Co?N graphene encapsulated cobalt catalyst for H2O2 decomposition under acidic conditions

Hydrogen peroxide (H₂O₂) has been listed as one of the 100 most important chemicals in the world. However, huge amount of residual H₂O₂ is hard to timely decomposed into O₂ and H₂O under acidic condition, easily resulting in explosion hazard. Here, we reported a core–shell structure catalyst, that is graphene with Co N structure encapsulated Co nanoparticles. Co N graphene shell serves as the active site for the H₂O₂ decomposition, and Co core further enhance this decomposition. Benefiting from it, the H₂O₂ decomposition were close to 100% after 6 cycles without pH adjustment, which increased 6 orders of magnitude compared with no catalyst. At the same time, the O₂ generation reached 99.67% in 2 h with little metal leaching, and ·OH has been greatly inhibited to only 0.08%. This work can cleanly remove H₂O₂ with little deep oxidation and protect the process of H₂O₂ utilization to achieve a safer world.     

疫情下电磁场理论课程的网络教学

本文主要总结了新冠疫情期间作者的电磁场理论课程在线教学经验。对比分析了录播和直播的优缺点后,选择录播教学方式。基于超星网络教学平台,展示了录播网络教学的具体措施,包括网上答疑和学习效果检查以及在线批改作业等。给出了网络教学可以为线下教学继续使用的方法和手段,为疫情结束后的正常教学提供了新的网络教学补充措施。     

基于Massive MIMO及频谱叠加的5G SA网络上行优化方法

大规模多输入多输出(Multiple-Input Multiple-Output, MIMO)可以有效提升5G SA网络的上行链路数据传输速率以及可靠性。针对5G SA网络上行链路速率和覆盖不均衡的情况,提出了基于大规模MIMO的分组算法,将发送信号矢量进行分组,组内采用最大似然检测,组外采用基于正交三角分解(QR分解)的干扰消除检测,并且结合5G频谱的叠加策略,在降低算法复杂度的同时,有效提升网络覆盖和速率。通过5G SA现网实测,通过MIMO降低分组数量能够提升分组检测性能,结合上行低频段频谱叠加策略能够有效提升5G SA网络上行覆盖30%,提升5G SA网络上行平均速率40%~80%,特别是弱覆盖边缘的网络速率,最高可达600%。     

条形药包爆破震动场的试验研究

通过时条形药包周围实测爆破震动数据采用数值计算方法进行处理，作出了条形药包周围的爆破震动场，使我们对条形药包的爆破地震效应有了全面的认识，从而在实际工程爆破中能够有针对性地进行安全防护。分析研究认为：条形药包周围的震动场由一系列同心椭圆形等震线组成。在爆破近区由于位置因素的影响，等震线的长轴与药包轴线重合；在远区的震动主要受波动干涉作用的影响，致使长轴与药包轴线垂直，因此不能采用集中药包的计算方法。     

Analytical approach on magnetohydrodynamic Casson fluid flow past a stretching sheet via Adomian decomposition method

Flow phenomena of three-dimensional conducting Casson fluid through a stretching sheet are proposed in the present investigation with the impact of the magnetic parameter in a permeable medium. The adaptation of particular transformations is useful to modify the governing equations into their nondimensional as well as the ordinary form. However, these transformed equations are nonlinear and approximate analytical methods for the solution of the complex form of governing equations. In particular, the Adomian decomposition method is proposed for the solution. The behavior of several variables, such as the magnetic and porous matrix, on the flow profile as well as the rate of shear stress, are discussed via graphs and tables. The conformity of the current result with the earlier study shows a road map for further investigation. The major concluding remarks are; the retardation in the velocity distribution is rendered due to an increase in the Casson parameter moreover, the Casson parameter favors in reducing the rate of shear stress coefficient in magnitude.     

Coal char gasification for co-production of fuel gas and methane decomposition catalysts

Partial gasification of coal char was conducted with addition of metal oxides for co-production of fuel gas and methane decomposition catalysts. Effect of the metal composition (Ni, Co and Fe based mono- or bi-metals) was investigated on the fuel gas production and the resultant catalyst surface and textural properties, morphology and performance in catalytic methane decomposition (CMD). Besides H₂-rich fuel gas production (the combustion energy up to 11.03–23.42 MJ/kg_char) from the gasification, the gasification residue can directly serve as the effective and efficient catalyst for CMD. The Fe and Fe–Co composite oxides were found to be better among the mono- and bi-metallic oxides for the fuel gas production during the gasification, respectively. The Ni-based mono-/bi-metallic catalysts could display high and stable methane conversion (up to 80%) during the 600-min CMD test at 850 °C. Promotional role of the second metal in CMD was discussed on the carbon diffusion, metal mobility and reducibility, formation and growth of the deposited carbons. The formed carbon morphology after CMD was analyzed based on the Kirkendall effect and Tammann temperature and further correlated to the potential catalyst deactivation.     

某福利院一起肠炎沙门菌食源性疾病的调查分析

目的 对某福利院一起肠炎沙门菌食源性疾病进行调查和溯源,为研究相关食源性疾病提供参考。方法采用流行病学、食品卫生学和脉冲场凝胶电泳(PFGE)同源性分析等方法,分析本次食源性疾病事件。结果 确认本次事件中病例23名,患病率5.65%(23/407)；现场采集病例肛拭子15份和厨房工作人员肛拭子3份、留样菜品3份、水果2份以及冰棒1份,其中从11份病例肛拭子中检出肠炎沙门菌,PFGE结果显示11株肠炎沙门菌的DNA条带图谱相似性为96.4%,聚类分析为同一型,结合流行病学调查,初步判断菌株来自同一克隆系。结论 综合流行病学、食品卫生学和实验室检测结果,确定为一起肠炎沙门菌引起的食源性疾病,福利院应加强对特殊人群的饮食安全管理,制定相应的食源性疾病突发事件应急处理预案,防止此类事故再发生。     

Flash joining of alumina ceramics under a small current density

The ceramic joining using electric field (E-field) has garnered significant research attention due to the decreased joining barrier and enhanced reliability. However, the underlying mechanism of E-field assisted joining remains unclear. Herein, we report the rapid joining of alumina ceramics using a small current. Moreover, the E-field is applied in both perpendicular and parallel directions to the faying surfaces, demonstrating a significant difference in terms of joint strength. These results indicate that the E-field generates defects and promotes the joining process by facilitating ionic diffusion.     

Relationship of the different Ca sites in the matrix with luminescence properties of orange‒red emitting Li0.04Ca0.96-xSiO3:Smx phosphors

Li_0.04Ca_0.96-xSiO₃:Sm_x orange?red emitting phosphors were synthesized using the sol-gel method. X-ray diffraction, Rietveld refinement of XRD patterns, Fourier transform infrared spectroscopy and ?uorescence spectrophotometry were used to characterize the crystal structure, sites of cationic Ca and luminescence properties of the prepared phosphors. The relationship of the different Ca sites in the matrix with the luminescence properties was analysed. The results indicate that the prepared phosphors reveal a β-CaSiO₃ phase with a monoclinic crystal structure and space Group P21/a. As the Sm³⁺ concentration increases, the unit cell volume of phosphors and the Ca–O band lengths of different Ca sites decrease due to substitution of Ca²⁺ by smaller Sm³⁺ ions. By excitation at 404 nm, Li_0.04Ca_0.96-xSiO₃:Sm_x phosphors exhibit warm orange?red light, corresponding to the electron transitions from ⁴G_5/2 → ⁶H_5/2 (567 nm), ⁴G_5/2 → ⁶H_7/2 (605 nm) and ⁴G_5/2 → ⁶H_9/2 (651 nm) of Sm³⁺. The concentration quenching phenomenon appears at Sm³⁺ concentrations beyond 0.02. The refinement results demonstrate that three cationic Ca sites, named Ca1, Ca2 and Ca3, exist in the β-CaSiO₃ host lattice. The Ca²⁺ ions at Ca1 and Ca2 sites are coordinated with six oxygen ions, leading to the same coordination number (CN). The Ca²⁺ ion located at Ca3 site has seven coordination numbers. The Ca1 site possesses a smaller lattice distortion and better symmetry than those of Ca2 and Ca3 sites. However, the Ca3 site exhibits the largest lattice distortion and poor symmetry. The Sm³⁺ present in symmetric Ca1 sites in the matrix illustrates the strong emission intensity, long luminescence lifetimes and good thermal stability.     

Various density light field image coding based on distortion minimization interpolation

In recent years, the light field (LF) as a new imaging modality has attracted wide interest. The large data volume of LF images poses great challenge to LF image coding, and the LF images captured by different devices show significant differences in angular domain. In this paper we propose a view prediction framework to handle LF image coding with various sampling density. All LF images are represented as view arrays. We first partition the views into reference view (RV) set and intermediate view (IV) set. The RVs are rearranged into a pseudo sequence and directly compressed by a video encoder. Other views are then predicted by the RVs. To exploit the four dimensional signal structure, we propose the linear approximation prior (LAP) to reveal the correlation among LF views and efficiently remove the LF data redundancy. Based on the LAP, a distortion minimization interpolation (DMI) method is used to predict IVs. To robustly handle the LF images with different sampling density, we propose an Iteratively Updating depth image based rendering (IU-DIBR) method to extend our DMI. Some auxiliary views are generated to cover the target region and then the DMI calculates reconstruction coefficients for the IVs. Different view partition patterns are also explored. Extensive experiments on different types LF images also valid the efficiency of the proposed method.