Effects of Cooling Rate and Component on the Microstructure and Mechanical Properties of Mg–Zn–Y Alloys

The microstructure and mechanical properties of Mg–6Zn–1Y and Mg–6Zn–3Y(wt%) alloys under different cooling rates were investigated. The results show that the second dendrite arm spacing(SDAS) of Mg–6Zn–1Y and Mg–6Zn–3Y is reduced by 32 and 30% with increasing cooling rates(Rc) from 10.2 to 23 K/s, which can be predicted using a empirical model of SDAS=68 R 0:45:45cand SDAS=73 R 0c, respectively. The compressive strength of both alloys increases with increasing the cooling rate, which is attributed to the increase of volume fraction(Vf) of secondary phases under high cooling rate. The interaction of the cooling rate and component with SDAS has been theoretically analyzed using interdependence theory.     

Prolonged tamoxifen exposure selects a breast cancer cell clone that is stable in vitro and in vivo

The effects of long-term tamoxifen exposure on cell growth and cell cycle kinetics were compared between oestrogen receptor (ER)-positive (MCF-7) and ER-negative (MDA-MB-231) cell lines. In the MCF-7 cell line, prolonged tamoxifen exposure (0.5 mumol/l for > 100 days) blocked cells in G0-G1 of the cell cycle, and slowed the doubling time of cells from 30 to 59 h. These effects corresponded to an increase in the cellular accumulation of tamoxifen over time [mean area under concentration curve (AUC) = 77.92 mumoles/10(6)/cells/day]. In contrast, in the MDA-MB-231 cell line, long-term tamoxifen exposure had no obvious effect on the doubling time, and reduced cellular tamoxifen accumulation (mean AUC = 50.50 mumoles/10(6)/cells/day) compared to the MCF-7 cells. Flow cytometric analysis of MDA-MB-231 cells demonstrated that a new tetraploid clone emerged following 56 days of tamoxifen exposure. Inoculation of the MDA-MB-231 tetraploid clone and MDA-MB-231 wildtype cells into the opposite flanks of athymic nude mice resulted in the rapid growth of tetraploid tumours. The tetraploid tumours maintained their ploidy following tamoxifen treatment for nine consecutive serial transplantations. Histological examination of the fifth transplant generation xenografts revealed that the tetraploid tumour had a 25-30 times greater mass, area of haemorrhage and necrosis, a slightly higher mitotic index and was more anaplastic than the control neoplasm. The control wildtype MDA-MB-231 tumours maintained a stable ploidy following tamoxifen treatment until the eighth and ninth transplantation, when a tetraploid population appeared, suggesting that tamoxifen treatment may select for this clone in vivo. These studies suggest that prolonged tamoxifen exposure may select for new, stable, fast growing cell clones in vitro as well as in vivo.     

模糊数学识别火山岩岩性

针对火岩地层岩性识别成功率低的状况，应用模糊数学原理，建立模糊数学识别火山岩岩性模式，识别和划分火山岩地层岩性，以便进一步深入研究火山岩油气藏储层，选择8个反映火山岩岩性测井参数，确定阈值；利用所建立的火山岩岩性识别模式，对火山岩岩性进行分类；依据最大隶属原则，识别火山岩岩性，应用实地研究资料，识别10种火山岩岩性，并与岩心鉴定统计分析结果对比，一致性达85％。表明该方法识别火山岩岩性精度较高，在地质上具有很好的应用前景。     

Photoluminescence and X-ray Diffraction of Distributed Bragg Reflector

Spectral and structural characteristics of distributed Bragg reflector (DBR) in vertical-cavity surface-emitting lasers were studied with photoluminescence and double- crystal X- ray diffraction measurement. The expected high quality epitaxial DBR structure was verified. In the X- ray double- crystal rocking curves of DBR the zeroth- order peak, the first and second order satellite peaks were measured. Splitting of diffraction peak appeared in the rocking curves was analyzed. The effects of introduced deep energy levels on the structural perfection and optical properties were discussed.     

引水发电系统无压隧洞中弃水堰位置的数值模拟研究

水电站引水发电系统无压隧洞中的水力过渡过程是近年来电站设计中出现的一个新课题,特别是流域梯级电站开发中经常遇到。结合工程实例应用扩散法,给出了无压隧洞水力过渡过程数值模拟的基本方程以及上下游及弃水堰等边界附加方程,模拟了弃水堰布置在不同位置下,无压隧洞内的水位变化过程。研究成果和讨论对实际工程应用具有参考意义。     

Accuracy of using computed tomography to identify pedicle screw placement in cadaveric human lumbar spine

STUDY DESIGN: Utility of using computed tomography to predict pedicle screw misplacement. OBJECTIVE: This study defines the sensitivity and specificity of predicting pedicle screw placement by experienced clinicians using a CT scan image. SUMMARY OF BACKGROUND DATA: In clinical and research settings, the method most commonly used to evaluate pedicle screws placement has been computed tomography. However, no current literature describes the accuracy of this method of evaluating screw placement. METHOD: Cobalt-chrome and titanium alloy pedicle screws of identical size were placed in six cadaveric human lumbar spine. Wide laminectomy was performed to allow complete visualization of the pedicles. Three consecutive lumbar levels were instrumented in each spine, giving 36 pedicle screw placements to identify. The instrumented spines were imaged, and four orthopaedic spine surgeons and a musculoskeletal radiologist were asked to read the images to identify the accuracy of screw placement within the pedicles. RESULTS: The sensitivity rate of identifying a misplaced screw was 67 +/- 6% for cobalt-chrome screws compared with 86 +/- 5% for titanium screws (P < 0.005). The specificity rates of radiographic diagnosis of misplaced pedicle screws were 66 +/- 10% for cobalt-chrome screws and 88 +/- 8% for titanium screws (P < 0.005). Similarly, a statistically significant difference was found in the sensitivity rates of identifying screws placed correctly in the pedicle: 70 +/- 10% for cobalt-chrome screws versus 89 +/- 8% for titanium screws (P < 0.005). Overall accuracy rates were 68 +/- 7% for cobalt chrome screws versus 87 +/- 3% for titanium screws (P < 0.002). CONCLUSION: Reliance on the computed tomography scan data alone in determining accuracy of pedicle screws can lead to inaccuracies in both clinical and research conditions.     

时空效应规律在软土深基坑工程中的运用

阐述了时空效应规律在软土深基坑工程中的运用情况，实践证明，运用时空效应规律，能可靠而合理地利用土体自身在基坑开挖过程中控制土体位移的潜力而达到保护环境的目的。     

高频微型脉冲管制冷机的实用化研究

脉冲管制冷机经过多年的发展，性能不断改善，目前已开始进入实用化阶段。高频微型脉冲管制冷机结构紧凑，应用方便，并且主要工作在需求量较大的液氮温区，因此将首先得到一定规模的应用。介绍了作者针对脉冲管制冷机在红外和超导方面的应用所作的实用化工作，讨论了尚待解决的问题。