Accelerating the decarbonization of carbonaceous gold ore by suspension oxidation roasting towards the improvement of gold leaching efficiency

Eliminating the gold preg-robbing effect of carbonaceous matter in carbonaceous gold ores is crucial for gold leaching. In this study, suspension oxidation roasting was proposed to accelerate the decarbonization of carbonaceous gold ore. The characteristics of oxidation reaction process and gas release were analyzed by TG-DTA-FTIR. The phase transformation and microstructure evolution of samples during roasting were analyzed by XRD, SEM and BET. The results show that the gold preg-robbing effect was eliminated after the gasification of carbonaceous matter, and the CaO generated by decomposition of carbonates can effectively capture the SO₂. After roasting for 75 min at 650 °C in a 20% O₂ atmosphere, the total carbon removal rate reached 99.42%, the distribution of exposed gold increased from 28.85% to 77.10% and the gold leaching efficiency increased from 4.55% to 84.83%. In addition, about 70% sulfur was mainly fixed in the roasted products in the form of sulfate. Therefore, the suspension oxidation roasting process is an efficient and clean pretreatment method for carbonaceous gold ores.     

离子型稀土矿山淋洗及尾水富集试验研究

对浸矿后离子型稀土原地浸矿场采用清水进行淋洗，在184天的清水淋洗过程中，尾水氨氮值从最开始的507mg/L，降低至140mg/L，淋洗尾水pH4.52~3.10。淋洗尾水采用两级反渗透膜分离，既回收有价资源稀土，又能使出水氨氮达标。结果表明，产水氨氮浓度稳定低于15mg/L，对稀土的截留率高于98.25%，浓水中稀土离子平均浓度313.4mg/L，可进一步回收稀土资源。     

填料类型与填充率对短程硝化的影响研究

研究不同填料类型与不同填充率对氨氮转化能力及亚氮积累效果影响。结果表明,在填充率相同的情况下,比表面积800 m²/m³的PE-03型号填料亚硝化效果最佳,氨氮转化50%,亚氮积累99%,PE-04型号填料比表面积1 200 m²/m³,相比于PE-03,氨氮转化降低5%、亚氮积累降低3%,PE-05型号填料比表面积510 m²/m³,相比于PE-03,氨氮转化30%、亚氮积累92%;随着填料填充率10%增加到30%,氨氮转化能力从20%增长至55%,之后再增加填充料,会小范围减小亚硝化能力,最低降至48%,由于该阶段亚硝化稳定运行,AOB优势生长,填充率的改变对亚氮积累率的影响不大。不同填料类型的影响研究中,PE-03型号的填料效果最佳;在填充率的考察中,随着同种填料填充率的增加,氨氮转化能力先增加后略微减小,对亚氮积累的情况影响较小;综合经济及技术因素,确定悬浮填料取材为PE-03型号,比表面积为800 m²/m³     

Evidence of fluid evolution of Baoshan Cu−Pb−Zn polymetallic deposit: Constraints from in-situ sulfur isotope and trace element compositions of pyrite

In-situ LA-ICP-MS and S isotopes of pyrite from the Baoshan Cu polymetallic deposit were conducted to investigate the ore-forming process and the enrichment mechanism of elements. Three generations of pyrite (Py I, Py II, and Py III) in the skarn-type ores and pyrite in the carbonate-hosted sulfide ores from central, western, and northern (C_Py, W_Py, and N_Py) mining districts are selected for comparison. Compared with Py I and Py III, the contents of most elements in Py II are apparently higher. The As and Se contents are high within a wide range and are decoupled in the growth band of the C_Py. The highest As, Se, and Pb contents were found in W_Py and N_Py. These results indicate the drastic changes in the temperature and fluid mixing during the mineralization. The occurrence of fluctuation and change in temperature and f(O₂) was triggered by intermittent pulses of magmatic-hydrothermal fluids, mixing with meteoric water, and water−rock interactions. The sulfur isotopes of all species of pyrite indicated the magmatic source. The change in the f(O₂) conditions caused slight differences in the sulfur isotope compositions. Consequently, a metallogenic model was proposed to explain the ore-forming processes.     

非径向管板焊接接头的超声检测

对AP1000压水堆核电站安全壳贯穿件的非径向管板焊接接头结构特点进行了介绍,并分析其超声检测工艺的重点和难点。通过建立统一的缺陷定位坐标系并结合被检构件的几何特点进行综合分析,推导得出了h值(缺陷回波最高点距套管外壁的距离)的计算方法。为超声检测对这类焊接接头缺陷的准确识别和定位提供了行之有效的方法,为解决这类焊接接头的超声检测技术受限区提供了行之有效的措施。     

四川某低品位金矿非氰浸出试验研究

对金品位为1.55 g/t的氧化矿采用非氰药剂进行浸金的工艺流程,考察了磨矿细度、药剂DZC浓度和浸出时间对金浸出率的影响。确定该金矿适宜的非氰浸出条件:磨矿细度-74μm含量占69.90%、石灰用量4 000g/t、矿浆液固比为2∶1、浸出药剂DZC浓度0.08%、浸出时间8 h,可获得金的浸出率为93.33%的良好指标。表明该氧化金矿在常温常压下,采用非氰浸出工艺是可行的。     

聚乙烯醇对芳纶复合纱聚苯胺导电层耐久性影响

为提高聚苯胺导电层与基材之间的黏结牢度,以聚乙烯醇为共混高聚物,通过连续原位聚合法在对位芳纶纱线表面形成聚乙烯醇/聚苯胺导电层,制备得到芳纶/聚苯胺/聚乙烯醇复合导电纱。分析了导电纱的结构与性能,并研究了聚乙烯醇对聚苯胺导电层耐水洗和耐磨性的影响。结果表明:适量添加聚乙烯醇有助于提高导电纱导电层的结构规整性及电导率,随着聚乙烯醇质量分数的提高,导电纱的电导率呈先上升后下降的趋势,当聚乙烯醇占苯胺的质量分数为4.30%时,制得的复合导电纱线的电导率最高,达到(1.120±0.198) S/cm;聚乙烯醇的添加和质量分数的提高,有助于聚苯胺导电层耐水洗性及在较小外力作用下的耐磨性的提高。     

适用于无线体域网的动态口令认证协议

无线体域网中传输的是与生命高度相关的敏感数据，身份认证是信息安全保护的第一道防线。现有的基于人体生物信息的身份认证方案存在信息难提取、偶然性大和误差性大的问题，基于传统密码学的认证方案需较大计算资源和能量消耗，并不适用于无线体域网环境。为此，在动态口令和非对称加密机制基础上，提出一种适用于无线体域网的动态口令双向认证轻量协议，并对其进行形式化分析。通过理论证明、SVO逻辑推理及SPIN模型检测得出：该协议满足双向认证，且能够抵御重放攻击、伪装攻击、拒绝服务器攻击和口令离线攻击，具有较高安全性。     

四川盆地龙女寺构造龙王庙组储层特征及地震响应

2005年威远构造威寒1井龙王庙组获11×10⁴ m³/d的测试产量揭示了四川盆地内部龙王庙组勘探的突破。随着勘探的深入，川中磨溪—高石梯地区多口百万立方米气井的获得证实了龙王庙组巨大的勘探潜力。然而，龙女寺构造龙王庙组储层发育情况展现出与磨溪—高石梯（高磨主体）地区较大的差异，以传统“亮点”反射模式作为储层预测的指导思想已经无法满足现今勘探的需要。以龙女寺构造龙王庙组储层为例，借助已有岩心、薄片、测录井及地震资料，对区内龙王庙组储层与高磨主体地区龙王庙组储层进行对比研究，同时对储层的地震响应进行进一步的探索。研究表明：研究区龙王庙组发育局限台地沉积，颗粒滩相作为储层发育的最有利相带，最主要的储集岩类为颗粒云岩及晶粒云岩，储集空间包括粒间（溶）孔、晶间（溶）孔、溶洞等；研究区内储层表现出低孔低渗的特征，非均质性强，纵向展布差异大，横向可对比性差。对比分析“亮点”反射模式，采用波形聚类属性对储层进行平面分布预测，明确不同储层发育情况对应的波形特征。I类波形对应于储层发育于顶部，储层厚度>30 m；II类波形对应于储层发育于中部，储层厚度>20 m，或顶部中部发育2套相距20 m左右、厚度15 m左右的储层；I、II类波形为储层发育有利波形；III类波形对应储层较薄（<5 m）且储层呈薄互层状发育或储层欠发育；IV类波形对应储层欠发育；III、IV类波形为储层发育不利波形。该方法可有效地规避“假亮点”反射，预测结果与沉积相发育特征及实钻井储层发育情况吻合率高。     

山东栖霞—大柳行地区金矿找矿靶区地质评价及优选

栖霞—大柳行地区位于胶东中部栖霞—蓬莱金矿成矿带内，是胶东重要的金成矿区，成矿条件优越。为了对圈定靶区进行优选分类，通过对该区地质背景、找矿靶区评价、找矿靶区优选方面展开综合研究，并结合勘查工作程度和矿业权设置情况，划分出3类预测区，选定了5个靶区为今后优先部署勘查工作的方向。