer blending with poly(vinyl alcohol) (PVA) polymer to produce N-methylene phosphonic chitosan/poly(vinyl alcohol) (NMPC/PVA) composite membranes. The aim of this work is to further investigate the effects of a propylammonium nitrate (PAN) ionic liquid and/or silicon dioxide (SiO₂) filler on the morphology and physical properties of NMPC/PVA composite membranes. The temperature-dependent ionic conductivity of the composite membranes with various ionic liquid and filler compositions was studied by varying the loading of PAN ionic liquid and SiO₂-PAN filler in the range of 5–20 wt%. As the loading of PAN ionic liquid increased in the NMPC/PVA membrane matrix, the ionic conductivity value also increased with the highest value of 0.53 × 10^?3 S cm^?1 at 25 °C and increased to 1.54 × 10^?3 S cm^?1 at 100 °C with 20 wt% PAN. The NMPC/PVA-PAN (20 wt%) composite membrane also exhibited the highest water uptake and ion exchange capacity, with values of 60.5% and 0.60 mequiv g^?1, respectively. In addition, in the single-cell performance test, the NMPC/PVA-PAN (20 wt%) composite membrane displayed a maximum power density, which was increased by approximately 14% compared to the NMPC/PVA composite membrane with 5 wt% SiO₂-PAN. This work demonstrated that modified NMPC/PVA composite membranes with ionic liquid PAN and/or SiO₂ filler showed enhanced performance compared with unmodified NMPC/PVA composite membranes for proton exchange membrane fuel cells.     

-15℃下Na+， K+， Mg2+//Cl-， NO3-， SO42——H2O体系相平衡研究

新疆卤水硝酸盐矿主要含有Na⁺、K⁺、Mg²⁺、Cl^-、NO₃^-、SO₄^2-六种离子，属于高元复杂体系，其合理利用和开发需要不同温度下的相平衡研究作为理论支撑。采用等温溶解平衡法，对Na⁺， K⁺， Mg²⁺//Cl^-， NO₃^-， SO₄^2--H₂O体系在-15℃、NaCl·2H₂O饱和条件下的相平衡进行了研究，并构建了相图。相图中有六个零变量点和八个两盐结晶区，只存在一种复盐KCl·MgCl₂·6H₂O。八个两盐结晶区，分别对应于NaCl·2H₂O+Na₂SO₄·10H₂O、NaCl·2H₂O+NaNO₃、NaCl·2H₂O+KCl、NaCl·2H₂O+KNO₃、NaCl·2H₂O+MgSO₄·7H₂O、NaCl·2H₂O+MgCl₂·8H₂O、NaCl·2H₂O+Mg(NO₃)₂·6H₂O和NaCl·2H₂O+KCl·MgCl₂·6H₂O，其中NaCl·2H₂O+Na₂SO₄·10H₂O共晶区最大，在低温时，硫酸钠的溶解度最小，降温过程中较易结晶析出。与该体系在25℃下的相图相比，复盐种类减少5种，零变量点减少19个，相关系得以极大简化。     

不同有机物对硝酸盐氮测试的影响

研究了红糖、葡萄糖、乙酸钠、甲醇、乙醇、乙酸、丙酸、丁酸、正戊酸、混合有机溶剂等10种不同有机物对麝香草酚光谱法和离子色谱法测试硝酸盐氮的影响。结果表明,溶液中含有红糖或葡萄糖时,均会对麝香草酚法测试硝酸盐氮造成影响,使得测试结果偏大;在无硝酸根离子存在时,红糖和葡萄糖的质量浓度与硝酸盐氮的测试浓度非线性相关;而乙酸钠、甲醇、乙醇、乙酸、丙酸、丁酸、正戊酸和混合有机溶剂则对麝香草酚法测试硝酸盐氮没有影响。实验发现,红糖和葡萄糖在浓硫酸的作用下与麝香草酚发生Molisch反应,形成有色复合物和红棕色不溶性沉淀。实验采用离子色谱法测试硝酸盐氮时,红糖和葡萄糖等糖类有机物对测试结果均无影响。     

石墨炉原子吸收法测定饮用水中痕量锗

探讨了以硝酸钯为基体改进剂,用石墨炉原子吸收法直接测定饮用水中痕量锗的最佳仪器测量条件、方法原理、基体改进剂的用量、准确度、精密度、曲线线性系数、测定下限、线性范围等。结果表明该方法灵敏、准确、稳定性好,加标回收率为96%～105%。     

盐卤除硝工艺的研究

介绍了一种采用氨碱蒸馏废液兑卤水进行除硝的新工艺 ,通过中试确定了该工艺的主要技术参数 ,为工程设计提供了条件。     

Biodegradation of monoaromatic hydrocarbons in aquifer columns amended with hydrogen peroxide and nitrate

The ability of indigenous microorganisms to degrade benzene, toluene, ethylbenzene and xylenes (BTEX) in laboratory scale flow-through aquifer columns was tested separately with hydrogen peroxide (110 mg/l) and nitrate (330 mg/l as NO₃⁻) amendments to air-saturated influent nutrient solution. The continuous removal of individual components from all columns relative to the sterile controls provided evidence for biodegradation. In the presence of hydrogen peroxide, the indigeneous microorganisms degraded benzene and toluene (> 95%), meta- plus para-xylene (80%) and ortho-xylene (70%). Nitrate addition resulted in 90% removal of toluene and 25% removal of ortho-xylene. However, benzene, ethylbenzene, meta- and para-xylene concentrations were not significantly reduced after 42 days of operation. Following this experiment, low dissolved oxygen (< 1 mg/l) conditions were initiated with the nitrate-amended column influent in order to mimic contaminated groundwater conditions distal from a nutrient injection well. Toluene continued to be effectively degraded (> 90%), and more than 25% of the benzene, 40% of the ethylbenzene, 50% of the meta- plus para-xylenes and 60% of the ortho-xylene were removed after several months of operation.     

离心萃取装置中硝酸羟胺还原反萃钚的研究

用十六级分离式混合—离心澄清萃取装置,在20-24℃,30-34℃,45-50℃等不同温度下进行了3B槽硝酸羟胺还原反萃钚的实验。结果表明,钚的收率均可达99.9%以上。在20-24℃时,有机相出口级附近几级的钚浓度较高,实验条件一旦波动,有可能造成钚的流失,且钚在萃取设备中有明显的积累。温度升高,14级反萃(停留时间约18min)时,钚的收率基本得到保证。     

Bi12TiO20 synthesized directly from bismuth (III) nitrate pentahydrate and titanium glycolate and its activity

Pure phase of sillenite structure, Bi₁₂TiO₂₀, was directly synthesized using stoichiometric bismuth (III) nitrate pentahydrate and titanium glycolate by co-precipitation. The influence of pH on the structure of Bi₁₂TiO₂₀ was studied in the pH range of 3–10. The sillenite structure was characterized using XRD and FTIR. The photo-degradation reaction of 4-nitrophenol (4-NP) was used to study photocatalytic activity of Bi₁₂TiO₂₀ as a function of the preparation pH. The rate of decomposition was followed by UV-vis and TOC. The beginning concentration of 4-NP, 44 ppm, decreased to less than 1 ppm within 30 min for all prepared catalysts. It was found that the decomposition rate constant of Bi₁₂TiO₂₀ is six times higher than those of either TiO₂ or Bi₂O₃ under the same conditions.     

月桂醇聚氧乙烯醚硝酸酯助燃降污性能的研究

通过柴油发动机台架试验证明 ,月桂醇聚氧乙烯醚硝酸酯用作柴油添加剂 ,既可提高柴油的燃烧性能 ,又可降低排放尾气中的一氧化碳 (CO)、未燃碳氢化合物 (HC)、氮氧化物 (NOx)含量及烟度等多种功能 ,是一种良好的多功能柴油助燃消烟添加剂。     

Direct synthesis of copper faujasite

Copper containing faujasite has been successfully prepared for the first time using a direct synthesis method. Faujasite type zeolite can be prepared in the presence of copper species by tuning the synthesis conditions. Ammonium hydroxide was used to form a copper complex that was later mixed with the reacting gel. Sodium is required to obtain copper faujasite. The complete elimination of sodium ions from the starting gel produces amorphous material. Crystallization took place at 358 K for 11 days. Crystallization temperature of 373 K produces ANA type zeolite as an impurity. Increasing by two times the amount of copper complex added to the reacting gel increases the crystallization time of Cu-FAU from 11 to 20 days (the crystallization rate decreases). The copper containing faujasite obtained was characterized by XRD, FESEM, EDX, EPR, FT-IR, TPR, and BET. According to the XRD pattern only FAU type zeolite was obtained. According to TPR experiments, the reduction temperature for Cu²⁺ ions present in Cu-FAU prepared by direct synthesis was 70 K more than for Cu-FAU prepared by ion-exchange. This difference can be due to the different location of the copper ions in the supercages or in the sodalite cages of the faujasite.